arXiv subjects

Ani Nersisyan

Publications and source records attributed to Ani Nersisyan.

10 recordsLinked to original sources

arXiv2025

On the electromagnetic couplings in superconducting qubit circuits

The precise engineering of electromagnetic couplings is paramount for constructing scalable and highfidelity superconducting quantum processors. While essential for orchestrating qubit operations, these couplings also present significant design challenges, including the mitigation of crosstalk and the management of environmental decoherence. A clear and unified theoretical framework is therefore crucial for the design, simulation, and analysis of these complex quantum circuits. This paper presents a comprehensive theoretical treatment of the fundamental electromagnetic coupling mechanisms in superconducting devices. Starting from first principles, we formulate the equations of motion and derive the input-output relations for canonical systems, including a single resonator coupled to a multi-port microwave network, interacting resonators, and coupled transmission lines. We review rigorous definitions for key parameters such as the energy decay rate (\k{appa}) and the dimensionless coupling coefficient (ζ) and connect these formalisms to practical methods of parameter extraction from electromagnetic simulations. This work provides a rigorous and pedagogical foundation for understanding and modeling linear electromagnetic interactions, serving as a vital resource for the development of advanced superconducting quantum hardware.

quant-ph↗

arXiv2023

Measurement of small photon numbers in circuit QED resonators

Off-resonant interaction of fluctuating photons in a resonator with a qubit increases the qubit dephasing rate. We use this effect to measure a small average number of intracavity photons that are coherently or thermally driven. For spectral resolution, we do this by subjecting the qubit to a Carr-Purcell-Meiboom-Gill (CPMG) sequence and record the qubit dephasing rate for various periods between qubit $π$-pulses. The recorded data is then analyzed with formulas for the photon-induced dephasing rate that we have derived for the non-Gaussian noise regime with an arbitrary ratio $2χ/κ$, where $2χ$ is the qubit frequency shift due to a single photon and $κ$ is the resonator decay rate. We show that the presented CPMG dephasing rate formulas agree well with experimental results and demonstrate measurement of thermal and coherent photon populations at the level of a few $10^{-4}$.

quant-ph↗

arXiv2022

Readout of a quantum processor with high dynamic range Josephson parametric amplifiers

We demonstrate a high dynamic range Josephson parametric amplifier (JPA) in which the active nonlinear element is implemented using an array of rf-SQUIDs. The device is matched to the 50 $Ω$ environment with a Klopfenstein-taper impedance transformer and achieves a bandwidth of 250-300 MHz, with input saturation powers up to -95 dBm at 20 dB gain. A 54-qubit Sycamore processor was used to benchmark these devices, providing a calibration for readout power, an estimate of amplifier added noise, and a platform for comparison against standard impedance matched parametric amplifiers with a single dc-SQUID. We find that the high power rf-SQUID array design has no adverse effect on system noise, readout fidelity, or qubit dephasing, and we estimate an upper bound on amplifier added noise at 1.6 times the quantum limit. Lastly, amplifiers with this design show no degradation in readout fidelity due to gain compression, which can occur in multi-tone multiplexed readout with traditional JPAs.

quant-ph↗

arXiv2022

Overcoming leakage in scalable quantum error correction

Leakage of quantum information out of computational states into higher energy states represents a major challenge in the pursuit of quantum error correction (QEC). In a QEC circuit, leakage builds over time and spreads through multi-qubit interactions. This leads to correlated errors that degrade the exponential suppression of logical error with scale, challenging the feasibility of QEC as a path towards fault-tolerant quantum computation. Here, we demonstrate the execution of a distance-3 surface code and distance-21 bit-flip code on a Sycamore quantum processor where leakage is removed from all qubits in each cycle. This shortens the lifetime of leakage and curtails its ability to spread and induce correlated errors. We report a ten-fold reduction in steady-state leakage population on the data qubits encoding the logical state and an average leakage population of less than $1 \times 10^{-3}$ throughout the entire device. The leakage removal process itself efficiently returns leakage population back to the computational basis, and adding it to a code circuit prevents leakage from inducing correlated error across cycles, restoring a fundamental assumption of QEC. With this demonstration that leakage can be contained, we resolve a key challenge for practical QEC at scale.

quant-ph↗

arXiv2022

Simple coplanar waveguide resonator mask targeting metal-substrate interface

This white paper presents a single-layer mask, found at https://github.com/Boulder-Cryogenic-Quantum-Testbed/simple-resonator-mask. It is designed for fabrication of superconducting microwave resonators towards 1:1 comparisons of dielectric losses from the metal-substrate interface. Finite-element electromagnetic simulations are used to determine participation ratios of the four major regions of the on-chip devices, as well as to confirm lack of crosstalk between neighboring devices and demonstrate coupling tunability over three orders of magnitude. This mask is intended as an open-source community resource for facilitating precise and accurate comparisons of materials in the single-photon, millikelvin regime.

