Searcharxiv⌕ Search

arXiv subjects

Pavel Peterka

Publications and source records attributed to Pavel Peterka.

11 recordsLinked to original sources

Thulium- and Holmium-Doped Silica Fibres for 2 μm High-Power and Highly-Efficient Lasers

Silica optical fibres, originally developed as a low-loss transmission medium for telecommunications, have evolved into a versatile platform for compact and efficient high-power lasers. This review discusses recent progress in thulium- and holmium-doped active fibres emitting within the 2 μm spectral band, with an emphasis on material and waveguide approaches that address power scaling through thermal-load mitigation and enhanced laser efficiency. In particular, the temperature dependence of absorption and emission cross-sections are reviewed, and their implications for spectral gain, amplified spontaneous emission and high-power laser operation are discussed. Structured-core thulium fibres are then considered as a route to combining the high local Tm3+ concentration required for efficient two for- one cross-relaxation with a reduced average dopant concentration, lower longitudinal heat load, and a pedestal-free waveguide design. Finally, recent results on holmium-doped silica fibres prepared by nanoparticle-assisted modified chemical vapour deposition are summarised. Crucially, the Al/Ho ratio is identified as a key compositional parameter governing laser efficiency, while a high absolute alumina content supports a long fluorescence lifetime and enables high Ho3+ concentrations without excessive clustering. These advances have enabled core-pumped holmium fibre lasers with slope efficiencies reaching 84% and output powers approaching 100W. Collectively, these development illustrate how control of spectroscopy, composition, and transverse dopant distribution can extend the performance of silica fibre lasers across the 1.7-2.2 μm spectral region.

physics.optics↗

Judd-Ofelt analysis of holmium-doped alumino-silicate optical glass prepared by MCVD combined with nanoparticle doping

We present a detailed Judd--Ofelt (JO) analysis of Ho$^{3+}$-doped alumino-silicate optical fiber preforms in a wide range of compositions and prepared by both the standard solution doping method as well as the more advanced nanoparticle doping. The absorption spectra were measured, the absorption cross sections were calculated for each observed transition, and the Judd--Ofelt analysis was conducted. The preforms exhibited the values of JO parameters of $Ω_2 = (7.2--10.6) \times 10^{-20}\,\mathrm{cm}^2$, depending on the Al$_2$O$_3$ content, and $Ω_4$ and $Ω_6$ around $2.5$ and $1.2 \times 10^{-20}\,\mathrm{cm}^2$, respectively. The radiative transition parameters, such as transition probabilities, branching ratios, and radiative lifetimes, were calculated. The radiative lifetime of the ${}^5I_7 \rightarrow {}^5I_8$ transition, in the $16.1--17.2\,\mathrm{ms}$ range, combined with a measured value in the $0.9--1.9\,\mathrm{ms}$ range, was used to calculate the quantum efficiency, which was in the $5--11\,\%$ range. The preforms prepared by nanoparticle doping containing high Al$_2$O$_3$ contents above $8\,\mathrm{mol.}\,\%$ exhibited superior values of measured lifetime (above $1.5\,\mathrm{ms}$) and quantum efficiency (above $8\,\%$) compared to the standard solution-doped samples. To the best of our knowledge, this work is the first comprehensive report on the JO analysis of Ho$^{3+}$-doped alumino-silicate glass. The calculated parameters may be used in various calculations, simulations, and modelling of holmium-doped fiber lasers and other devices.

physics.optics↗

Structured Ytterbium and Erbium -doped Silica Fiber for Dual Wavelength Laser Operation

We report on a novel type of dual-wavelength fiber laser with a structured-core design inside silica glass, forming a spatial separation of the several core areas doped with ytterbium and erbium ions. We have optimised the key parameters of the fiber core, such as the concentration of rare earth elements, and the optimal length of active fiber to operate simultaneously at two different wavelengths. Using the Modified Chemical Vapor Deposition method to obtain initial optical fiber preforms, and using the stack and draw technique, we have fabricated two types of active fibers, one with 7 and one with 19 rare-earth-doped rods (elements) forming the fiber core. We characterized the drawn fibers by investigating their structure by scanning electron microscopy, confirming the spatial separation of the elements within the core. Measuring absorption shows that concentration ratios Nt Yb: Nt Er were approximately 52: 48 for 7 core fibers and 56:44 for 19 core fibers. Lifetimes for both active fibers were 0.84 ms for Yb3+ ion and 10.30 ms for Er3+ ion. The performance of fiber lasers was determined, proving that fibers are capable of laser emission simultaneously at 1042 nm and 1550 nm. We have shown experimentally that the output power ratio between both lasing wavelengths can be controlled by the length of the fiber.

physics.optics↗

7-Rod-Core Thulium-Doped Fiber for Enhanced Fiber Laser Cooling

Structured-core thulium-doped fibers were developed to reduce heat load, enable shorter-wavelength operation, and achieve a pedestal-free design. In a proof-of-principle experiment, laser slope efficiencies of 52% at 1907 nm and 54% at 1940 nm were achieved with respect to absorbed power.

physics.optics↗

High harmonic generation in monolayer MoS2 controlled by resonant and near-resonant pulses on ultrashort time scales

