arXiv subjects

Damien Vandembroucq

Publications and source records attributed to Damien Vandembroucq.

53 records · Page 3Linked to original sources

arXiv2006

Quantitative AFM analysis of phase separated borosilicate glass surfaces

Phase separated borosilicate glass samples were prepared by applying various heat treatments. Using selective chemical etching we performed AFM measurement on the phase separated glass surfaces. A quantitative roughness analysis allowed us to measure precisely the dependence of the characteristic size of the phase domains on heating time and temperature. The experimental measurements are very well described by the theoretically expected scaling laws. Interdiffusion coefficients and activation energy are estimated from this analysis and are consistent with literature data.

cond-mat.other↗

arXiv2006

Frozen capillary waves on glass surfaces: an AFM study

Using atomic force microscopy on silica and float glass surfaces, we give evidence that the roughness of melted glass surfaces can be quantitatively accounted for by frozen capillary waves. In this framework the height spatial correlations are shown to obey a logarithmic scaling law; the identification of this behaviour allows to estimate the ratio $kT\_F/πγ$ where $k$ is the Boltzmann constant, $γ$ the interface tension and $T\_F$ the temperature corresponding to the ``freezing'' of the capillary waves. Variations of interface tension and (to a lesser extent) temperatures of annealing treatments are shown to be directly measurable from a statistical analysis of the roughness spectrum of the glass surfaces.

cond-mat.other↗

arXiv2006

Raman microspectroscopic characterization of amorphous silica plastic behavior

Raman microspectroscopy was used to characterize amorphous silica plastic behavior. Using a correlation between Raman spectrum and density, a map of the local residual indentation-induced densification is obtained. The existence of a densification-induced hardening is also evidenced through a diamond anvil cell experiment. Such observations are not accounted for by the previously proposed hardening-free pressure-dependent yield criterion based on indentation curves. These results open the way to more accurate description of a constitutive law for amorphous silica.

cond-mat.other↗

arXiv2005

Laplacian transfer across a rough interface: Numerical resolution in the conformal plane

We use a conformal mapping technique to study the Laplacian transfer across a rough interface. Natural Dirichlet or Von Neumann boundary condition are simply read by the conformal map. Mixed boundary condition, albeit being more complex can be efficiently treated in the conformal plane. We show in particular that an expansion of the potential on a basis of evanescent waves in the conformal plane allows to write a well-conditioned 1D linear system. These general principle are illustrated by numerical results on rough interfaces.

cond-mat.other↗

arXiv2004

Light scattering from cold rolled aluminum surfaces

We present experimental light scattering measurements from aluminum surfaces obtained by cold rolling. We show that our results are consistent with a scale invariant description of the roughness of these surfaces. The roughness parameters that we obtain from the light scattering experiment are consistent with those obtained from Atomic Force Microscopy measurements.

cond-mat.other↗

arXiv2004

Material independent crack arrest statistics

The propagation of (planar) cracks in a heterogeneous brittle material characterized by a random field of toughness is considered, taking into account explicitly the effect of the crack front roughness on the local stress intensity factor. In the so-called strong-pinning regime, the onset of crack propagation appears to map onto a second-order phase transition characterized by universal critical exponents which are independent of the local characteristics of the medium. Propagation over large distances can be described by using a simple one-dimensional description, with a correlation length and an effective macroscopic toughness distribution that scale in a non-trivial fashion with the crack front length. As an application of the above concepts, the arrest of indentation cracks is addressed, and the analytical expression for the statistical distribution of the crack radius at arrest is derived. The analysis of indentation crack radii on alumina is shown to obey the predicted algebraic expression for the radius distribution and its dependence on the indentation load.

cond-mat.other↗

arXiv2004

Effective toughness of heterogeneous brittle materials

A heterogeneous brittle material characterized by a random field of local toughness Kc(x) can be represented by an equivalent homogeneous medium of toughness, Keff. Homogenization refers to a process of estimating Keff from the local field Kc(x). An approach based on a perturbative expansion of the stress intensity factor along a rough crack front shows the occurrence of different regimes depending on the correlation length of the local toughness field in the direction of crack propagation. A `"weak pinning" regime takes place for long correlation lengths, where the effective toughness is the average of the local toughness. For shorter correlation lengths, a transition to "strong pinning" occurs leading to a much higher effective toughness, and characterized by a propagation regime consisting in jumps between pinning configurations.

cond-mat.other↗

arXiv2004

Electromagnetic wave scattering from conducting self-affine surfaces : An analytic and numerical study

We derive an analytical expression for the scattering of a scalar wave from a perfectly conducting self-affine one dimensional surface in the framework of the Kirchhoff approximation. We show that most of the results can be recovered via a scaling analysis. We identify the typical slope taken over one wavelength as the relevant parameter controlling the scattering process. We compare our predictions with direct numerical simulations performed on surfaces of varying roughness parameters and confirm the broad range of applicability of our description up to very large roughness. Finally we check that a non zero electrical resistivity provided small does not invalidate our results.

