arXiv subjects

Sébastien Pairis

Publications and source records attributed to Sébastien Pairis.

13 recordsLinked to original sources

arXiv2024

Magnetic field sorting of superconducting graphite particles with T$_c$$>$400K

It has been claimed that graphite hosts superconductivity at room temperature, although all efforts to isolate it have been vain. Here we report a separation method that uses magnetic field gradients to sort the superconducting from normal grains out of industrial graphite powders. We have obtained a concentrate of above room temperature superconducting particles. Electrical resistance measurements on agglomerates of sorted grains of three types of graphite show transition temperatures up to T$_{c{_{onset}}} \sim$ 700K with zero resistance up to $\sim$ 500K. Magnetization measurements confirm these values through jumps at \textit{T$_c$} in the zero field cooled curves, and by the occurrence diamagnetic hysteretic cycles shrinking with temperature. Our results open the door towards the study of above room temperature superconducting ill-stacked graphite phases.

cond-mat.supr-con↗

arXiv2024

Hyperspectral electromechanical imaging at the nanoscale: Dynamical backaction, dissipation and quantum fluctuations

We report a new scanning nanomechanical noise microscopy platform enabling to both heat and acquire the fluctuations of mechanical nanostructures with nanometric resolution. We use this platform to image the thermally activated nanomechanical dynamics of a model system consisting of a $40\,\mathrm{nm}$ diameter single-defect nanowire, while scanning a localized heat source across its surface. We develop a thermal backaction model, which we use to demonstrate a close connection between the structure of the nanowire, its thermal response, its dissipation and its fluctuations. We notably show that the defect behaves as a single fluctuation hub, whose e-beam excitation yields a far off-equilibrium vibrational state, largely dominated by the quantum fluctuations of the heating source. Our platform is of interest for future quantitative investigation of fundamental nanoscale dynamical phenomena, and appears as a new playground for investigating quantum thermodynamics in the strongly dissipative regime and at room temperature.

cond-mat.mes-hall↗

arXiv2023

Pressure-induced formation of cubic lutetium hydrides derived from trigonal LuH$_3$

In recent years, there has been a fervent search for room-temperature superconductivity within the binary hydrides. However, as the number of untested compounds dwindled, it became natural to begin searching within the ternary hydrides. This led to the controversial discovery of room-temperature superconductivity at only 1GPa in nitrogen-doped lutetium hydride [Dasenbrock-Gammon et al., Nature 615, 244 (2023)] and consequently provided much impetus for the synthesis of nitrogen-based ternary hydrides. Here, we report the synthesis of stable trigonal LuH$_3$ by hydrogenating pure lutetium which was subsequently pressurised to $\sim$2GPa in a dilute-N$_2$/He-rich pressure medium. Raman spectroscopy and x-ray diffraction were used to characterise the structures throughout. After depressurising, energy-dispersive and wavelength-dispersive X-ray spectroscopies characterised the final compound. Though our compound under pressure exhibits similar structural behaviour to the Dasenbrock-Gammon et al. sample, we do not observe any nitrogen within the structure of the recovered sample at ambient pressure. We observe two cubic structures under pressure that simultaneously explain the X-ray diffraction and Raman spectra observed: the first corresponds well to $Fm\overline{3}m$ LuH$_{2+x}$, whilst the latter is an $Ia\overline{3}$-type structure.

cond-mat.supr-con↗

arXiv2023

X-ray diffraction study of epitaxial CuO nanostructures obtained through post-deposition annealing of Cu on SrTiO$_3$(001)

Orientation, structure and morphology in the early growth stages of CuO films on strontium titanate were studied by synchrotron radiation X-ray diffraction. Nanostructured CuO films were obtained by ex situ heat treatment at 970 K in oxygen flow at ambient pressure after an initial deposition of Cu on SrTiO$_3$(001) at $10^{-4}$ Pa oxygen pressure using the molecular beam epitaxy technique. These films at low coverages grow forming islands a few tens of nanometers wide, with the [010] direction perpendicular to the substrate surface. Two types of epitaxies are observed, CuO[001]//SrTiO$_3$[100] and CuO[100]//SrTiO$_3$[100], the former being the preferred one. The combination of these epitaxies with the P4mm surface symmetry of the substrate generates 16 different orientations of nanostructures. The lattice constant values obtained from X-ray diffraction are very close to those of bulk tenorite, with the exception of the monoclinic angle $θ$, which is reduced from 99.54$^\circ$ to 96.76(8)$^\circ$ by the epitaxy constraints. This angle is a key parameter in determining the magnetic properties of CuO.

