arXiv subjects

Rudolf Gross

Publications and source records attributed to Rudolf Gross.

At least 109 records · Page 6Linked to original sources

arXiv2015

An all-electrical torque differential magnetometer operating under ambient conditions

An all-electrical torque differential magnetometry (also known as cantilever magnetometry) setup employing piezoelectric quartz tuning forks is demonstrated. The magnetometer can be operated under ambient conditions as well as low temperatures and pressures. It extends the allowed specimen mass range up to several 10 $μ$g without any significant reduction in the sensitivity. Operation under ambient conditions and a simple all-electrical design of the magnetometer should allow for an easy integration with other experimental setups. The uniaxial magnetic anisotropy of a 25 $μ$m diameter iron wire, measured under ambient conditions with a high signal to noise ratio, was found to be in good agreement with its literature value. Further applications of the technique are discussed.

cond-mat.mtrl-sci↗

arXiv2015

A universal platform for magnetostriction measurements in thin films

We present a universal nanomechanical sensing platform for the investigation of magnetostriction in thin films. It is based on a doubly-clamped silicon nitride nanobeam resonator covered with a thin magnetostrictive film. Changing the magnetization direction within the film plane by an applied magnetic field generates a magnetostrictive stress and thus changes the resonance frequency of the nanobeam. A measurement of the resulting resonance frequency shift, e.g. by optical interferometry, allows to quantitatively determine the magnetostriction constants of the thin film. We use this method to determine the magnetostriction constants of a 10nm thick polycrystalline cobalt film, showing very good agreement with literature values. The presented technique can be useful in particular for the precise measurement of magnetostriction in a variety of (conducting and insulating) thin films, which can be deposited by e.g. electron beam deposition, thermal evaporation or sputtering.

cond-mat.mes-hall↗

arXiv2015

Non-local magnetoresistance in YIG/Pt nanostructures

We study the local and non-local magnetoresistance of thin Pt strips deposited onto yttrium iron garnet. The local magnetoresistive response, inferred from the voltage drop measured along one given Pt strip upon current-biasing it, shows the characteristic magnetization orientation dependence of the spin Hall magnetoresistance. We simultaneously also record the non-local voltage appearing along a second, electrically isolated, Pt strip, separated from the current carrying one by a gap of a few 100 nm. The corresponding non-local magnetoresistance exhibits the symmetry expected for a magnon spin accumulation-driven process, confirming the results recently put forward by Cornelissen et al. [1]. Our magnetotransport data, taken at a series of different temperatures as a function of magnetic field orientation, rotating the externally applied field in three mutually orthogonal planes, show that the mechanisms behind the spin Hall and the non-local magnetoresistance are qualitatively different. In particular, the non-local magnetoresistance vanishes at liquid Helium temperatures, while the spin Hall magnetoresistance prevails.

cond-mat.mtrl-sci↗

arXiv2015

Antiferromagentic resonance detected by DC voltages in MnF$_2$/Pt bilayers

We performed coplanar waveguide-based broadband ferromagnetic resonance experiments on the antiferromagnetic insulator MnF$_2$, while simultaneously recording the DC voltage arising in a thin platinum film deposited onto the MnF$_2$. The antiferromagnetic resonance is clearly reflected in both the transmission through the waveguide as well as the DC voltage in the Pt strip. The DC voltage remains largely unaffected by field reversal and thus presumably stems from microwave rectification and/or heating effects. However, we identify a small magnetic field orientation dependent contribution, compatible with antiferromagnetic spin pumping theory.

cond-mat.mtrl-sci↗

arXiv2015

Spin-boson model with an engineered reservoir in circuit quantum electrodynamics

A superconducting qubit coupled to an open transmission line represents an implementation of the spin-boson model with a broadband environment. We show that this environment can be engineered by introducing partial reflectors into the transmission line, allowing to shape the spectral function, J(ω), of the spin-boson model. The spectral function can be accessed by measuring the resonance fluorescence of the qubit, which provides information on both the engineered environment and the coupling between qubit and transmission line. The spectral function of a transmission line without partial reflectors is found to be Ohmic over a wide frequency range, whereas a peaked spectral density is found for the shaped environment. Our work lays the ground for future quantum simulations of other, more involved, impurity models with superconducting circuits.

