SearcharxivSearch

arXiv · 2501.10964

The energy dependence of cluster size and its physical processes in the proton measurement with TimePix3 silicon detector

Abstract

We investigated the energy dependence of the number of triggered pixels, or cluster size, when charged particles are detected using the TimePix3 detector with a silicon sensor. We measured protons in the range of 1.5~3.3 MeV from a Pelletron accelerator at RIKEN using a TimePix3 detector with a 500 um-thick silicon sensor. We determined from the experimental results a cluster size comprised between 30 and 80 pixels. To understand the physical process that produces large cluster images and its energy dependence, we simulated the charge carrier drifts in the sensor, assuming the incidence of a proton in the detector. The cluster sizes estimated in the simulation were smaller than those observed in the experiment, and remained constant across the entire energy range, when thermal diffusion and charge carriers self-repulsion were considered as the factors of the cluster image formation. In addition, we discovered that the size of the cluster image and its energy dependence observed in the experiment could be well explained when considering that the TimePix3 detector is sensitive to the transient induced charges, allowing even pixels that do not collect the charge carriers to trigger. We conclude that the cluster size measurement is a promising method for evaluating the energy deposited by a charged particle in the TimePix3 detector.

Explore related subjects

Keep this discovery

BibTeXRIS

Naoki Itoh, Hugo Allaire, Tokihiro Ikeda, Shunsaku Nagasawa, Shinji Okada, Tadayuki Takahashi, Aiko Takamine, Yuichi Toyama, Yuusuke Uchida, Hideki Ueno. 2025-01-19. The energy dependence of cluster size and its physical processes in the proton measurement with TimePix3 silicon detector. https://arxiv.org/abs/2501.10964

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det