arXiv subjects

Sukumar Rajauria

Publications and source records attributed to Sukumar Rajauria.

14 recordsLinked to original sources

arXiv2024

Applicability of Ideal Gas Law in the Air-bearing of Hard Drives

This report evaluates the applicability of the ideal gas law in the pressurized air-bearing of hard disk drives when calculating the relative humidity. We employ a semi-analytical numerical method that solves vapor-liquid equilibrium using the Redlich-Kwong and Peng-Robinson equation of state to calculate the saturation pressure of water. The deviation from the ideal gas law is quantified and examined through saturation pressure isotherms. We find that at low temperatures, lighter gases such as helium show little deviation from the ideal gas law, whereas heavier gases such as nitrogen deviate significantly. As temperature increases, the difference between the gases decreases. The results suggest that in areas of low temperature, the non-ideal nature of gases must be taken into account.

physics.app-ph↗

arXiv2020

Precise nanoscale temperature mapping in operational microelectronic devices by use of a phase change material

The microelectronics industry is pushing the fundamental limit on the physical size of individual elements to produce faster and more powerful integrated chips. These chips have nanoscale features that dissipate power resulting in nanoscale hotspots leading to device failures. To understand the reliability impact of the hotspots, the device needs to be tested under the actual operating conditions. Therefore, the development of high-resolution thermometry techniques is required to understand the heat dissipation processes during the device operation. Recently, several thermometry techniques have been proposed,such as radiation thermometry, thermocouple based contact thermometry, scanning thermal microscopy (SThM), scanning transmission electron microscopy (STEM) and transition based threshold thermometers. However, most of these techniques have limitations including the need for extensive calibration, perturbation of the actual device temperature, low throughput, and the use of ultra-high vacuum. Here, we present a facile technique, which uses a thin film contact thermometer based on the phase change material Ge2Sb2Te5, to precisely map thermal contours from the nanoscale to the microscale. Ge2Sb2Te5 undergoes a crystalline transition at Tg with large changes in its electric conductivity, optical reflectivity and density. Using this approach, we map the surface temperature of a nanowire and an embedded micro-heater on the same chip where the scales of the temperature contours differ by three orders of magnitude. The spatial resolution can be as high as 20 nanometers thanks to the continuous nature of the thin film.

physics.app-ph↗

arXiv2017

Electrostatically tunable adhesion in a high speed sliding interface

Contact hysteresis between sliding interfaces is a widely observed phenomenon from macro- to nano- scale sliding interfaces. Most of such studies are done using an atomic force microscope (AFM) where the sliding speed is a few μm/s. Here, we present a unique study on stiction between the head-disk interface of commercially available hard disk drives, wherein vertical clearance between the head and the disk is of the same order as in various AFM based fundamental studies, but with a sliding speed that is nearly six orders of magnitude higher. We demonstrate that although the electrostatic force (DC or AC voltage) is an attractive force, the AC voltage induced out-of-plane oscillation of the head with respect to disk is able to suppress completely the contact hysteresis.

physics.app-ph↗

arXiv2016

Voltage assisted asymmetric nanoscale wear on ultra-smooth diamond like carbon thin films at high sliding speeds

The understanding of tribo- and electro-chemical phenomenons on the molecular level at a sliding interface is a field of growing interest. Fundamental chemical and physical insights of sliding surfaces are crucial for understanding wear at an interface, particularly for nano or micro scale devices operating at high sliding speeds. A complete investigation of the electrochemical effects on high sliding speed interfaces requires a precise monitoring of both the associated wear and surface chemical reactions at the interface. Here, we demonstrate that head-disk interface inside a commercial magnetic storage hard disk drive provides a unique system for such studies. The results obtained shows that the voltage assisted electrochemical wear lead to asymmetric wear on either side of sliding interface.

cond-mat.mes-hall↗

arXiv2015

Nanoscale wear and kinetic friction between atomically smooth surfaces sliding at high speeds

The kinetic friction and wear at high sliding speeds is investigated using the head-disk interface of hard disk drives, wherein, the head and the disk are less than 10 nm apart and move at sliding speeds of 5-10 m/s relative to each other. While the spacing between the sliding surfaces is of the same order of magnitude as various AFM based fundamental studies on friction, the sliding speed is nearly six orders of magnitude larger, allowing a unique set-up for a systematic study of nanoscale wear at high sliding speeds. In a hard disk drive, the physical contact between the head and the disk leads to friction, wear and degradation of the head overcoat material (typically diamond like carbon). In this work, strain gauge based friction measurements are performed; the friction coefficient as well as the adhering shear strength at the head-disk interface are extracted; and an experimental set-up for studying friction between high speed sliding surfaces is exemplified.

cond-mat.mes-hall↗

arXiv2014

High-speed discrimination and sorting of sub-micron particles using a microfluidic device

The size- and fluorescence-based sorting of micro- and nano-scale particles suspended in fluid presents a significant and important challenge for both sample analysis and for manufacturing of nanoparticle-based products. Here we demonstrate a disposable microfluidic particle sorter that enables high-throughput, on-demand counting and binary sorting of sub-micron particles and cells, using either fluorescence or an electrically-based determination of particle size. Size-based sorting uses a resistive pulse sensor integrated on-chip, while fluorescence-based discrimination is achieved using on-the-fly optical image capture and analysis. Following detection and analysis, the individual particles are deflected using a pair of piezoelectric actuators, directing the particles into one of two desired output channels; the main flow goes into a third waste channel. The integrated system can achieve sorting fidelities of better than 98\%, and the mechanism can successfully count and actuate, on demand, more than 60,000 particles/min.

