arXiv subjects

Adrian Bachtold

Publications and source records attributed to Adrian Bachtold.

31 records · Page 2Linked to original sources

arXiv2015

Electro-mechanical control of an optical emitter using graphene

Active, in situ control of light at the nanoscale remains a challenge in modern physics and in nanophotonics in particular. A promising approach is to take advantage of the technological maturity of nano-electromechanical systems (NEMS) and to combine it with on-chip optics. However, in scaling down the dimensions of such integrated devices, the coupling of a NEMS to optical fields becomes challenging. Despite recent progress in nano-optomechanical coupling, active control of optical fields at the nanoscale has not been achieved with an on-chip NEMS thus far. Here, we show a new type of hybrid system, which consists of an on-chip graphene NEMS suspended a few tens of nanometers above nitrogen-vacancy centres (NVC), which are stable single photon emitters embedded in nano-diamonds. Electromechanical control of the photons emitted by the NVC is provided by electrostatic tuning of the graphene NEMS position, which is transduced to a modulation of NVC emission intensity. The optomechanical coupling between the graphene displacement and the NVC emission is based on near-field dipole-dipole interaction. This class of optomechanical coupling increases strongly for smaller distances, making it suitable for devices with nanoscale dimensions. These achievements hold promise for the selective control of single-emitter arrays on chip, optical spectroscopy of individual nano-objects, integrated optomechanical information processing and quantum optomechanics.

cond-mat.mes-hall↗

arXiv2015

Nanotube mechanical resonators with quality factors of up to 5 million

Carbon nanotube mechanical resonators have attracted considerable interest because of their small mass, the high quality of their surface, and the pristine electronic states they host. However, their small dimensions result in fragile vibrational states that are difficult to measure. Here we observe quality factors $Q$ as high as $5\times10^6$ in ultra-clean nanotube resonators at a cryostat temperature of 30 mK, where we define $Q$ as the ratio of the resonant frequency over the linewidth. Measuring such high quality factors requires both employing an ultra-low noise method to detect minuscule vibrations rapidly, and carefully reducing the noise of the electrostatic environment. We observe that the measured quality factors fluctuate because of fluctuations of the resonant frequency. The quality factors we measure are record high; they are comparable to the highest $Q$ reported in mechanical resonators of much larger size, a remarkable result considering that reducing the size of resonators is usually concomitant with decreasing quality factors. The combination of ultra-low size and very large $Q$ offers new opportunities for ultra-sensitive detection schemes and quantum optomechanical experiments.

cond-mat.mes-hall↗

arXiv2014

Sequential tasks performed by catalytic pumps for colloidal crystallization

Gold-platinum catalytic pumps immersed in a chemical fuel are used to manipulate silica colloids. The manipulation relies on the electric field and the fluid flow generated by the pump. Catalytic pumps perform various tasks, such as the repulsion of colloids, the attraction of colloids, and the guided crystallization of colloids. We demonstrate that catalytic pumps can execute these tasks sequentially over time. Switching from one task to the next is related to the local change of the proton concentration, which modifies the colloid zeta potential and consequently the electric force acting on the colloids.

cond-mat.soft↗

arXiv2014

Harnessing vacuum forces for quantum sensing of graphene motion

Position measurements at the quantum level are vital for many applications, but also challenging. Typically, methods based on optical phase shifts are used, but these methods are often weak and difficult to apply to many materials. An important example is graphene, which is an excellent mechanical resonator due to its small mass and an outstanding platform for nanotechnologies, but is largely transparent. Here, we present a novel detection scheme based upon the strong, dispersive vacuum interactions between a graphene sheet and a quantum emitter. In particular, the mechanical displacement causes strong changes in the vacuum-induced shifts of the transition frequency of the emitter, which can be read out via optical fields. We show that this enables strong quantum squeezing of the graphene position on time scales short compared to the mechanical period.

quant-ph↗

arXiv2014

Atomic monolayer deposition on the surface of nanotube mechanical resonators

We studied monolayers of noble gas atoms (Xe, Kr, Ar, and Ne) deposited on individual ultra- clean suspended nanotubes. For this, we recorded the resonance frequency of the mechanical motion of the nanotube, since it provides a direct measure of the coverage. The latter is the number of adsorbed atoms divided by the number of the carbon atoms of the suspended nanotube. Monolayers formed when the temperature was lowered in a constant pressure of noble gas atoms. The coverage of Xe monolayers remained constant at 1/6 over a large temperature range. This finding reveals that Xe monolayers are solid phases with a triangular atomic arrangement, and are commensurate with the underlying carbon nanotube. By comparing our measurements to theoretical calculations, we identify the phases of Ar and Ne monolayers as fluids, and we tentatively describe Kr monolayers as solid phases. These results underscore that mechanical resonators made from single nanotubes are excellent probes for surface science.

