arXiv subjects

Yudong Gu

Publications and source records attributed to Yudong Gu.

11 recordsLinked to original sources

arXiv2026

Design, Fabrication and Characterization of Microwave Multiplexing SQUID Prototype

The readout system with a high multiplexing ratio has become a bottleneck limiting the application of large-scale Transition Edge Sensor (TES) detector arrays. In recent years, the microwave superconducting quantum interference device (SQUID) multiplexer has emerged as a key technology for effectively reading large-scale cryogenic detector arrays. Currently, the microwave SQUID multiplexer is being adopted by an increasing number of experiments due to its capability of achieving a multiplexing ratio of 2000:1 within the readout bandwidth. In this study, we developed and fabricated a 32-channel microwave SQUID multiplexer prototype. And we measured 8 channels of the prototype. The measured equivalent noise current of the prototype reached 42 pA/$\sqrt{Hz}$.

physics.ins-det↗

arXiv2026

Beyond One-Thousandth Energy Resolution with an AlMn TES Detector

The superconducting Transition-Edge Sensor (TES) is a critical technology for next-generation X-ray spectrometers, known for its exceptional energy resolution. In the last decade, TESs based on AlMn alloy films have been extensively used in several cosmic microwave background (CMB) experiments. The advantages of simple fabrication process and easily tunable critical temperature make them an alternative to bilayer TESs. However, they have rarely been applied to X-ray detection until now. We developed an annular AlMn TES for X-ray detection and tested it in a dilution refrigerator with a Superconducting Quantum Interference Device (SQUID) amplifier, achieving an Full Width at Half Maximum (FWHM) of 12.1 +- 0.3 eV at 17.48 keV. To the best of our knowledge, this is the first demonstration of an AlMn TES achieving an energy resolution below 0.1%, highlighting its potential for high-resolution X-ray detection.

astro-ph.IM↗

arXiv2026

Development of Low-Noise Two-stage dc-SQUID for TES Detector Readout

Direct-current superconducting quantum interference devices (dc-SQUIDs) are one of the most sensitive magnetic detectors. These sensors are extensively used in the readout of superconducting transition edge sensors (TESs), which are used for the detection of weak signals. A cosmic microwave background (CMB) polarization telescope operating in 22-48 GHz is currently under developing. The TESs calorimeter of the telescope will be readout by a time-division multiplexer (TDM) SQUID readout system. We develop a two-stage dc-SQUID amplifier circuit, comprising an input-stage SQUID with 4 SQUID cells and a series SQUID array (SSA) with 100 SQUID cells. This configuration has been shown to achieve extremely high signal gain while effectively controlling system noise. We assess the system noise at $300$ $mK$ in an adiabatic demagnetisation refrigerator (ADR). The the measured magnetic flux noise of the two-stage SQUID circuit system is approximately $0.3$ ${\mu}\Phi_{0}/\sqrt{Hz}$ at $10$ $kHz$. The current noise equivalent to the input coil of input SQUID is about $2.4$ $pA/\sqrt{Hz}$. This result meets the low-noise readout requirements of the CMB TES and other applications with TES detectors.

physics.ins-det↗

arXiv2025

Fabrication and Characterization of X-ray TES Detectors Based on Annular AlMn Alloy Films

AlMn alloy flms are widely fabricated into superconducting transition edge sensors (TESs) for the detection of cosmic microwave background radiation. However, the application in X-ray or gamma-ray detection based on AlMn TES is rarely reported. In this study, X-ray TES detectors based on unique annular AlMn flms are devel-oped. The fabrication processes of TES detectors are introduced in detail. The char-acteristics of three TES samples are evaluated in a dilution refrigerator. The results demonstrate that the I-V characteristics of the three annular TES detectors are highly consistent. The TES detector with the smallest absorber achieved the best energy resolution of 11.0 eV @ 5.9 keV, which is inferior to the theoretical value. The dis-crepancy is mainly attributed to the larger readout electronics noise than expected.

