arXiv subjects

G. Nieradka

Publications and source records attributed to G. Nieradka.

12 recordsLinked to original sources

arXiv2026

Measurement of the muon flux at SNOLAB using the DEAP-3600 experiment

A direct measurement of the muon flux at SNOLAB is performed using the DEAP-3600 experiment, located 2 km underground at SNOLAB near Sudbury, Canada. Primarily designed for the direct detection of weakly interacting massive particles (WIMPs), a dark matter candidate, DEAP-3600 consists of an inner spherical acrylic vessel containing a liquid argon target; this vessel is enclosed within a steel shell which is submerged in an instrumented water tank, serving as a muon veto for the dark matter search. The muon flux measurement is performed using a cut-and-count analysis of events observed in the muon veto detector and of events which are coincident between the muon veto and the liquid argon target. The requirement that muons traverse both the water and liquid argon minimizes instrumental backgrounds and systematic uncertainties. Using data collected from November 2016 to March 2020, the muon flux is measured by this coincidence analysis to be $(3.71 \pm 0.25_{\textrm{stat}} \pm 0.09_{\textrm{sys}}) \times 10^{-10}\, \mu/$cm$^2$/s. The standalone measurement using muon veto data only is compatible within uncertainties. Both measurements agree with the previous result by the SNO experiment and with simulations carried out using the MUTE software. These results provide an important benchmark for future rare-event searches at the SNOLAB facility.

hep-ex↗

arXiv2026

First evidence of neutrino absorption on argon using $^{8}$B solar neutrinos in DEAP-3600

We report experimental evidence for electron neutrino charged-current interactions (neutrino absorption, CC $\nu_e$) from $^{8}$B solar neutrinos on $^{40}$Ar using an exposure of ($7.29 \pm 0.05$) tonne$\cdot$years in the DEAP-3600 detector. A region of interest (ROI) of 10.5-13.0 MeV reconstructed energy calibrated on single-peak events, corresponding to incident neutrino energy in 12.0-14.5 MeV, is used for this measurement. We observe 5 single-peak and 1 double-peak neutrino-like events consistent with the $^{8}$B solar neutrino energy spectrum in the ROI after correcting for nonlinearities in the detector response at high energies. With an expected background of $0.48~^{+0.16}_{-0.15}$ events, the data correspond to a significance of $4.0\,\sigma$ with respect to the background-only hypothesis. We report an energy-averaged cross section of $(4.0~^{+2.0}_{-1.6}~\mathrm{(stat)}~^{+0.8}_{-0.7}~\mathrm{(sys)})\times 10^{-41}\,\mathrm{cm}^2$ in the ROI for the CC $\nu_{e}$ signal, a factor $(2.4~^{+1.3}_{-1.0})$ higher than predicted by Bhattacharya, Goodman and Garc\'ia (2009).

hep-ex↗

arXiv2026

Production of GEM-like structures for cryogenic applications, using laser-cutting techniques

A novel concept for electroluminescence (EL) structures was recently proposed. In it, a wavelength-shifting material is deposited inside the holes of GEM-like structures which, after suitable optical treatment of its electrodes, improves the light collection and detection efficiency in noble gas TPCs. This new development directly addresses problems related with the scalability of future dual-phase TPCs for rare-event searches, matching (and potentially exceeding) the performance of conventional EL techniques. We report the newest developments on the production of such structures using laser-based techniques, namely the manufacture of a first batch of the so-called FAT-GEMs. This process allows low-cost and reproducible manufacturing of a high volume of such structures. In addition to the detailed description of the production, we present a performance assessment in pure argon, at a gas density close to the one expected in LAr conditions. An energy resolution of 23.5$\pm$1~\% (FWHM) at 5.9~keV was obtained, indicating a consistent improvement over previous batch. The optical treatment of the electrode surfaces has been greatly simplified and modestly improved, while charging-up effects arising from the use of laminates eliminated.

physics.ins-det↗

arXiv2025

New candidate polymeric wavelength shifters for noble liquid detectors

Polymeric wavelength shifters are of particular interest for large liquid argon detectors. Inspired by the success of polyethylene naphthalate (PEN), other new polymers exhibiting a similar type of excimer fluorescence were investigated. We report on the preliminary results of the first cryogenic wavelength shifting test of a solution-cast film of PVN, poly(2-vinyl naphthalene). Significant brittleness was identified as a factor potentially limiting the use of PVN. However, clear signs of wavelength shifting were observed, with the overall efficiency and time response comparable to those of PEN.