cond-mat.mes-hall↗

arXiv2015

Anomalous Hall effect in YIG$|$Pt bilayers

We measure the ordinary and the anomalous Hall effect in a set of yttrium iron garnet$|$platinum (YIG$|$Pt) bilayers via magnetization orientation dependent magnetoresistance experiments. Our data show that the presence of the ferrimagnetic insulator YIG leads to an anomalous Hall like signature in Pt, sensitive to both Pt thickness and temperature. Interpretation of the experimental findings in terms of the spin Hall anomalous Hall effect indicates that the imaginary part of the spin mixing interface conductance $G_{\mathrm{i}}$ plays a crucial role in YIG$|$Pt bilayers. In particular, our data suggest a sign change in $G_{\mathrm{i}}$ between $10\,\mathrm{K}$ and $300\,\mathrm{K}$. Additionally, we report a higher order Hall effect, which appears in thin Pt films on YIG at low temperatures.

cond-mat.mtrl-sci↗

arXiv2015

Quantum State Engineering with Circuit Electromechanical Three-Body Interactions

We propose a hybrid system with quantum mechanical three-body interactions between photons, phonons, and qubit excitations. These interactions take place in a circuit quantum electrodynamical architecture with a superconducting microwave resonator coupled to a transmon qubit whose shunt capacitance is free to mechanically oscillate. We show that this system design features a three-mode polariton--mechanical mode and a nonlinear transmon--mechanical mode interaction in the strong coupling regime. Together with the strong resonator--transmon interaction, these properties provide intriguing opportunities for manipulations of this hybrid quantum system. We show, in particular, the feasibility of cooling the mechanical motion down to its ground state and preparing various nonclassical states including mechanical Fock and cat states and hybrid tripartite entangled states.

quant-ph↗

arXiv2015

Towards on-chip generation, routing and detection of non-classical light

We fabricate an integrated photonic circuit with emitter, waveguide and detector on one chip, based on a hybrid superconductor-semiconductor system. We detect photoluminescence from self-assembled InGaAs quantum dots on-chip using NbN superconducting nanowire single photon detectors. Using the fast temporal response of these detectors we perform time-resolved studies of non-resonantly excited quantum dots. By introducing a temporal filtering to the signal, we are able to resonantly excite the quantum dot and detect its resonance uorescence on-chip with the integrated superconducting single photon detector.

cond-mat.mes-hall↗

arXiv2015

Sign of inverse spin Hall voltages generated by ferromagnetic resonance and temperature gradients in yttrium iron garnet|platinum bilayers

We carried out a concerted effort to determine the absolute sign of the inverse spin Hall effect voltage generated by spin currents injected into a normal metal. We focus on yttrium iron garnet (YIG)|platinum bilayers at room temperature, generating spin currents by microwaves and temperature gradients. We find consistent results for different samples and measurement setups that agree with theory. We suggest a right-hand-rule to define a positive spin Hall angle corresponding to with the voltage expected for the simple case of scattering of free electrons from repulsive Coulomb charges.

cond-mat.mtrl-sci↗

arXiv2014

Current-induced spin torque resonance of a magnetic insulator

Pure spin currents transport angular momentum without an associated charge flow. This unique property makes them attractive for spintronics applications, such as torque induced magnetization control in nanodevices that can be used for sensing, data storage, interconnects and logics. Up to now, however, most spin transfer torque studies focused on metallic ferromagnets, while magnetic insulators were largely ignored, in spite of superior magnetic quality factors. Here, we report the observation of spin torque-induced magnetization dynamics in a magnetic insulator. Our experiments show that in ultrathin magnetic insulators the spin torque induced magnetization dynamics can be substantially larger than those generated by the Oersted field. This opens new perspectives for the efficient integration of ferro-, ferri-, and antiferromagnetic insulators into electronic devices.

cond-mat.mes-hall↗

arXiv2014

Spin Hall noise

We measure the low-frequency thermal fluctuations of pure spin current in a Platinum film deposited on yttrium iron garnet via the inverse spin Hall effect (ISHE)-mediated voltage noise as a function of the angle $α$ between the magnetization and the transport direction. The results are consistent with the fluctuation dissipation theorem in terms of the recently discovered spin Hall magnetoresistance (SMR). We present a microscopic description of the $α$ dependence of the voltage noise in terms of spin current fluctuations and ISHE.

cond-mat.mes-hall↗

arXiv2014

Time resolved spin Seebeck effect experiments

In this Letter, we present the results of transient thermopower experiments, performed at room temperature on yttrium iron garnet/platinum bilayers. Upon application of a time-varying thermal gradient, we observe a characteristic low-pass frequency response of the ensuing thermopower voltage with cutoff frequencies of up to 37 MHz. We interpret our results in terms of the spin Seebeck effect, and argue that small wavevector magnons are of minor importance for the spin Seebeck effect in our thin film hybrid structures.

