SearcharxivSearch

arXiv subjects

Simona Lorenti

Publications and source records attributed to Simona Lorenti.

3 recordsLinked to original sources

Double Step Annealing for the Recovering of Ion Implantation Defectiveness in 4H-SiC DIMOSFET

Thermal annealing plays a crucial role for healing the defectiveness in the ion implanted regions of DIMOSFETs (Double Implanted MOSFETs) devices. In this work, we have studied the effect of a double step annealing on the body (Al implanted) and the source (P implanted) regions of such devices. We found that a high temperature annealing (1750°C, 1h) followed by a lower temperature one (1500°C, 4h) is mandatory to achieve low defects concentration and good crystal quality in both the n- and p- type zones of the device.

cond-mat.mtrl-sci

Thermal Annealing of High Dose P Implantation in 4H-SiC

In this work, we have studied the crystal defectiveness and doping activation subsequent to ion implantation and post-annealing by using various techniques including photoluminescence (PL), Raman spectroscopy and transmission electron microscopy (TEM). The aim of this work was to test the effectiveness of double step annealing to reduce the density of point defects generated during the annealing of a P implanted 4H-SiC epitaxial layer. The outcome of this work evidences that neither the first, 1 hour isochronal annealing at 1650 - 1700 - 1750 °C, nor the second one, at 1500 °C for times between 4 hour and 14 hour, were able to recover a satisfactory crystallinity of the sample and achieve dopant activations exceeding 1%.

cond-mat.mtrl-sci

Temperature-dependent Fowler-Nordheim electron barrier height in SiO2/4H-SiC MOS capacitors

This paper reports on the physical and temperature-dependent electrical characterizations of the oxide/semiconductor interface in MOS capacitors with a SiO2 layer deposited on 4H-SiC using dichlorosilane and nitrogen-based vapor precursors. The capacitors, subjected to a standard post deposition annealing process in N2O, exhibited an interface state density Dit = 9.0 x 1011cm-2eV-1 below the conduction band edge. At room temperature, a barrier height (conduction band offset) of 2.8 eV was observed, along with the presence of negative charges in the insulator. The SiO2 insulating properties were evaluated by studying the experimental temperature-dependence of the gate current. In particular, the temperature-dependent electrical measurements showed a negative temperature coefficient of the Fowler-Nordheim electron barrier height (dFB/dT = - 0.98 meV/°C), which was very close to the expected value for an ideal SiO2/4H-SiC system and much lower compared to the values reported for thermally grown SiO2. This smaller dependence of FB on the temperature and the increase of the current level with temperature in the transcharacteristics measured in the relative fabricated MOSFETs represents a clear advantage of our deposited SiO2 for the operation of MOSFET devices at high temperatures.

physics.app-ph