astro-ph.IM↗

arXiv2024

Demonstration of the light collection stability of a PEN-based wavelength shifting reflector in a tonne scale liquid argon detector

Liquid argon detectors rely on wavelength shifters for efficient detection of scintillation light. The current standard is tetraphenyl butadiene (TPB), but it is challenging to instrument on a large scale. Poly(ethylene 2,6-naphthalate) (PEN), a polyester easily manufactured as thin sheets, could simplify the coverage of large surfaces with wavelength shifters. Previous measurements have shown that commercial grades of PEN have approximately 50% light conversion efficiency relative to TPB. Encouraged by these results, we conducted a large-scale measurement using $4~m^2$ combined PEN and specular reflector foils in a two-tonne liquid argon dewar to assess its stability over approximately two weeks. This test is crucial for validating PEN as a viable substitute for TPB. The setup used for the measurement of the stability of PEN as a wavelength shifter is described, together with the first results, showing no evidence of performance deterioration over a period of 12 days.

physics.ins-det↗

arXiv2024

Production of GEM-like structures using laser-cutting techniques

To enhance the ionization yield of liquid argon time projection chambers (LArTPC) used in dark matter and neutrino experiments it was proposed the use of dopants in LAr, with ionization energies below the scintillation threshold of Ar. While dual-phase LArTPCs have excellent sensitivity to single ionization electrons, their compatibility with photosensitive dopants is hindered by gas-phase electroluminescence photons ionizing the dopants, leading to a positive feedback loop. This can be addressed by optically decoupling the gaseous and liquid phases with a barrier that transmits electrons. A possible solution relies on the use of a pair of structures based on Gaseous Electron Multipliers(GEMs) with misaligned holes. Rather than amplifying electron signals in gas pockets within their holes, their holes will be filled with LAr and a low biasing voltage, so that incident drifting electrons are drawn into the holes but not amplified. Instead, amplification will occur in the gas phase above the structures. Its core element is a GEM-like structure machined from polyethylene naphthalate(PEN). Since PEN scintillates in the visible spectrum, the risk of increased radioactivity due to the larger mass compared to traditional wire grids is negated by the potential to veto its own radioactivity. As such, these structures may also be a useful alternative to wire grids. In this work, we report the newest developments on the production of GEM-like structures using laser-based techniques, namely the manufacture of the first batch PEN and PMMA-based GEM-like structures. This process allows low-cost, reproducible fabrication of a high volume of such structures. In addition to being a low radioactive technique, we expect that it will allow the scaling up of the production of these structures at a reduced cost. First tests indicate good electrical stability, while the performance assessment is still ongoing.

physics.ins-det↗

arXiv2024

Development of wavelength-shifting PEN foils for next generation experiments

Polyethylene naphthalate (PEN) foils have been demonstrated as a wavelength shifter suitable for operation in liquid argon. At the same time, wavelength shifting efficiency of technical grades of PEN, commercially available on the market, is lower than that of tetraphenyl butadiene (TPB). This paper reports on an R&D program focused on exploring the intrinsic limitations of PEN and optimizing it for the highest achievable wavelength shifting efficiency.