cond-mat.mes-hall↗

arXiv2014

On-chip generation, routing and detection of quantum light

Semiconductor based photonic information technologies are rapidly being pushed to the quantum limit where non-classical states of light can be generated, manipulated and exploited in prototypical quantum optical circuits. Here, we report the on-chip generation of quantum light from individual, resonantly excited self-assembled InGaAs quantum dots, efficient routing over length scales $\geq 1$ mm via GaAs ridge waveguides and in-situ detection using evanescently coupled integrated NbN superconducting single photon detectors fabricated on the same chip. By temporally filtering the time-resolved luminescence signal stemming from single, resonantly excited quantum dots we use the prototypical quantum optical circuit to perform time-resolved excitation spectroscopy on single dots and demonstrate resonant fluorescence with a line-width of $10 \pm 1 \ μ$eV; key elements needed for the use of single photons in prototypical quantum photonic circuits.

cond-mat.mes-hall↗

arXiv2014

Circuit Electromechanics with a Non-Metallized Nanobeam

We have realized a nano-electromechanical hybrid system consisting of a silicon nitride beam dielectrically coupled to a superconducting microwave resonator. We characterize the sample by making use of the Duffing nonlinearity of the strongly driven beam. In particular, we calibrate the amplitude spectrum of the mechanical motion and determine the electromechanical vacuum coupling. A high quality factor of 480,000 at a resonance frequency of 14 MHz is achieved at 0.5 K. The experimentally determined electromechanical vacuum coupling of 11.5 mHz is quantitatively compared with finite element based model calculations.

cond-mat.mes-hall↗

arXiv2014

Determination of effective mechanical properties of a double-layer beam by means of a nano-electromechanical transducer

We investigate the mechanical properties of a doubly-clamped, double-layer nanobeam embedded into an electromechanical system. The nanobeam consists of a highly pre-stressed silicon nitride and a superconducting niobium layer. By measuring the mechanical displacement spectral density both in the linear and the nonlinear Duffing regime, we determine the pre-stress and the effective Young's modulus of the nanobeam. An analytical double-layer model quantitatively corroborates the measured values. This suggests that this model can be used to design mechanical multilayer systems for electro- and optomechanical devices, including materials controllable by external parameters such as piezoelectric, magnetrostrictive, or in more general multiferroic materials.

cond-mat.mes-hall↗

arXiv2014

Temperature dependent spin transport properties of Platinum inferred from spin Hall magnetoresistance measurements

We study the temperature dependence of the spin Hall magnetoresistance (SMR) in yttrium iron garnet/platinum hybrid structures via magnetization orientation dependent magnetoresistance measurements. Our experiments show a decrease of the SMR magnitude with decreasing temperature. Using the sensitivity of the SMR to the spin transport properties of the normal metal, we interpret our data in terms of a decrease of the spin Hall angle in platinum from 0.11 at room temperature to 0.075 at 10K, while the spin diffusion length and the spin mixing conductance of the ferrimagnetic insulator/normal metal interface remain almost constant.

cond-mat.mes-hall↗

arXiv2014

Origin of the spin Seebeck effect probed by temperature dependent measurements in Gd$_{3}$Fe$_{5}$O$_{12}$

We probe the spin Seebeck effect in Gd$_{3}$Fe$_{5}$O$_{12}$/Pt hybrid structures as a function of temperature and observe two sign changes of the spin Seebeck signal with decreasing temperature. A first sign change occurs at a temperature close to the Gd$_{3}$Fe$_{5}$O$_{12}$ magnetic compensation point at around 280 K. There the spin Seebeck signal changes sign abruptly with unaltered amplitude, indicating that the spin current is mainly caused by the magnetic Fe sub-lattices, which reorient their directions at this temperature. A second, more gradual sign change takes place around the ordering temperature of the Gd sub-lattice in the range of 65-85 K, showing that the Gd magnetic sub-lattice dominates the thermally driven spin current at lower temperatures. These sign changes together with the non-monotonous dependence of the spin Seebeck signal on the temperature demonstrate that the magnonic spin current is not simply replicating the effective magnetization of Gd$_{3}$Fe$_{5}$O$_{12}$. Rather, the thermally generated net spin current results from a complex interplay of the three magnetic sub-lattices involved.

cond-mat.mes-hall↗

arXiv2014

Spin Hall Magnetoimpedance

The recently discovered spin Hall magnetoresistance effect electrically probes pure spin current flow across a ferrimagnetic insulator/normal metal bilayer interface. While usually the DC electrical resistance of the bilayer is measured as a function of the magnetization orientation in the magnetic insulator, we here present magnetoimpedance measurements using bias currents with frequencies up to several GHz. We find that the spin Hall magnetoresistance effect persists up to frequencies of at least 4 GHz, enabling a fast readout of the magnetization direction in magnetic insulator/normal metal bilayers. Our data furthermore show that all interaction time constants relevant for the spin Hall magnetoresistance effect are shorter than 40 ps.

cond-mat.mes-hall↗