Production of GEM-like structures using laser-cutting techniques

Abstract

To enhance the ionization yield of liquid argon time projection chambers (LArTPC) used in dark matter and neutrino experiments it was proposed the use of dopants in LAr, with ionization energies below the scintillation threshold of Ar. While dual-phase LArTPCs have excellent sensitivity to single ionization electrons, their compatibility with photosensitive dopants is hindered by gas-phase electroluminescence photons ionizing the dopants, leading to a positive feedback loop. This can be addressed by optically decoupling the gaseous and liquid phases with a barrier that transmits electrons. A possible solution relies on the use of a pair of structures based on Gaseous Electron Multipliers(GEMs) with misaligned holes. Rather than amplifying electron signals in gas pockets within their holes, their holes will be filled with LAr and a low biasing voltage, so that incident drifting electrons are drawn into the holes but not amplified. Instead, amplification will occur in the gas phase above the structures. Its core element is a GEM-like structure machined from polyethylene naphthalate(PEN). Since PEN scintillates in the visible spectrum, the risk of increased radioactivity due to the larger mass compared to traditional wire grids is negated by the potential to veto its own radioactivity. As such, these structures may also be a useful alternative to wire grids. In this work, we report the newest developments on the production of GEM-like structures using laser-based techniques, namely the manufacture of the first batch PEN and PMMA-based GEM-like structures. This process allows low-cost, reproducible fabrication of a high volume of such structures. In addition to being a low radioactive technique, we expect that it will allow the scaling up of the production of these structures at a reduced cost. First tests indicate good electrical stability, while the performance assessment is still ongoing.