Searcharxiv⌕ Search
Home/Archive/arXiv

arXiv · 2503.02588

High-frequency magnetic response measurement of test mass with a fluxgate magnetometer for gravitational wave detection

Yuanyang Yu·Butian Zhang·Shengxin Lin·Jianping Liang·Donghua Pan·Shun Wang·Ze-Bing Zhou
View original source ↗Read source document ↗Export metadata ↓

Abstract

For space-borne gravitational wave detectors,such as LISA and TianQin ,the disturbance caused by the coupling of test masses and the external magnetic fields is one of the main sources of the residual acceleration noise. Although the detection frequency band is from 0.1 mHz to 1 Hz, magnetic fields with frequencies higher than 1 Hz can still contribute to the noise through down conversion effect. Therefore, it is necessary to measure the AC magnetic susceptibility or magnetic response of the test mass at higher frequency for the evaluation of the magnetic noise. In this work, we propose a magnetic field response measurement method by directly probing the induced magnetic field of the test mass placed in a spatially uniform magnetic field. The frequency can be measured up to 1500 Hz, satisfying the requirement of space-borne gravitational wave detection.

Explore related subjects

physics.ins-detastro-ph.IMgr-qcphysics.app-ph

Keep this discovery

BibTeXRIS

Yuanyang Yu, Butian Zhang, Shengxin Lin, Jianping Liang, Donghua Pan, Shun Wang, Ze-Bing Zhou. 2025-03-04. High-frequency magnetic response measurement of test mass with a fluxgate magnetometer for gravitational wave detection. https://arxiv.org/abs/2503.02588

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

arXiv2026

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det↗
arXiv2026

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det↗
arXiv2026

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det↗