We report on experimental investigation of nonperturbative high harmonic generation (HHG) in monolayer MoS2 in the ultraviolet spectral region driven by mid-infrared light. We study how the HHG is influenced by pre-excitation of the monolayer using resonant and near-resonant pulses in a pump-probe-like scheme. The resonant light creates high density exciton population. Due to ultrafast dephasing caused by electron-electron scattering, the HHG is suppressed in the presence of pre-excited carriers. In the case of near-resonant excitation with photon energy below the exciton transition, the dynamics of the observed suppression of the HHG yield contains a fast component which is a consequence of momentum scattering at carriers, which are excited by two-photon transition when the two pulses temporally overlap in the sample. This interpretation is supported by comparison of the experimental data with theoretical calculations of two-photon absorption spectrum of MoS2 monolayer. This work demonstrates a possibility to control HHG in lowdimensional materials on ultrashort timescales by combining the driving strong-field pulse with a weak near-resonant light.

physics.optics↗

Noncollinear phase-matching of high harmonic generation in solids

We propose and experimentally demonstrate a scheme allowing to reach noncollinear phase-matching of high harmonic generation in solids, which may potentially lead to an enhancement of the generation efficiency. The principle is based on high-order frequency mixing of two light waves with identical frequencies but different directions of wavevectors. In this process, $N$-th harmonic frequency is produced by frequency mixing of $N$+1 photons from a wave with high amplitude of electric field and a single photon from a wave with low field amplitude, which are propagating noncollinearly in an optically isotropic media. We experimentally verify the feasibility of this scheme by demonstrating phase-matched generation of third and fifth harmonic frequency in sapphire.

physics.optics↗

Understanding the temperature conditions for controlled splicing between silica and fluoride fibers

This study explores the efficacy of thermal splicing conditions between silica and zirconium-fluoride fibers, focusing on achieving mechanical strength between the two fibers. A comprehensive characterization of the thermal profile in the hot zone of the filament splicer was conducted using a fiber Bragg grating, providing valuable insights into its stability and overall performance. Results demonstrate mechanically strong joints and suggest a very narrow temperature window to achieve strong connection between the two materials. Moreover, we characterize the surface composition of the ZrF4 fiber using energy dispersive spectroscopy following splicing at ideal temperatures, as well as at higher and lower temperatures. This work paves the way towards future implementation of silica and fluoride fibers splicing using alternative splicing solutions such as CO2 laser system while raising interesting facts for further studies in the specific field.

physics.optics↗

Passively Q-switched Ytterbium and Chromium all-fibre laser

A chromium-doped saturable absorber fibre stabilizes an otherwise spontaneously chaotic ytterbium- doped fibre laser. This original passively Q-switched all-fibre laser produces sustained and stable trains of smooth pulses at high repetition rate.

physics.optics↗

Thulium-doped silica fibers with enhanced 3H4 level lifetime: modelling the devices for 800-820 nm band

Silica-based thulium-doped fiber devices operating around 810 nm would extend the spectral range covered by high- power fiber devices. Using a comprehensive numerical model of the fiber we have shown that efficient lasing at 810 nm can be achieved for specific ranges of the laser cavity parameters in silica-based thulium-doped fibers with enhanced 3H4 lifetime up to 58 \mus as measured in our highly alumina-codoped fibers. We present optimization of the thulium-doped fiber and laser cavity parameters and also potential applications of the developed host material in amplifiers and broadband sources.

physics.optics↗

Preparation and characterization of highly thulium- and alumina-doped optical fibers for single-frequency fiber lasers

Thulium-doped fibers suitable for core-pumped single-frequency lasers were fabricated by the modified chemical vapor deposition (MCVD) method. Refractive index profile, doping profile and spectral absorption was measured. High doping concentration of thulium ions should be achieved to allow for high absorption of light at a pump wavelength while the thulium ions clustering should be avoided to prevent the cooperative upconversion and quenching processes. The fabricated fibers featured pump absorption up to 70dB/m at a pump wavelength of 1611nm. The single-frequency master oscillator with a resonator composed of a pair of fiber Bragg gratings and a thulium-doped fiber was demonstrated with predominantly single ended operation. We achieved a slope efficiency of 22% and a threshold of 22mW at a lasing wavelength of 1944nm.

physics.optics↗

Visible and near infra-red up-conversion in Tm3+/Yb3+ co-doped silica fibres under 980 nm excitation

The spectroscopic properties of Tm3+/Yb3+ co-doped silica fibers under excitation at 980 nm are reported. Three distinct up-conversion fluorescence bands were observed in the visible to near infra-red regions. The blue and red fluorescence bands at 475 and 650 nm, respectively, were found to originate from the 1G4 level of Tm3+. A three step up-conversion process was established as the populating mechanism for these fluorescence bands. The fluorescence band at 800 nm was found to originate from two possible transitions in Tm3+; one being the transition from the 3H4 to 3H6 manifold which was found to dominate at low pump powers; the other being the transition from the 1G4 to 3H6 level which dominates at higher pump powers. The fluorescence lifetime of the 3H4 and 3F4 levels of Tm3+ and 2F5/2 level of Yb3+ were studied as a function of Yb3+ concentration, with no significant energy back transfer from Tm3+ to Yb3+ observed.

physics.optics↗