arXiv subjects

Sokrates T. Pantelides

Publications and source records attributed to Sokrates T. Pantelides.

51 records · Page 3Linked to original sources

arXiv2015

High On/Off Ratio Memristive Switching of Manganite-Cuprate Bilayer by Interfacial Magnetoelectricity

Memristive switching serves as the basis for a new generation of electronic devices. Memristors are two-terminal devices in which the current is turned on and off by redistributing point defects, e.g., vacancies, which is difficult to control. Memristors based on alternative mechanisms have been explored, but achieving both the high On/Off ratio and the low switching energy desirable for use in electronics remains a challenge. Here we report memristive switching in a La0.7Ca0.3MnO3/PrBa2Cu3O7 bilayer with an On/Off ratio greater than 10^3 and demonstrate that the phenomenon originates from a new type of interfacial magnetoelectricity. Using results from first-principles calculations, we show that an external electric-field induces subtle displacements of the interfacial Mn ions, which switches on/off an interfacial magnetic "dead" layer, resulting in memristive behavior for spin-polarized electron transport across the bilayer. The interfacial nature of the switching entails low energy cost about of a tenth of atto Joule for write/erase a "bit". Our results indicate new opportunities for manganite/cuprate systems and other transition-metal-oxide junctions in memristive applications.

cond-mat.str-el↗

arXiv2015

Two-dimensional nanovaristors at grain boundaries account for memristive switching in polycrystalline BiFeO3

Memristive switching in polycrystalline materials is widely attributed to the formation and rupture of conducting filaments, believed to be mediated by oxygen-vacancy redistribution. The underlying atomic-scale processes are still unknown, however, which limits device modeling and design. Here we combine experimental data with multi-scale calculations to elucidate the entire atomic-scale cycle in undoped polycrystalline BiFeO3. Conductive atomic force microscopy reveals that the grain boundaries behave like two-dimensional nanovaristors while, on the return part of the cycle, the decreasing current is through the grains. Using density-functional-theory and Monte-Carlo calculations we deduce the atomic-scale mechanism of the observed phenomena. Oxygen vacancies in non-equilibrium concentrations are initially distributed relatively uniformly, but they are swept into the grain boundaries by an increasing voltage. A critical voltage, the SET voltage, then eliminates the barrier for hopping conduction through vacancy energy levels in grain boundaries. On the return part of the cycle, the grain boundaries are again non-conductive, but the grains show nonzero conductivity by virtue of remote doping by oxygen vacancies. The RESET voltage amounts to a heat pulse that redistributes the vacancies. The realization that nanovaristors are at the heart of memristive switching in polycrystalline materials may open possibilities for novel devices and circuits.

cond-mat.mtrl-sci↗

arXiv2015

Atomic origin of high temperature electron trapping in MOS devices

MOSFETs based on wide band-gap semiconductors are suitable for operations at high temperature, at which additional atomic-scale processes that are benign at lower temperatures can get activated which results in device degradation. Recently significant enhancement of electron trapping was observed under positive bias in SiC MOSFETs at temperatures higher than 150°C. Here we report first-principle calculations showing that the enhanced electron trapping is associated with thermally activated capturing of a second electron by an oxygen vacancy in SiO2, by which the vacancy transforms into a new structure that comprises one Si dangling bond and a bond between a five-fold and a four-fold Si atoms. The results suggest a key role of oxygen vacancies and their structural reconfigurations in the reliability of high-temperature MOS devices.

cond-mat.mtrl-sci↗

arXiv2013

p-type doping in CVD grown MoS2 using Nb

We report on the first demonstration of p-type doping in large area few-layer films of (0001)-oriented chemical vapor deposited (CVD) MoS2. Niobium was found to act as an efficient acceptor up to relatively high density in MoS2 films. For a hole density of 4 x 1020 cm-3 Hall mobility of 8.5 cm2V-1s-1 was determined, which matches well with the theoretically expected values. XRD and Raman characterization indicate that the film had good out-of-plane crystalline quality. Absorption measurements showed that the doped sample had similar characteristics to high-quality undoped samples, with a clear absorption edge at 1.8 eV. This demonstration of p-doping in large area epitaxial MoS2 could help in realizing a wide variety of electrical and opto-electronic devices based on layered metal dichalcogenides.