cond-mat.mes-hall↗

arXiv2012

Parametric amplification and self-oscillation in a nanotube mechanical resonator

A hallmark of mechanical resonators made from a single nanotube is that the resonance frequency can be widely tuned. Here, we take advantage of this property to realize parametric amplification and self-oscillation. The gain of the parametric amplification can be as high as 18.2 dB and tends to saturate at high parametric pumping due to nonlinear damping. These measurements allow us to determine the coefficient of the linear damping force. The corresponding damping rate is lower than the one obtained from the lineshape of the resonance (without pumping), supporting the recently reported scenario that describes damping in nanotube resonators by a nonlinear force. The possibility to combine nanotube resonant mechanics and parametric amplification holds promise for future ultra-low force sensing experiments.

cond-mat.mes-hall↗

arXiv2010

Ground-state cooling the vibrations of suspended carbon-nanotubes with constant electron current

We investigate the efficiency of cooling the vibrations of a nano-mechanical resonator, constituted by a partially suspended Carbon-nanotube and operating as double-quantum dot. The motion is brought to lower temperatures by tailoring the energy exchange via electromechanical coupling with single electrons, constantly flowing through the nanotube when a constant potential difference is applied at its extremes in the Coulomb-blockade regime. Ground-state cooling is possible at sufficiently high quality factors, provided that the dephasing rate of electron transport within the double dot does not exceed the resonator frequency. For large values of the dephasing rates cooling can still be achieved by appropriately setting the tunable parameters.

cond-mat.mes-hall↗

arXiv2010

Current-voltage characteristics of graphene devices: interplay between Zener-Klein tunneling and defects

We report a theoretical/experimental study of current-voltage characteristics (I-V) of graphene devices near the Dirac point. The I-V can be described by a power law (I \propto V^α, with 1< α<= 1.5). The exponent is higher when the mobility is lower. This superlinear I-V is interpreted in terms of the interplay between Zener-Klein transport, that is tunneling between different energy bands, and defect scattering. Surprisingly, the Zener-Klein tunneling is made visible by the presence of defects.

cond-mat.mtrl-sci↗

arXiv2009

Fabrication of large addition energy quantum dots in graphene

We present a simple technique to fabricate graphene quantum dots in a cryostat. It relies upon the controlled rupture of a suspended graphene sheet subjected to the application of a large electron current. This results in the in-situ formation of a clean and ultra-narrow constriction, which hosts one quantum dot, and occasionally a few quantum dots in series. Conductance spectroscopy indicates that individual quantum dots can possess an addition energy as large as 180 meV and a level spacing as large as 25 meV. Our technique has several assets: (i) the dot is suspended, thus the electrostatic influence of the substrate is reduced, and (ii) contamination is minimized, since the edges of the dot have only been exposed to the vacuum in the cryostat.

cond-mat.mes-hall↗

arXiv2009

Transport properties of graphene in the high-current limit

We present a detailed study of the high-current transport properties of graphene devices patterned in a four-point configuration. The current tends to saturate as the voltage across graphene is increased but never reaches the complete saturation as in metallic nanotubes. Measurements are compared to a model based on the Boltzmann equation, which includes electron scattering processes due to charged and neutral impurities, and graphene optical-phonons. The saturation is incomplete because of the competition between disorder and optical-phonon scattering.

cond-mat.mes-hall↗

arXiv2009

Thermal Probing of Energy Dissipation in Current-Carrying Carbon Nanotubes

The temperature distributions in current-carrying carbon nanotubes have been measured with a scanning thermal microscope. The obtained temperature profiles reveal diffusive and dissipative electron transport in multi-walled nanotubes and in single-walled nanotubes when the voltage bias was higher than the 0.1-0.2 eV optical phonon energy. Over ninety percent of the Joule heat in a multi-walled nanotube was found to be conducted along the nanotube to the two metal contacts. In comparison, about eighty percent of the Joule heat was transferred directly across the nanotube-substrate interface for single-walled nanotubes. The average temperature rise in the nanotubes is determined to be in the range of 5 to 42 K per micro watt Joule heat dissipation in the nanotubes.

cond-mat.mes-hall↗

arXiv2009

Cooling carbon nanotubes to the phononic ground state with constant electron current

We present a quantum theory of cooling of a mechanical resonator using back-action with constant electron current. The resonator device is based on a doubly clamped nanotube, which mechanically vibrates and acts as a double quantum dot for electron transport. Mechanical vibrations and electrons are coupled electrostatically using an external gate. The fundamental eigenmode is cooled by absorbing phonons when electrons tunnel through the double quantum dot. We identify the regimes in which ground state cooling can be achieved for realistic experimental parameters.

cond-mat.other↗

arXiv2002

Transport through the Interface between a Semiconducting Carbon Nanotube and a Metal Electrode

We report a numerical study of the tunnel conductance through the Schottky barrier at the contact between a semiconducting carbon nanotube and a metal electrode. In a planar gate model the asymmetry between the p--doped and the n--doped region is shown to depend mainly on the difference between the electrode Fermi level and the band gap of carbon nanotubes. We quantitatively show how the gate/nanotube distance is important to get large on--off ratios. We explain the bend of the current versus gate voltage as the transition from a thermal--activation region to a tunneling region. A good agreement is obtained with experimental results for carbon nanotubes field--effect transistors.

cond-mat.mes-hall↗