physics.ins-det↗

arXiv2025

Development of 6-inch 80-170 GHz broadband silicon plated horn antenna arrays for primordial gravitational wave search

Searching for primordial gravitational wave in cosmic microwave background (CMB) polarization signal is one of the key topics in modern cosmology. Cutting-edge CMB telescopes requires thousands of pixels to maximize mapping speed. Using modular design, the telescope focal plane is simplified as several detector modules. Each module has hundreds of pixels including antenna arrays, detector arrays, and readout arrays. The antenna arrays, as the beam defining component, determine the overall optical response of the detector module. In this article, we present the developments of 6-inch broadband antenna arrays from 80GHz to 170GHz for the future IHEP focal plane module. The arrays are fabricated from 42 6-inch silicon wafers including 456 antennas, 7% more pixels than usual design. The overall in-band cross polarization is smaller than -20 dB and the in-band beam asymmetry is smaller than 10%, fulfilling the requirements for primordial gravitational wave search.

astro-ph.IM↗

arXiv2023

In-orbit Performance of ME onboard Insight-HXMT in the first 5 years

Introduction: The Medium Energy X-ray telescope (ME) is a collimated X-ray telescope onboard the Insight hard X-ray modulation telescope (Insight-HXMT) satellite. It has 1728 Si-PIN pixels readout using 54 low noise application-specific integrated circuits (ASICs). ME covers the energy range of 5-30 keV and has a total detection area of 952 cm2. The typical energy resolution of ME at the beginning of the mission is 3 keV at 17.8 keV (Full Width at Half Maximum, FWHM) and the time resolution is 255 us. In this study, we present the in-orbit performance of ME in its first 5 years of operation. Methods: The performance of ME was monitored using onboard radioactive sources and astronomical X-ray objects. ME carries six 241Am radioactive sources for onboard calibration, which can continuously illuminate the calibration pixels. The long-term performance evolution of ME can be quantified using the properties of the accumulated spectra of the calibration pixels. In addition, observations of the Crab Nebula and the pulsar were used to check the long-term evolution of the detection efficiency as a function of energy. Conclusion: After 5 years of operation, 742 cm2 of the Si-PIN pixels were still working normally. The peak positions of 241Am emission lines gradually shifted to the high energy region, implying a slow increase in ME gain of 1.43%. A comparison of the ME spectra of the Crab Nebula and the pulsar shows that the E-C relations and the redistribution matrix file are still acceptable for most data analysis works, and there is no detectable variation in the detection efficiency.

astro-ph.IM↗

arXiv2022

An Insight-HXMT view of the mHz quasi-regular modulation phenomenon in the black hole X-ray binary 4U 1630-47

Here we report the spectral-timing results of the black hole X-ray binary 4U 1630-47 during its 2021 outburst using observations from the Hard X-ray Modulation Telescope. Type-C quasi-periodic oscillations (QPOs) in 1.6--4.2 Hz and quasi-regular modulation (QRM) near 60 mHz are detected during the outburst. The mHz QRM has a fractional rms of 10%--16% in the 8--35 keV energy band with a Q factor (frequency/width) of 2--4. Benefiting from the broad energy band of hxmt, we study the energy dependence of the 60 mHz QRM in 1--100 keV for the first time. We find that the fractional rms of the mHz QRM increases with photon energy, while the time lags of the mHz QRM are soft and decrease with photon energy. Fast recurrence of the mHz QRM, in a timescale of less than one hour, has been observed during the outburst. During this period, the corresponding energy spectra moderately change when the source transitions from the QRM state to the non-QRM state. The QRM phenomena also shows a dependence with the accretion rate. We suggest that the QRM could be caused by an unknown accretion instability aroused from the corona.

astro-ph.HE↗

arXiv2022

Quasi-periodic oscillations of the X-ray burst from the magnetar SGR J1935+2154 and associated with the fast radio burst FRB 200428