cond-mat.mtrl-sci↗

arXiv2023

Stability of the In-Plane Room Temperature van der Waals Ferromagnet Chromium Ditelluride and Its Conversion to Chromium-Interleaved CrTe$_2$ Compounds

Van der Waals magnetic materials are building blocks for novel kinds of spintronic devices and playgrounds for exploring collective magnetic phenomena down to the two-dimensional limit. Chromium-tellurium compounds are relevant in this perspective. In particular, the 1$T$ phase of CrTe$_2$ has been argued to have a Curie temperature above 300~K, a rare and desirable property in the class of lamellar materials, making it a candidate for practical applications. However, recent literature reveals a strong variability in the reported properties, including magnetic ones. Using electron microscopy, diffraction and spectroscopy techniques, together with local and macroscopic magnetometry approaches, our work sheds new light on the structural, chemical and magnetic properties of bulk 1$T$-CrTe$_2$ exfoliated in the form of flakes having a thickness ranging from few to several tens of nanometers. We unambiguously establish that 1$T$-CrTe$_2$ flakes are ferromagnetic above room temperature, have an in-plane easy axis of magnetization, low coercivity, and we confirm that their Raman spectroscopy signatures are two modes, $E_{2\text{g}}$ (103.5~cm$^{-1}$) and $A_{1\text{g}}$ (136.5~cm$^{-1}$). We also prove that thermal annealing causes a phase transformation to monoclinic Cr$_5$Te$_8$ and, to a lesser extent, to trigonal Cr$_5$Te$_8$. In sharp contrast with 1$T$-CrTe$_2$, none of these compounds have a Curie temperature above room temperature, and they both have perpendicular magnetic anisotropy. Our findings reconcile the apparently conflicting reports in the literature and open opportunities for phase-engineered magnetic properties.

cond-mat.mtrl-sci↗

arXiv2022

Possible high temperature superconducting transitions in disordered graphite obtained from room temperature deintercalated KC$_8$

Although progress with twisted graphene nano-devices is boosting the superconductivity that is the consequence of their Moiré flat electronic bands, the immense choice for future development is an obstacle for their optimisation. We report here that soft-chemistry deintercalation of KC$_8$ breaks down graphite stacking generating a strong disorder that includes stacking twists and variable local doping. We obtain a bulk graphite whose individual crystallites have different stackings with arbitrary twists and doping, scanning in the same sample a huge number of stacking configurations. We perform magnetisation measurements on batches with different synthesis conditions. The disorder weakens the huge diamagnetism of graphite, revealing several phase transitions. A "ferromagnetic-like" magnetisation appears with Curie temperatures T$_0$$\sim$450K, that has to be subtracted from the measured magnetisation. Depending on sample synthesis, anomalies towards diamagnetic states appear at T$_c$$\sim$110K (3 samples), $\sim$240K (4 samples), $\sim$320K (2 samples). Electrical resistivity measurements yield anomalies for the T$_c\sim$240K transition, with one sample showing a 90% drop. We discuss the possibility that these (diamagnetic and resistitive) anomalies could be due to superconductivity.

cond-mat.supr-con↗

arXiv2018

Shot noise limited nanomechanical detection and radiation pressure backaction from an electron beam

Detecting nanomechanical motion has become an important challenge in Science and Technology. Recently, electromechanical coupling to focused electron beams has emerged as a promising method adapted to ultra-low scale systems. However the fundamental measurement processes associated with such complex interaction remain to be explored. Here we report highly sensitive detection of the Brownian motion of um-long semiconducting nanowires (InAs). The measurement imprecision is found to be set by the shot noise of the secondary electrons generated along the electromechanical interaction. By carefully analysing the nano-electromechanical dynamics, we demonstrate the existence of a radial backaction process which we identify as originating from the momentum exchange between the electron beam and the nanomechanical device, which is also known as radiation pressure.

cond-mat.mes-hall↗

arXiv2017

Transmission XMCD-PEEM imaging of an engineered vertical FEBID cobalt nanowire with a domain wall

Using focused electron-beam-induced deposition (FEBID), we fabricate vertical, platinum-coated cobalt nanowires with a controlled three-dimensional structure. The latter is engineered to feature bends along the height: these are used as pinning sites for domain walls, the presence of which we investigate using X-ray Magnetic Circular Dichroism (XMCD) coupled to PhotoEmission Electron Microscopy (PEEM). The vertical geometry of our sample combined with the low incidence of the X-ray beam produce an extended wire shadow which we use to recover the wire's magnetic configuration. In this transmission configuration, the whole sample volume is probed, thus circumventing the limitation of PEEM to surfaces. This article reports on the first study of magnetic nanostructures standing perpendicular to the substrate with XMCD-PEEM. The use of this technique in shadow mode enabled us to confirm the presence of a domain wall (DW) without direct imaging of the nanowire.