cond-mat.other↗

arXiv2004

Conformal Mapping on Rough Boundaries II: Applications to bi-harmonic problems

We use a conformal mapping method introduced in a companion paper to study the properties of bi-harmonic fields in the vicinity of rough boundaries. We focus our analysis on two different situations where such bi-harmonic problems are encountered: a Stokes flow near a rough wall and the stress distribution on the rough interface of a material in uni-axial tension. We perform a complete numerical solution of these two-dimensional problems for any univalued rough surfaces. We present results for sinusoidal and self-affine surface whose slope can locally reach 2.5. Beyond the numerical solution we present perturbative solutions of these problems. We show in particular that at first order in roughness amplitude, the surface stress of a material in uni-axial tension can be directly obtained from the Hilbert transform of the local slope. In case of self-affine surfaces, we show that the stress distribution presents, for large stresses, a power law tail whose exponent continuously depends on the roughness amplitude.

cond-mat.other↗

arXiv2004

Conformal Mapping on Rough Boundaries I: Applications to harmonic problems

The aim of this study is to analyze the properties of harmonic fields in the vicinity of rough boundaries where either a constant potential or a zero flux is imposed, while a constant field is prescribed at an infinite distance from this boundary. We introduce a conformal mapping technique that is tailored to this problem in two dimensions. An efficient algorithm is introduced to compute the conformal map for arbitrarily chosen boundaries. Harmonic fields can then simply be read from the conformal map. We discuss applications to "equivalent" smooth interfaces. We study the correlations between the topography and the field at the surface. Finally we apply the conformal map to the computation of inhomogeneous harmonic fields such as the derivation of Green function for localized flux on the surface of a rough boundary.

cond-mat.other↗

arXiv2004

Large scale numerical simulations of "ultrametric" long-range depinning

The depinning of an elastic line interacting with a quenched disorder is studied for long range interactions, applicable to crack propagation or wetting. An ultrametric distance is introduced instead of the Euclidean distance, allowing for a drastic reduction of the numerical complexity of the problem. Based on large scale simulations, two to three orders of magnitude larger than previously considered, we obtain a very precise determination of critical exponents which are shown to be indistinguishable from their Euclidean metric counterparts. Moreover the scaling functions are shown to be unchanged. The choice of an ultrametric distance thus does not affect the universality class of the depinning transition and opens the way to an analytic real space renormalization group approach.

cond-mat.other↗

arXiv2003

Universal depinning force fluctuations of an elastic line: Application to finite temperature behavior

The depinning of an elastic line in a random medium is studied via an extremal model. The latter gives access to the instantaneous depinning force for each successive conformation of the line. Based on conditional statistics the universal and non-universal parts of the depinning force distribution can be obtained. In particular the singular behavior close to a (macroscopic) critical threshold is obtained as a function of the roughness exponent of the front. We show moreover that the advance of the front is controlled by a very tenuous set of subcritical sites. Extension of the extremal model to a finite temperature is proposed, the scaling properties of which can be discussed based on the statistics of depinning force at zero temperature.

cond-mat↗

arXiv2002

An extremal model for amorphous media plasticity

An extremal model for the plasticity of amorphous materials is studied in a simple two-dimensional anti-plane geometry. The steady-state is analyzed through numerical simulations. Long-range spatial and temporal correlations in local slip events are shown to develop, leading to non-trivial and highly anisotropic scaling laws. In particular, the plastic strain is shown to statistically concentrate over a region which tends to align perpendicular to the displacement gradient. By construction, the model can be seen as giving rise to a depinning transition, the threshold of which (i.e. the macroscopic yield stress) also reveal scaling properties reflecting the localization of the activity.

cond-mat.dis-nn↗

arXiv2002

Front propagation in random media: From extremal to activated dynamics

Front propagation in a random environment is studied close to the depinning threshold. At zero temperature we show that the depinning force distribution exhibits a universal behavior. This property is used to estimate the velocity of the front at very low temperature. We obtain a Arrhenius behavior with a prefactor depending on the temperature as a power law. These results are supported by numerical simulations.

cond-mat.dis-nn↗

arXiv1999

Wave scattering from self-affine surfaces

Electromagnetic wave scattering from a perfectly reflecting self-affine surface is considered. Within the framework of the Kirchhoff approximation, we show that the scattering cross section can be exactly written as a function of the scattering angle via a centered symmetric Levy distribution for general roughness amplitude, Hurst exponent and wavelength of the incident wave. The amplitude of the specular peak, its width and its position are discussed as well as the power law decrease (with scattering angle) of the scattering cross section.

cond-mat.stat-mech↗

arXiv1998

An optimal shell model of turbulence

We introduce a new shell model of turbulence which exhibits improved properties in comparison to the standard (and very popular) GOY model. The nonlinear coupling is chosen to minimize correlations between different shells. In particular the second order correlation function is diagonal in the shell index, the third order correlation exists only between three consecutive shells. Spurious oscillations in the scaling regime, which are an annoying feature of the GOY model, are eliminated by our choice of nonlinear coupling. We demonstrate that the model exhibits multi-scaling similarly to these GOY model. The scaling exponents are shown to be independent of the viscous mechanism as is expected for Navier-Stokes turbulence and other shell models. These properties of the new model make it optimal for further attempts to achieve understanding of multi-scaling in nonlinear dynamics.

chao-dyn↗

arXiv1998

Universal scaling exponents in shell models of turbulence: Viscous effects are finite-size corrections to scaling

In a series of recent works it was proposed that shell models of turbulence exhibit inertial range scaling exponents that depend on the nature of the dissipative mechanism. If true, and if one could imply a similar phenomenon to Navier-Stokes turbulence, this finding would cast strong doubts on the universality of scaling in turbulence. In this Letter we propose that these ``nonuniversalities'' are just corrections to scaling that disappear when the Reynolds number goes to infinity.

chao-dyn↗