SearcharxivSearch

arXiv · 1810.03803

A simple scheme of low phase noise microwave synthesizers based on the sub-sampling phase lock loop

Abstract

In this paper, we demonstrate a simple scheme of 6.835 GHz microwave frequency synthesizer based on the sub-sampling phase lock loop (PLL) technique. The application of the sub-sampling PLL is the key to simplify the architecture of the synthesizer in this scheme. A 100 MHz oven controlled crystal oscillator (OCXO) with ultra-low phase noise is used as the initial signal source. Then a dielectric resonant oscillator (DRO) of 6.8 GHz is directly phase locked to the 100 MHz OCXO utilizing the sub-sampling PLL. Benefiting from the sub-sampling PLL, the processes of microwave frequency multiplication and phase lock which are necessary in the development of microwave synthesizer are greatly simplified. Therefore, the architecture of the synthesizer is very simple. Correspondingly, the power consumption and cost of the synthesizer are low. The absolute phase noises of the 6.835 GHz output signal are measured to be -47 dBc/Hz, -77 dBc/Hz, -104 dBc/Hz and -121 dBc/Hz at 1 Hz, 10 Hz, 100 Hz and 1 kHz offset frequencies, respectively. he synthesizer can be used as the local oscillator of the Rb atomic clocks. For the Rb atomic clocks operated in the continuous or pulsed optically pumped (POP) mode, Tthe short-term frequency stability limited by the absolute phase noises of the synthesizer through the intermodulation or the Dick effect is theoretically calculated to be better than 5.0E10^-14/t^1/2. This low phase noise microwave frequency synthesizer can be used in other experiments of fundamental physics measurement.

Explore related subjects

Keep this discovery

BibTeXRIS

Wenbing Li, Qiang Hao, Yuanbo Du, Shaoqing Huang, Peter Yun, Zehuang Lu. 2018-10-09. A simple scheme of low phase noise microwave synthesizers based on the sub-sampling phase lock loop. https://doi.org/10.1088/0256-307x%2F36%2F7%2F070601

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Delay-engineered dynamical phases in a programmable non-Markovian spin oscillator

Non-Markovian dynamics offer a new route towards engineering non-equilibrium matter, where memory and feedback act as programmable resources for controlling order in time. Here we report the realization of a non-Markovian spin oscillator in a hot vapour $^{129}$Xe-Cs co-magnetometer with programmable feedback delay and gain. By tuning these parameters, we observe a hierarchy of dynamical phases, including time-crystalline response, nonlinear bifurcations, and frequency-comb formation. The measured spectra and phase boundaries are captured by linear stability analysis of delayed Bloch equations, revealing these phenomena as different manifestations of the same memory-induced instability structure. These results establish time-delayed feedback as a powerful strategy for controlling non-equilibrium phases, enabling quantum sensing, frequency referencing, and synchronization within a single spin-based platform.

physics.atom-ph

Non-stick vacuum wall collisions with a laser-coolable molecule

Molecular species that are suitable for direct laser cooling are typically considered lost or destroyed if they collide with an ambient temperature vacuum wall. Here, we study surface collisions with aluminum monofluoride (AlF), a laser-coolable molecule that survives this process with unusually high probability. We detect the outgoing AlF molecules from a single wall collision via Doppler-sensitive laser-induced fluorescence spectroscopy, using incoming supersonic (pulsed) and thermochemical (continuous) molecular beams. The angular, velocity and rovibrational level distributions of the outgoing molecules show near-complete thermalisation to the wall in a single collision event. We determine an upper limit to the surface residence time of about 5$~\mu$s, and by monitoring the decay in density of pulses of molecules loaded into a small storage volume, we deduce the surface sticking probability for different materials. For a siloxane-coated metallic surface, the sticking probability of AlF is about 0.015, allowing us to accumulate molecules from the thermochemical source into an ambient temperature storage vessel at densities near $10^{8}~$cm$^{-3}$. This provides a route to compact, portable traps for neutral molecules.

physics.atom-ph

Kinetic modeling of molecular beam formation in a cryogenic buffer-gas cell

Cryogenic buffer-gas cells are widely used to produce cold molecular beams, but the microscopic dynamics governing beam formation remain challenging to model. Here we present fully kinetic simulations of a cryogenic buffer-gas cell using the Direct Simulation Monte Carlo method implemented in the PICLas framework, treating the buffer gas and ablated molecules within a single unified model. We capture characteristic features of cryogenic buffer-gas sources, including plume cooling, directed transport toward the aperture, and the formation of a slow molecular beam, while also resolving energy transfer from the hot ablation plume to the helium buffer gas that is inaccessible to existing approaches relying on the background-gas approximation. Our results demonstrate that fully kinetic simulations can provide detailed insights into buffer-gas cell dynamics and open a route toward a systematic optimization of such sources.

physics.atom-ph