cond-mat.mes-hall↗

arXiv2012

Suppression of Multilayer Graphene Patches during CVD Graphene growth on Copper

By limiting the carbon segregation at the copper surface defects, a pulsed chemical vapor deposition method for single layer graphene growth is shown to inhibit the formation of few-layer regions, leading to a fully single-layered graphene homogeneous at the centimeter scale. Graphene field-effect devices obtained after transfer of pulsed grown graphene on oxidized silicon exhibit mobilities above 5000 cm^2.V^-1.s^-1.

cond-mat.mes-hall↗

arXiv2011

Martensite structures and twinning in substrate-constrained epitaxial Ni-Mn-Ga films deposited by a magnetron co-sputtering process

In order to obtain Ni-Mn-Ga epitaxial films crystallized in martensite structures showing Magnetic-Induced Rearrangement (MIR) of martensite variants, a fine control of the composition is required. Here we present how the co-sputtering process might be helpful in the development of Ni-Mn-Ga epitaxial films. A batch of epitaxial Ni-Mn-Ga films deposited by co-sputtering of a Ni-Mn-Ga ternary target and a pure manganese target has been studied. The co-sputtering process allows a precise control of the film compositions and enables keeping the epitaxial growth of Ni-Mn-Ga austenite during deposition at high temperature. It gives rise to tune the content of the MIR-active 14-modulated martensite in the film at room temperature, as well as micro and macro-twinned domains sizes.

cond-mat.mtrl-sci↗

arXiv2011

Ni-Mn-Ga films in the austenite and the martensite structures at room temperature: Uniaxial texturation and epitaxial growth

Ni-Mn-Ga films in the austenite and the martensite structures at room temperature have been obtained using the DC magnetron sputtering technique. Two elaboration processes were studied. A first batch of samples was deposited using a resist sacrificial layer in order to release the film from the substrate before vacuum annealing. This process leads to polycrystalline films with a strong (022) fiber texture. The martensitic phase transformation of such polycrystalline freestanding films has been studied by optical and scanning electron microscopy. A second batch of samples was grown epitaxially on (100)MgO substrates using different deposition temperatures. The texture has been analyzed with four-circle X-ray diffraction. Epitaxial films crystallized both in the austenite and the martensite structures at room temperature have been studied.

cond-mat.mtrl-sci↗

arXiv2010

Fabrication and characterization of a Ni-Mn-Ga uniaxially textured freestanding film deposited by DC magnetron sputtering

Homogeneous freestanding films have been obtained by the direct current (DC) magnetron sputtering technique using a sacrificial layer. After annealing, the films are crystallized with a strong out-of-plane texture along the (022) direction. The stoichiometry of the annealed films is close to the target composition and leads to a martensitic transformation around 255K. The annealed films demonstrate ferromagnetic behavior with a Curie temperature of about 362K. The magnetization process has been studied on the both states and during the martensitic transition. The saturation magnetizations have been determined by fitting the experimental data with a saturation approach law in the range 1-5T. Results show the saturation magnetization of the martensite is around 10% higher than that of the austenite. A model based on intrinsic magnetic properties of each state allowing the description of the magnetization M=f (H, T) of such polycrystalline films during the martensitic transformation is presented. The mass fraction of martensite inside the austenite phase can be determined using this model. The shape memory effect is analyzed both by scanning electron microscopy and by optical microscopy with in-situ measurement of the resistance temperature dependence.

cond-mat.mtrl-sci↗

arXiv2010

Tuning macro-twinned domain sizes and the b-variants content of the adaptive 14-modulated martensite in epitaxial Ni-Mn-Ga films by co-sputtering

In order to obtain modulated-martensite in our epitaxial Ni-Mn-Ga films, we have tuned the composition by using a co-sputtering process. Here we present how the composition affects the variant distribution of the 14-modulated martensite at room temperature. The nature of such modulated-martensites is still strongly debated for magnetic shape memory alloys. It has been very recently demonstrated that the modulated-martensites in Ni-Mn-Ga are adaptive phases. The results presented here corroborate this theory for the first time, for three different compositions. Moreover, we demonstrate with the help of the adaptive modulations theory that b-variants of the 14-modulated martensite form close to the free-surface of the film to release the stress induced by branching of macro-twinned domains during the martensitic transformation on a rigid substrate. At room temperature, the content of such b-variants is found to strongly decrease when the macro-twinned domain sizes increase.

cond-mat.mtrl-sci↗