cond-mat.soft↗

arXiv2011

Porous Superhydrophobic Membranes: Hydrodynamic Anomaly in Oscillating Flows

We have fabricated and characterized a novel superhydrophobic system, a mesh-like porous superhydrophobic membrane with solid area fraction $Φ_s$, which can maintain intimate contact with outside air and water reservoirs simultaneously. Oscillatory hydrodynamic measurements on porous superhydrophobic membranes as a function of $Φ_s$ reveal surprising effects. The hydrodynamic mass oscillating in-phase with the membranes stays constant for $0.9\leΦ_s\le1$, but drops precipitously for $Φ_s < 0.9$. The viscous friction shows a similar drop after a slow initial decrease proportional to $Φ_s$. We attribute these effects to the percolation of a stable Knudsen layer of air at the interface.

cond-mat.soft↗

arXiv2011

Efficient Quasiparticle Evacuation in Superconducting Devices

We have studied the diffusion of excess quasiparticles in a current-biased superconductor strip in proximity to a metallic trap junction. In particular, we have measured accurately the superconductor temperature at a near-gap injection voltage. By analyzing our data quantitatively, we provide a full description of the spatial distribution of excess quasiparticles in the superconductor. We show that a metallic trap junction contributes significantly to the evacuation of excess quasiparticles.

cond-mat.mes-hall↗

arXiv2009

Quasiparticle diffusion based heating in superconductor tunneling micro-coolers

In a hybrid Superconductor - Insulator - Normal metal tunnel junction biased just below the gap, the extraction of hot electrons out of the normal metal results in electronic cooling effect. The quasiparticles injected in the superconductor accumulate near the tunnel interface, thus increasing the effective superconductor temperature. We propose a simple model for the diffusion of excess quasiparticles in a superconducting strip with an additional trap junction. This diffusion model has a complete analytic solution, which depends on experimentally accessible parameters. We find that the accumulated quasiparticles near the junction reduce the efficiency of the device. This study is also relevant to more general situations making use of superconducting tunnel junctions, as low temperature detectors.

cond-mat.mes-hall↗

arXiv2009

Spin-Valve Effect of the Spin Accumulation Resistance in a Double Ferromagnet - Superconductor Junction

We have measured the transport properties of Ferromagnet - Superconductor nanostructures, where two superconducting aluminum (Al) electrodes are connected through two ferromagnetic iron (Fe) ellipsoids in parallel. We find that, below the superconducting critical temperature of Al, the resistance depends on the relative alignment of the ferromagnets' magnetization. This spin-valve effect is analyzed in terms of spin accumulation in the superconducting electrode submitted to inverse proximity effect.

cond-mat.supr-con↗

arXiv2009

Inherent thermometry in a hybrid superconducting tunnel junction

We discuss inherent thermometry in a Superconductor - Normal metal - Superconductor tunnel junction. In this configuration, the energy selectivity of single-particle tunneling can provide a significant electron cooling, depending on the bias voltage. The usual approach for measuring the electron temperature consists in using an additional pair of superconducting tunnel junctions as probes. In this paper, we discuss our experiment performed on a different design with no such thermometer. The quasi-equilibrium in the central metallic island is discussed in terms of a kinetic equation including injection and relaxation terms. We determine the electron temperature by comparing the micro-cooler experimental current-voltage characteristic with isothermal theoretical predictions. The limits of validity of this approach, due to the junctions asymmetry, the Andreev reflection or the presence of sub-gap states are discussed.

cond-mat.supr-con↗

arXiv2009

Competition between electronic cooling and Andreev dissipation in a superconducting micro-cooler

We discuss very low temperature experiments on superconducting micro-coolers made of a double Normal metal - Insulator - Superconductor junction. We investigate with a high resolution the differential conductance of the micro-cooler as well as of additional probe junctions. There is an explicit crossover between the single quasi-particle current and the phase-coherent Andreev current. We establish a thermal model by considering the thermal contribution due to the Andreev current. The related increase of the electron temperature is discussed, including the influence of several parameters like the phase-coherence length or the tunnel junction transparency.

cond-mat.supr-con↗

arXiv2008

Andreev Current-Induced Dissipation in a Hybrid Superconducting Tunnel Junction

We have studied hybrid superconducting micro-coolers made of a double Superconductor-Insulator-Normal metal tunnel junction. Under subgap conditions, the Andreev current is found to dominate the single-particle tunnel current. We show that the Andreev current introduces additional dissipation in the normal metal equivalent to Joule heating. By analyzing quantitatively the heat balance in the system, we provide a full description of the evolution of the electronic temperature with the voltage. The dissipation induced by the Andreev current is found to dominate the quasiparticle tunneling-based cooling over a large bias range.

cond-mat.supr-con↗

arXiv2007

Electron and phonon Cooling in a Superconductor - Normal Metal - Superconductor Tunnel Junction

We present evidence for the cooling of normal metal phonons by electron tunneling in a Superconductor - Normal metal - Superconductor tunnel junction. The normal metal electron temperature is extracted by comparing the device current-voltage characteristics to the theoretical prediction. We use a quantitative model for the phonon cooling that includes the electron-phonon coupling in the normal metal and the Kapitza resistance between the substrate and the metal. It gives an excellent fit to the data and enables us to extract an effective phonon temperature in the normal metal.

cond-mat.mes-hall↗