quant-ph↗

arXiv2021

Entanglement Across Separate Silicon Dies in a Modular Superconducting Qubit Device

Assembling future large-scale quantum computers out of smaller, specialized modules promises to simplify a number of formidable science and engineering challenges. One of the primary challenges in developing a modular architecture is in engineering high fidelity, low-latency quantum interconnects between modules. Here we demonstrate a modular solid state architecture with deterministic inter-module coupling between four physically separate, interchangeable superconducting qubit integrated circuits, achieving two-qubit gate fidelities as high as 99.1$\pm0.5$\% and 98.3$\pm$0.3\% for iSWAP and CZ entangling gates, respectively. The quality of the inter-module entanglement is further confirmed by a demonstration of Bell-inequality violation for disjoint pairs of entangled qubits across the four separate silicon dies. Having proven out the fundamental building blocks, this work provides the technological foundations for a modular quantum processor: technology which will accelerate near-term experimental efforts and open up new paths to the fault-tolerant era for solid state qubit architectures.

quant-ph↗

arXiv2019

Realization of a Carbon-Nanotube-Based Superconducting Qubit

Hybrid circuit quantum electrodynamics (QED) involves the study of coherent quantum physics in solid state systems via their interactions with superconducting microwave circuits. Here we present an implementation of a hybrid superconducting qubit that employs a carbon nanotube as a Josephson junction. We realize the junction by contacting a carbon nanotube with a superconducting Pd/Al bi-layer, and implement voltage tunability of the qubit frequency using a local electrostatic gate. We demonstrate strong dispersive coupling to a coplanar waveguide resonator via observation of a resonator frequency shift dependent on applied gate voltage. We extract qubit parameters from spectroscopy using dispersive readout and find qubit relaxation and coherence times in the range of $10-200~\rm{ns}$.

quant-ph↗

arXiv2019

Manufacturing low dissipation superconducting quantum processors

Enabling applications for solid state quantum technology will require systematically reducing noise, particularly dissipation, in these systems. Yet, when multiple decay channels are present in a system with similar weight, resolution to distinguish relatively small changes is necessary to infer improvements to noise levels. For superconducting qubits, uncontrolled variation of nominal performance makes obtaining such resolution challenging. Here, we approach this problem by investigating specific combinations of previously reported fabrication techniques on the quality of 242 thin film superconducting resonators and qubits. Our results quantify the influence of elementary processes on dissipation at key interfaces. We report that an end-to-end optimization of the manufacturing process that integrates multiple small improvements together can produce an average ${\overline{T}_{1}=76\pm13~μ}$s across 24 qubits with the best qubits having ${T_1\geq110~μ}$s. Moreover, our analysis places bounds on energy decay rates for three fabrication-related loss channels present in state-of-the-art superconducting qubits. Understanding dissipation through such systematic analysis may pave the way for lower noise solid state quantum computers.

quant-ph↗

arXiv2015

Surface acoustic wave devices on bulk ZnO at low temperature

Surface acoustic wave (SAW) devices based on thin films of ZnO are a well established technology. However, SAW devices on bulk ZnO crystals are not practical at room temperature due to the significant damping caused by finite electrical conductivity of the crystal. Here, by operating at low temperatures, we demonstrate effective SAW devices on the (0001) surface of bulk ZnO crystals, including a delay line operating at SAW wavelengths of λ = 4 and 6 μm and a one-port resonator at a wavelength of λ = 1.6 μm. We find that the SAW velocity is temperature dependent, reaching $v \simeq 2.68$ km/s at 10mK. Our resonator reaches a maximum quality factor of $Q_i \simeq 1.5\times 10^5$, demonstrating that bulk ZnO is highly viable for low temperature SAW applications. The performance of the devices is strongly correlated with the bulk conductivity, which quenches SAW transmission above about 200 K.

cond-mat.mtrl-sci↗

arXiv2013

Pattern Formation and Strong Nonlinear Interactions in Exciton-Polariton Condensates

Exciton-polaritons generated by light-induced potentials can spontaneously condense into macroscopic quantum states that display nontrivial spatial and temporal density modulation. While these patterns and their dynamics can be reproduced through the solution of the generalized Gross-Pitaevskii equation, a predictive theory of their thresholds, oscillation frequencies, and multi-pattern interactions has so far been lacking. Here we represent such an approach based on the linear non-Hermitian modes of the complex-valued light-induced potential. We provide a simple analytic expression for the lowest thresholds that is able to explain the modal patterns observed in recent experiments for various pump geometries. We also show that the evolution of the condensate with increasing pump strength is strongly geometry dependent and can display contrasting features such as enhancement or reduction of the spatial localization of the condensate.

cond-mat.mes-hall↗