cond-mat.mtrl-sci↗

arXiv2013

Bandgap Engineering of Strained Monolayer and Bilayer MoS2

We report the influence of uniaxial tensile mechanical strain in the range 0-2.2% on the phonon spectra and bandstructures of monolayer and bilayer molybdenum disulfide (MoS2) two-dimensional crystals. First, we employ Raman spectroscopy to observe phonon softening with increased strain, breaking the degeneracy in the E' Raman mode of MoS2, and extract a Grüneisen parameter of ~1.06. Second, using photoluminescence spectroscopy we measure a decrease in the optical band gap of MoS2 that is roughly linear with strain, ~45 meV% strain for monolayer MoS2 and ~120 meV% strain for bilayer MoS2. Third, we observe a pronounced strain-induced decrease in the photoluminescence intensity of monolayer MoS2 that is indicative of the direct-to-indirect transition of the character of the optical band gap of this material at applied strain of ~1.5%, a value supported by first-principles calculations that include excitonic effects. These observations constitute the first demonstration of strain engineering the band structure in the emergent class of two-dimensional crystals, transition-metal dichalcogenides.

cond-mat.mes-hall↗

arXiv2012

Competing Atomic and Molecular Mechanisms of Thermal Oxidation

The oxidation of SiC and Si provide a unique opportunity for studying oxidation mechanisms because the product is the same, SiO2. Silicon oxidation follows a linear-parabolic law, with molecular oxygen identified as the oxidant. SiC oxidation obeys the same linear-parabolic law but has different rates and activation energies and exhibits much stronger face-dependence. Using results from first-principles calculations, we show that atomic and molecular oxygen are the oxidant for Si- and C-face SiC respectively. Comparing SiC with Si, we elucidate how the interface controls the competition between atomic and molecular mechanisms.

cond-mat.mtrl-sci↗

arXiv2012

Probing charge scattering mechanisms in suspended graphene by varying its dielectric environment

Graphene with high carrier mobility μ is required both for graphene-based electronic devices and for the investigation of the fundamental properties of graphene's Dirac fermions. It is largely accepted that the mobility-limiting factor in graphene is the Coulomb scattering off of charged impurities that reside either on graphene or in the underlying substrate. This is true both for traditional graphene devices on SiO2 substrates and possibly for the recently reported high-mobility suspended and supported devices. An attractive approach to reduce such scattering is to place graphene in an environment with high static dielectric constant κ that would effectively screen the electric field due to the impurities. However, experiments so far report only a modest effect of high-κ environment on mobility. Here, we investigate the effect of the dielectric environment of graphene by studying electrical transport in multi-terminal graphene devices that are suspended in liquids with κ ranging from 1.9 to 33. For non-polar liquids (κ<5) we observe a rapid increase of μ with κ and report a record room-temperature mobility as large as ~60,000 cm2/Vs for graphene devices in anisole (κ=4.3), while in polar liquids (κ>18) we observe a drastic drop in mobility. We demonstrate that non-polar liquids enhance mobility by screening charged impurities adsorbed on graphene, while charged ions in polar liquids cause the observed mobility suppression. Furthermore, using molecular dynamics simulation we establish that scattering by out-of-plane flexural phonons, a dominant scattering mechanism in suspended graphene in vacuum at room temperature, is suppressed by the presence of liquids. We expect that our findings may provide avenues to control and reduce carrier scattering in future graphene-based electronic devices.

cond-mat.mes-hall↗

arXiv2010

Identification of the major cause of endemically poor mobilities in SiC/SiO2 structures

Materials with good carrier mobilities are desired for device applications, but in real devices the mobilities are usually limited by the presence of interfaces and contacts. Mobility degradation at semiconductor-dielectric interfaces is generally attributed to defects at the interface or inside the dielectric, as is the case in Si/SiO2 structures, where processing does not introduce detrimental defects in the semiconductor. In the case of SiC/SiO2 structures, a decade of research focused on reducing or passivating interface and oxide defects, but the low mobilities have persisted. By invoking theoretical results and available experimental evidence, we show that thermal oxidation generates carbon di-interstitial defects inside the semiconductor substrate and that they are a major cause of the poor mobility in SiC/SiO2 structures.

cond-mat.mtrl-sci↗

arXiv2010

Atomic-scale compensation phenomena at polar interfaces

The interfacial screening charge that arises to compensate electric fields of dielectric or ferroelectric thin films is now recognized as the most important factor in determining the capacitance or polarization of ultrathin ferroelectrics. Here we investigate using aberration-corrected electron microscopy and density functional theory how interfaces cope with the need to terminate ferroelectric polarization. In one case, we show evidence for ionic screening, which has been predicted by theory but never observed. For a ferroelectric film on an insulating substrate, we found that compensation can be mediated by interfacial charge generated, for example, by oxygen vacancies.

cond-mat.mtrl-sci↗

arXiv2010

Control of the structural and magnetic properties of perovskite oxide ultrathin films through the substrate symmetry effect