astro-ph.IM↗

arXiv2024

FAT-GEMs: (Field Assisted) Transparent Gaseous-Electroluminescence Multipliers

The idea of implementing electroluminescence-based amplification through transparent multi-hole structures (FAT-GEMs) has been entertained for some time. Arguably, for such a technology to be attractive it should perform at least at a level comparable to conventional alternatives based on wires or meshes. We present now a detailed calorimetric study carried out for 5.9~keV X-rays in xenon, for pressures ranging from 2 to 10~bar, resorting to different geometries, production and post-processing techniques. At a reference voltage 5~times above the electroluminescence threshold ($E_{EL,th}\sim0.7$~kV/cm/bar), the number of photoelectrons measured for the best structure was found to be just 18\%~below that obtained for a double-mesh with the same thickness and at the same distance. The energy resolution stayed within 10\% (relative) of the double-mesh value. An innovative characteristic of the structure is that vacuum ultraviolet (VUV) transparency of the polymethyl methacrylate (PMMA) substrate was achieved, effectively, through tetraphenylbutadiene (TPB) coating of the electroluminescence channels combined with indium tin oxide (ITO) coating of the electrodes. This resulted in a $\times 2.25$-increased optical yield (compared to the bare structure), that was found to be in good agreement with simulations if assuming a TPB wavelength-shifting-efficiency at the level of WLSE=0.74-1.28, compatible with expected values. This result, combined with the stability demonstrated for the TPB coating under electric field (over 20~h of continuous operation), shows great potential to revolutionize electroluminescence-based instrumentation.

physics.ins-det↗

arXiv2024

Cryogenic setup for the characterization of wavelength-shifting materials for noble element radiation detectors

In the present work, we describe a cryogenic setup for studies of wavelength-shifting materials for optimised light collection in noble element radiation detectors, and discuss the commissioning results. This SiPM-based setup uses alpha induced scintillation in gaseous argon as the vacuum ultraviolet light source with the goal of characterising materials, such as polyethylene naphthalate (PEN) and tetraphenyl butadiene (TPB), in terms of their wavelength-shifting efficiency. Further extensions of the system are currently being studied. The foreseen upgrades are expected to allow the study of GEM-like structures potentially interesting for rare-event searches. The design of the setup will be addressed along with the first results.

physics.ins-det↗

arXiv2022

SiPM cross-talk in liquid argon detectors

SiPM-based readouts are becoming the standard for light detection in particle detectors given their superior resolution and ease of use with respect to vacuum tube photo-multipliers. However, the contributions of detection noise such as the dark rate, cross-talk, and after-pulsing may impact significantly their performance. In this work, we present the development of highly reflective single-phase argon chambers capable of light yields up to 32 photo-electrons per keV, with roughly 12 being primary photo-electrons generated by the argon scintillation, while the rest are accounted by optical cross-talk. Furthermore, the presence of compound processes results in a generalized Fano factor larger than 2 already at an over-voltage of 5 V. Finally, we present a parametrization of the optical cross-talk for the FBK NUV-HD-Cryo SiPMs at 87 K that can be extended to future detectors with tailored optical simulations.

physics.ins-det↗

arXiv2022

Development of very-thick transparent GEMs with wavelength-shifting capability for noble element TPCs

A new concept for the simultaneous detection of primary and secondary scintillation in time projection chambers is proposed. Its core element is a type of very-thick GEM structure supplied with transparent electrodes and machined from a polyethylene naphthalate plate, a natural wavelength-shifter. Such a device has good prospects for scalability and, by virtue of its genuine optical properties, it can improve on the light collection efficiency, energy threshold and resolution of conventional micropattern gas detectors. This, together with the intrinsic radiopurity of its constituting elements, offers advantages for noble gas and liquid based time projection chambers, used for dark matter searches and neutrino experiments. Production, optical and electrical characterization, and first measurements performed with the new device are reported.

physics.ins-det↗

arXiv2022

Direct comparison of PEN and TPB wavelength shifters in a liquid argon detector

A large number of particle detectors employ liquid argon as their target material owing to its high scintillation yield and its ability to drift ionization charge over large distances. Scintillation light from argon is peaked at 128 nm and a wavelength shifter is required for its efficient detection. In this work, we directly compare the light yield achieved in two identical liquid argon chambers, one of which is equipped with PolyEthylene Naphthalate (PEN) and the other with TetraPhenyl Butadiene (TPB) wavelength shifter. Both chambers are lined with enhanced specular reflectors and instrumented with SiPMs with a coverage fraction of approximately 1%, which represents a geometry comparable to the future large scale detectors. We measured the light yield of the PEN chamber to be 39.4$\pm$0.4(stat)$\pm$1.9(syst)% of the yield of the TPB chamber. Using a Monte Carlo simulation this result is used to extract the wavelength shifting efficiency of PEN relative to TPB equal to 47.2$\pm$5.7%. This result paves the way for the use of easily available PEN foils as a wavelength shifter, which can substantially simplify the construction of future liquid argon detectors.

physics.ins-det↗