arXiv subjects

Zhibo Li

Publications and source records attributed to Zhibo Li.

13 recordsLinked to original sources

arXiv2026

Trajectory-Aware Multi-RIS Activation and Configuration: A Riemannian Diffusion Method

Reconfigurable intelligent surfaces (RISs) offer a low-cost, energy-efficient means for enhancing wireless coverage. Yet, their inherently programmable reflections may unintentionally amplify interference, particularly in large-scale, multi-RIS-enabled mobile communication scenarios where dense user mobility and frequent line-of-sight overlaps can severely degrade the signal-to-interference-plus-noise ratio (SINR). To address this challenge, this paper presents a novel generative multi-RIS control framework that jointly optimizes the ON/OFF activation patterns of multiple RISs in the smart wireless environment and the phase configurations of the activated RISs based on predictions of multi-user trajectories and interference patterns. We specially design a long short-term memory (LSTM) artificial neural network, enriched with speed and heading features, to forecast multi-user trajectories, thereby enabling reconstruction of future channel state information. To overcome the highly nonconvex nature of the multi-RIS control problem, we develop a Riemannian diffusion model on the torus to generate geometry-consistent phase-configuration, where the reverse diffusion process is dynamically guided by reinforcement learning. We then rigorously derive the optimal ON/OFF states of the metasurfaces by comparing predicted achievable rates under RIS activation and deactivation conditions. Extensive simulations demonstrate that the proposed framework achieves up to 30\% SINR improvement over learning-based control and up to 44\% gain compared with the RIS always-on scheme, while consistently outperforming state-of-the-art baselines across different transmit powers, RIS configurations, and interference densities.

cs.NI↗

arXiv2026

Performance Bounds of Joint Detection with Kalman Filtering and Channel Decoding for Wireless Networked Control Systems

The joint detection uses Kalman filtering (KF) to estimate the prior probability of control outputs to assist channel decoding. In this paper, we regard the joint detection as maximum a posteriori (MAP) decoding and derive the lower and upper bounds based on the pairwise error probability considering system interference, quantization interval, and weight distribution. We first derive the limiting bounds as the signal-to-noise ratio (SNR) goes to infinity and the system interference goes to zero. Then, we construct an infinite-state Markov chain to describe the consecutive packet losses of the control systems to derive the MAP bounds. Finally, the MAP bounds are approximated as the bounds of the transition probability from the state with no packet loss to the state with consecutive single packet loss. The simulation results show that the MAP performance of $\left(64,16\right)$ polar code and 16-bit CRC coincides with the limiting upper bound as the SNR increases and has $3.0$dB performance gain compared with the normal approximation of the finite block rate at block error rate $10^{-3}$.

cs.IT↗

arXiv2026

Microscopic Description of Rotational Nuclear Fission Elucidates Fragment Spin Generation and Scission Mechanism

The generation of fission fragment spin as a probe of scission mechanism remains a question of considerable interests. We present here microscopic calculations of rapidly rotating fission of the compound nucleus 240Pu under varying initial conditions within the time-dependent density functional theory framework. The obtained spin ratio of light to heavy nascent fragments is unchanged up to high spins but diminished as excitation energies increase, indicating sawtooth structures in fragment spins would fade away at high excitations rather than high angular momentum. Further analysis elucidates that the bending scission mode is predominated at low excitation energies, which has been under intense debates. Results also show thicker and elongated neck configurations, along with scission nucleons emitted perpendicular to the fission axis, owing to rapid rotations. These findings offer insights into the scission mechanism of rotating compound nuclei that have usually been overlooked in earlier studies.

nucl-th↗

arXiv2025

Iterative Joint Detection of Kalman Filter and Channel Decoder for Sensor-to-Controller Link in Wireless Networked Control Systems

In this letter, we propose an iterative joint detection algorithm of Kalman filter (KF) and channel decoder for the sensor-to-controller link of wireless networked control systems, which utilizes the prior information of control system to improve control and communication performance. In this algorithm, we first use the KF to estimate the probability density of the control system outputs and calculate the prior probability of received signals to assist decoder. Then, the possible outputs of the control system are traversed to update the prior probability in order to implement iterative detection. The simulation results show that the prior information and the iterative structure can reduce the block error rate performance of communications while improving the root mean square error performance of controls.

cs.IT↗

arXiv2025

Heterogeneous-free narrow linewidth semiconductor laser with optical injection locking