Perovskite transition-metal oxides are networks of corner-sharing octahedra whose tilts and distortions are known to affect their electronic and magnetic properties. We report calculations on a model interfacial structure to avoid chemical influences and show that the symmetry mismatch imposes an interfacial layer with distortion modes that do not exist in either bulk material, creating new interface properties driven by symmetry alone. Depending on the resistance of the octahedra to deformation, the interface layer can be as small as one unit cell or extend deep into the thin film.

cond-mat.mtrl-sci↗

arXiv2005

Bonding Configurations and Collective Patterns of Ge Atoms Adsorbed on Si(111)-7x7

We report scanning tunneling microscopy observations of Ge deposited on the Si(111)-7x7 surface for a sequence of sub-monolayer coverages. We demonstrate that Ge atoms replace so-called Si adatoms. Initially, the replacements are random, but distinct patterns emerge and evolve with increasing coverage, till small islands begin to form. Corner adatom sites in the faulted half unit cells are preferred. First-principles density functional calculations find that adatom substitution competes energetically with a high-coordination bridge site, but atoms occupying the latter sites are highly mobile. Thus, the observed structures are indeed more thermodynamically stable.

cond-mat.mtrl-sci↗

arXiv2004

Spin-dependent resonant tunneling through quantum-well states in magnetic metallic thin films

Quantum-well (QW) states in {\it nonmagnetic} metal layers contained in magnetic multilayers are known to be important in spin-dependent transport, but the role of QW states in {\it magnetic} layers remains elusive. Here we identify the conditions and mechanisms for resonant tunneling through QW states in magnetic layers and determine candidate structures. We report first-principles calculations of spin-dependent transport in epitaxial Fe/MgO/FeO/Fe/Cr and Co/MgO/Fe/Cr tunnel junctions. We demonstrate the formation of sharp QW states in the Fe layer and show discrete conductance jumps as the QW states enter the transport window with increasing bias. At resonance, the current increases by one to two orders of magnitude. The tunneling magnetoresistance ratio is several times larger than in simple spin tunnel junctions and is positive (negative) for majority- (minority-) spin resonances, with a large asymmetry between positive and negative biases. The results can serve as the basis for novel spintronic devices.

cond-mat.mes-hall↗

arXiv2004

Dopants adsorbed as single atoms prevent degradation of catalysts

The design of catalysts with desired chemical and thermal properties is viewed as a grand challenge for scientists and engineers. For operation at high temperatures, stability against structural transformations is a key requirement. Although doping has been found to impede degradation, the lack of atomistic understanding of the pertinent mechanism has hindered optimization. For example, porous gamma-Al2O3, a widely used catalyst and catalytic support, transforms to non-porous alpha-Al2O3 at ~1,100C. Doping with La raises the transformation temperature to ~1,250C, but it has not been possible to establish if La atoms enter the bulk, adsorb on surfaces as single atoms or clusters, or form surface compounds. Here, we use direct imaging by aberration-corrected Z-contrast scanning transmission electron microscopy coupled with extended X-ray absorption fine structure and first-principles calculations to demonstrate that, contrary to expectations, stabilization is achieved by isolated La atoms adsorbed on the surface. Strong binding and mutual repulsion of La atoms effectively pin the surface and inhibit both sintering and the transformation to alpha-Al2O3. The results provide the first guidelines for the choice of dopants to prevent thermal degradation of catalysts and other porous materials.

cond-mat.mtrl-sci↗

arXiv2001

Atomic-Scale Dynamics of the Formation and Dissolution of Carbon Clusters in SiO2

Oxidation of SiC produces SiO2 while CO is released. A `reoxidation' step at lower temperatures is, however, necessary to produce high-quality SiO2. This step is believed to cleanse the oxide of residual C without further oxidation of the SiC substrate. We report first-principles calculations that describe the nucleation and growth of O-deficient C clusters in SiO2 under oxidation conditions, fed by the production of CO at the advancing interface, and their gradual dissolution by the supply of O under reoxidation conditions. We predict that both CO and CO2 are released during both steps.

cond-mat.mtrl-sci↗

arXiv1995

Coupled-barrier diffusion: the case of oxygen in silicon

Oxygen migration in silicon corresponds to an apparently simple jump between neighboring bridge sites. Yet, extensive theoretical calculations have so far produced conflicting results and have failed to provide a satisfactory account of the observed $2.5$ eV activation energy. We report a comprehensive set of first-principles calculations that demonstrate that the seemingly simple oxygen jump is actually a complex process involving coupled barriers and can be properly described quantitatively in terms of an energy hypersurface with a ``saddle ridge'' and an activation energy of $\sim 2.5 $ eV. Earlier calculations correspond to different points or lines on this hypersurface.

cond-mat↗