arXiv subjects

Nuria González-Prelcic

Publications and source records attributed to Nuria González-Prelcic.

42 records · Page 3Linked to original sources

arXiv2017

Joint Data-Aided Carrier Frequency Offset, Phase Offset, Amplitude and SNR Estimation for Millimeter-Wave MIMO Systems

This work is devoted to solve the problem of estimating the carrier frequency offset, phase offset, amplitude, and SNR between two mmWave transceivers. The Cramér-Rao Lower Bound (CRLB) for the different parameters is provided first, as well as the condition for the CRLB to exist, known as Regularity Condition. Thereafter, the problem of finding suitable estimators for the parameters is adressed, for which the proposed solution is the Maximum Likelihood estimator (ML).

cs.IT↗

arXiv2017

Millimeter Wave communication with out-of-band information

Configuring the antenna arrays is the main source of overhead in millimeter wave (mmWave) communication systems. In high mobility scenarios, the problem is exacerbated, as achieving the highest rates requires frequent link reconfiguration. One solution is to exploit spatial congruence between signals at different frequency bands and extract mmWave channel parameters from side information obtained in another band. In this paper we propose the concept of out-of-band information aided mmWave communication. We analyze different strategies to leverage information derived from sensors or from other communication systems operating at sub-6 GHz bands to help configure the mmWave communication link. The overhead reductions that can be obtained when exploiting out-of-band information are characterized in a preliminary study. Finally, the challenges associated with using out-of-band signals as a source of side information at mmWave are analyzed in detail.

cs.IT↗

arXiv2017

Frequency-domain Compressive Channel Estimation for Frequency-Selective Hybrid mmWave MIMO Systems

Channel estimation is useful in millimeter wave (mmWave) MIMO communication systems. Channel state information allows optimized designs of precoders and combiners under different metrics such as mutual information or signal-to-interference-noise (SINR) ratio. At mmWave, MIMO precoders and combiners are usually hybrid, since this architecture provides a means to trade-off power consumption and achievable rate. Channel estimation is challenging when using these architectures, however, since there is no direct access to the outputs of the different antenna elements in the array. The MIMO channel can only be observed through the analog combining network, which acts as a compression stage of the received signal. Most of prior work on channel estimation for hybrid architectures assumes a frequency-flat mmWave channel model. In this paper, we consider a frequency-selective mmWave channel and propose compressed-sensing-based strategies to estimate the channel in the frequency domain. We evaluate different algorithms and compute their complexity to expose trade-offs in complexity-overhead-performance as compared to those of previous approaches.

cs.IT↗

arXiv2017

Millimeter Wave Beam-Selection Using Out-of-Band Spatial Information

Millimeter wave (mmWave) communication is one feasible solution for high data-rate applications like vehicular-to-everything communication and next generation cellular communication. Configuring mmWave links, which can be done through channel estimation or beam-selection, however, is a source of significant overhead. In this paper, we propose to use spatial information extracted at sub-6 GHz to help establish the mmWave link. First, we review the prior work on frequency dependent channel behavior and outline a simulation strategy to generate multi-band frequency dependent channels. Second, assuming: (i) narrowband channels and a fully digital architecture at sub-6 GHz; and (ii) wideband frequency selective channels, OFDM signaling, and an analog architecture at mmWave, we outline strategies to incorporate sub-6 GHz spatial information in mmWave compressed beam selection. We formulate compressed beam-selection as a weighted sparse signal recovery problem, and obtain the weighting information from sub-6 GHz channels. In addition, we outline a structured precoder/combiner design to tailor the training to out-of-band information. We also extend the proposed out-of-band aided compressed beam-selection approach to leverage information from all active OFDM subcarriers. The simulation results for achievable rate show that out-of-band aided beam-selection can reduce the training overhead of in-band only beam-selection by 4x.

cs.IT↗

arXiv2016

Optimized Compressed Sensing via Incoherent Frames Designed by Convex Optimization

The construction of highly incoherent frames, sequences of vectors placed on the unit hyper sphere of a finite dimensional Hilbert space with low correlation between them, has proven very difficult. Algorithms proposed in the past have focused in minimizing the absolute value off-diagonal entries of the Gram matrix of these structures. Recently, a method based on convex optimization that operates directly on the vectors of the frame has been shown to produce promising results. This paper gives a detailed analysis of the optimization problem at the heart of this approach and, based on these insights, proposes a new method that substantially outperforms the initial approach and all current methods in the literature for all types of frames, with low and high redundancy. We give extensive experimental results that show the effectiveness of the proposed method and its application to optimized compressed sensing.

cs.IT↗

arXiv2015

Hybrid MIMO Architectures for Millimeter Wave Communications: Phase Shifters or Switches?

Hybrid analog/digital MIMO architectures were recently proposed as an alternative for fully-digitalprecoding in millimeter wave (mmWave) wireless communication systems. This is motivated by the possible reduction in the number of RF chains and analog-to-digital converters. In these architectures, the analog processing network is usually based on variable phase shifters. In this paper, we propose hybrid architectures based on switching networks to reduce the complexity and the power consumption of the structures based on phase shifters. We define a power consumption model and use it to evaluate the energy efficiency of both structures. To estimate the complete MIMO channel, we propose an open loop compressive channel estimation technique which is independent of the hardware used in the analog processing stage. We analyze the performance of the new estimation algorithm for hybrid architectures based on phase shifters and switches. Using the estimated, we develop two algorithms for the design of the hybrid combiner based on switches and analyze the achieved spectral efficiency. Finally, we study the trade-offs between power consumption, hardware complexity, and spectral efficiency for hybrid architectures based on phase shifting networks and switching networks. Numerical results show that architectures based on switches obtain equal or better channel estimation performance to that obtained using phase shifters, while reducing hardware complexity and power consumption. For equal power consumption, all the hybrid architectures provide similar spectral efficiencies.

cs.IT↗