Narrow linewidth lasers are indispensable for coherent optical systems, including communications, metrology, and sensing. Although compact semiconductor lasers with narrow linewidths and low noise have been demonstrated, their spectral purity typically relies on hybrid or heterogeneous external cavity feedback. Here, we present a theoretical and experimental demonstration of a heterogeneous free optical injection locking (HF OIL) semiconductor laser. By integrating a topological interface state extended (TISE) laser with a micro ring resonator (MRR) on an AlGaInAs multiple quantum well platform,we achieve monolithic photon injection and phase locking, thereby reducing the optical linewidth. We fabricated and characterized a 1550 nm sidewall HF OIL laser, achieving stable single mode operation over a broad current range (65 to 300 mA) and a side mode suppression ratio (SMSR) over 50 dB. Under injection locking, the devices Voigt fitted linewidth narrowed from over 1.7 MHz (free running) to 4.2 kHz, representing a three order of magnitude improvement over conventional distributed feedback lasers. The intrinsic linewidth of 1.4 kHz is measured by correlated delayed self-heterodyne frequency noise power spectrum density (FN PSD) method. Moreover, the HF OIL laser demonstrated high phase stability and the ability to transition from a random phased to a phase locked state. These results underscore the potential of HF-OIL lasers in advancing coherent optical communications and phase encoders in quantum key distribution (QKD) systems.

physics.optics↗

arXiv2024

Fast square-oscillations in semiconductor VCSELs with delayed orthogonal polarization feedback

We present an experimental investigation into the generation of self-sustained and fast square oscillations from the TE mode of semiconductor VCSELs with delayed orthogonal polarization feedback. We find that the low frequency switching originates from the rotation of the TE and TM modes facilitated by a long time delay, but the fast oscillations are anchored to the frequency beating between the TE and TM modes and are modified by a half-wavelength ($\lambda/2$) plate. A comprehensive analysis of the evolution of the nonlinear dynamics is conducted and the related mechanism is discussed. Our study not only deepens our comprehension of laser nonlinear dynamics but also offers an all-optical approach for producing specialized signals, which could be instrumental in applications such as optical communications and photonic computing leveraging the complexity of long-delay systems.

physics.optics↗

arXiv2024

Multi-Wavelength DFB Laser Based on Sidewall Third Order Four Phase-Shifted Sampled Bragg Grating with Uniform Wavelength Spacing

We present the first demonstration of a 1550 nm multi-wavelength distributed feedback (MW-DFB) laser employing a third-order, four-phase-shifted sampled sidewall grating. By utilizing linearly chirped sampled gratings and incorporating multiple true {\pi}-phase shifts within the cavity, we achieved and experimentally validated a four-wavelength laser with a channel spacing of 0.4 nm. The device operates stably and uniformly across a wide range of injection currents from 280 mA to 350 mA. The average wavelength spacing was measured at 0.401 nm with a standard deviation of 0.0081 nm. Additionally, we demonstrated a 0.3 nm MW-DFB laser with a seven-channel output, achieving a wavelength spacing of 0.274 nm and a standard deviation of 0.0055 nm. This MW-DFB laser features a ridge waveguide with sidewall gratings, requiring only one metalorganic vapor-phase epitaxy (MOVPE) step and a single III-V material etching process. This streamlined fabrication approach simplifies device manufacturing and is well-suited for dense wavelength division multiplexing (DWDM) systems.

physics.optics↗

arXiv2024

Narrow Linewidth Laser Based on Extended Topological Interface States in One-Dimensional Photonic Crystals

Recent advances in topological one-dimensional photonic crystal concepts have enabled the development of robust light-emitting devices by incorporating a topological interface state (TIS) at the cavity center. In this study, we theoretically and experimentally demonstrate a one-dimensional TIS-extended photonic crystal (1D-TISE-PC) structure. By integrating a linearly dispersive zero-index one-dimensional photonic crystal structure with a four-phase shift sampled grating, photons propagate along the cavity without phase differences, enhancing the robustness to material variations and extending the TIS. Our findings indicate that extending the TIS promotes a more uniform photon distribution along the laser cavity and mitigates the spatial hole burning (SHB) effect. We fabricated and characterized a 1550 nm sidewall 1D-TISE-PC semiconductor laser, achieving stable single-mode operation across a wide current range from 60 to 420 mA, with a side-mode suppression ratio of 50 dB. The 1D-TISE-PC structure exhibited a linewidth narrowing effect to approximately 150 kHz Lorentzian linewidth. Utilizing reconstruction equivalent-chirp technology for the 4PS sampled grating enabled precise wavelength control in 1D-TISE-PC laser arrays, achieving a wavelength spacing of 0.796 nm +- 0.003 nm. We show that the TIS still exists in the TISE cavity and topological protection is preserved. Its mode extension characteristics mitigate the SHB so narrows the linewidth. We argue that the design simplicity and improvement of the fabrication tolerance make this architecture suitable for high-power and narrow-linewidth semiconductor lasers development.

physics.optics↗

arXiv2024

NTIRE 2024 Challenge on Short-form UGC Video Quality Assessment: Methods and Results