The origin(s) and mechanism(s) of fast radio bursts (FRBs), which are short radio pulses from cosmological distances, have remained a major puzzle since their discovery. We report a strong Quasi-Periodic Oscillation(QPO) of 40 Hz in the X-ray burst from the magnetar SGR J1935+2154 and associated with FRB 200428, significantly detected with the Hard X-ray Modulation Telescope (Insight-HXMT) and also hinted by the Konus-Wind data. QPOs from magnetar bursts have only been rarely detected; our 3.4 sigma (p-value is 2.9e-4) detection of the QPO reported here reveals the strongest QPO signal observed from magnetars (except in some very rare giant flares), making this X-ray burst unique among magnetar bursts. The two X-ray spikes coinciding with the two FRB pulses are also among the peaks of the QPO. Our results suggest that at least some FRBs are related to strong oscillation processes of neutron stars. We also show that we may overestimate the significance of the QPO signal and underestimate the errors of QPO parameters if QPO exists only in a fraction of the time series of a X-ray burst which we use to calculate the Leahy-normalized periodogram.

astro-ph.HE↗

arXiv2021

Insight-HXMT observations of jet-like corona in a black hole X-ray binary MAXI J1820+070

A black hole X-ray binary produces hard X-ray radiation from its corona and disk when the accreting matter heats up. During an outburst, the disk and corona co-evolves with each other. However, such an evolution is still unclear in both its geometry and dynamics. Here we report the unusual decrease of the reflection fraction in MAXI J1820+070, which is the ratio of the coronal intensity illuminating the disk to the coronal intensity reaching the observer, as the corona is observed to contrast during the decay phase. We postulate a jet-like corona model, in which the corona can be understood as a standing shock where the material flowing through. In this dynamical scenario, the decrease of the reflection fraction is a signature of the corona's bulk velocity. Our findings suggest that as the corona is observed to get closer to the black hole, the coronal material might be outflowing faster.

astro-ph.HE↗

arXiv2019

The Medium Energy (ME) X-ray telescope onboard the Insight-HXMT astronomy satellite

The Medium Energy X-ray telescope (ME) is one of the three main telescopes on board the Insight Hard X-ray Modulation Telescope (Insight-HXMT) astronomy satellite. ME contains 1728 pixels of Si-PIN detectors sensitive in 5-30 keV with a total geometrical area of 952 cm2. Application Specific Integrated Circuit (ASIC) chips, VA32TA6, is used to achieve low power consumption and low readout noise. The collimators define three kinds of field of views (FOVs) for the telescope, 1°{\times}4°, 4°{\times}4°, and blocked ones. Combination of such FOVs can be used to estimate the in-orbit X-ray and particle background components. The energy resolution of ME is ~3 keV at 17.8 keV (FWHM) and the time resolution is 255 μs. In this paper, we introduce the design and performance of ME.

astro-ph.IM↗

arXiv2019

Insight-HXMT observations of Swift J0243.6+6124 during its 2017-2018 outburst

The recently discovered neutron star transient Swift J0243.6+6124 has been monitored by {\it the Hard X-ray Modulation Telescope} ({\it Insight-\rm HXMT). Based on the obtained data, we investigate the broadband spectrum of the source throughout the outburst. We estimate the broadband flux of the source and search for possible cyclotron line in the broadband spectrum. No evidence of line-like features is, however, found up to $\rm 150~keV$. In the absence of any cyclotron line in its energy spectrum, we estimate the magnetic field of the source based on the observed spin evolution of the neutron star by applying two accretion torque models. In both cases, we get consistent results with $B\rm \sim 10^{13}~G$, $D\rm \sim 6~kpc$ and peak luminosity of $\rm >10^{39}~erg~s^{-1}$ which makes the source the first Galactic ultraluminous X-ray source hosting a neutron star.

astro-ph.HE↗