This paper reviews the NTIRE 2024 Challenge on Shortform UGC Video Quality Assessment (S-UGC VQA), where various excellent solutions are submitted and evaluated on the collected dataset KVQ from popular short-form video platform, i.e., Kuaishou/Kwai Platform. The KVQ database is divided into three parts, including 2926 videos for training, 420 videos for validation, and 854 videos for testing. The purpose is to build new benchmarks and advance the development of S-UGC VQA. The competition had 200 participants and 13 teams submitted valid solutions for the final testing phase. The proposed solutions achieved state-of-the-art performances for S-UGC VQA. The project can be found at https://github.com/lixinustc/KVQChallenge-CVPR-NTIRE2024.

eess.IV↗

arXiv2023

Dynamics of rigid fibers interacting with triangular obstacles in microchannel flows

Fiber suspensions flowing in structured media are encountered in many biological and industrial systems. Interactions between fibers and the transporting flow as well as fiber contact with obstacles can lead to complex dynamics. In this work, we combine microfluidic experiments and numerical simulations to study the interactions of a rigid fiber with an individual equilateral triangular pillar in a microfluidic channel. Four dominant fiber dynamics are identified: transport above or below the obstacle, pole vaulting and trapping, in excellent agreement between experiments and modeling. The dynamics are classified as a function of the length, angle and lateral position of the fibers at the channel entry. We show that the orientation and lateral position close to the obstacle are responsible for the fiber dynamics and we link those to the initial conditions of the fibers at the channel entrance. Direct contact between the fibers and the pillar is required to obtain strong modification of the fiber trajectories, which is associated to irreversible dynamics. Longer fibers are found to be more laterally shifted by the pillar than shorter fibers that rather tend to remain on their initial streamline. Our findings could in the future be used to design and optimize microfluidic sorting devices to sort rigid fibers by length.

physics.flu-dyn↗

arXiv2023

Performance Analysis for Polar Codes under Successive Cancellation List Decoding with Fixed List Size

In this paper, we first indicate that the block error event of polar codes under successive cancellation list (SCL) decoding is composed of path loss (PL) error event and path selection (PS) error event, where the PL error event is that correct codeword is lost during the SCL decoding and the PS error event is that correct codeword is reserved in the decoded list but not selected as the decoded codeword. Then, we simplify the PL error event by assuming the all-zero codeword is transmitted and derive the probability lower bound via the joint probability density of the log-likelihood ratios of information bits. Meanwhile, the union bound calculated by the minimum weight distribution is used to evaluate the probability of the PS error event. With the performance analysis, we design a greedy bit-swapping (BS) algorithm to construct polar codes by gradually swapping information bit and frozen bit to reduce the performance lower bound of SCL decoding. The simulation results show that the BLER performance of SCL decoding is close to the lower bound in the medium to high signal-to-noise ratio region and we can optimize the lower bound to improve the BLER performance of SCL decoding by the BS algorithm.

cs.IT↗

arXiv2023

Construction Methods Based on Minimum Weight Distribution for Polar Codes with Successive Cancellation List Decoding

Minimum weight distribution (MWD) is an important metric to calculate the first term of union bound called minimum weight union bound (MWUB). In this paper, we first prove the maximum likelihood (ML) performance approaches MWUB as signal-to-noise ratio (SNR) goes to infinity and provide the deviation when MWD and SNR are given. Then, we propose a nested reliability sequence, namely MWD sequence, to construct polar codes independently of channel information. In the sequence, synthetic channels are sorted by partial MWD which is used to evaluate the influence of information bit on MWD and we prove the MWD sequence is the optimum sequence evaluated by MWUB for polar codes obeying partial order. Finally, we introduce an entropy constraint to establish a relationship between list size and MWUB and propose a heuristic construction method named entropy constraint bit-swapping (ECBS) algorithm, where we initialize information set by the MWD sequence and gradually swap information bit and frozen bit to satisfy the entropy constraint. The simulation results show the MWD sequence is more suitable for constructing polar codes with short code length than the polar sequence in 5G and the ECBS algorithm can improve MWD to show better performance as list size increases.

cs.IT↗

arXiv2022

Photonic integration of lithium niobate micro-ring resonators onto silicon nitride waveguide chips by transfer-printing

The heterogeneous integration of lithium niobate photonic waveguide devices onto a silicon nitride waveguide platform via a transfer-printing approach has been demonstrated for the first time. A fabrication process was developed to make free-standing lithium niobate membrane devices compatible with back-end integration onto photonic integrated circuits. Micro-ring resonators in membrane format were lithographically defined by using laser direct writing and plasma dry etching. The lithium niobate micro-ring resonators were then transferred from their host substrate and released onto a silicon nitride waveguide chip. An all-pass ring resonator transmission spectrum was obtained in the 1.5 μm to 1.6 μm wavelength range, with a measured loaded Q-factor larger than 32000.

physics.optics↗