arXiv subjects

Gianluca Usai

Publications and source records attributed to Gianluca Usai.

9 recordsLinked to original sources

arXiv2026

Experiments at the CERN SPS: first signals of deconfinement

Heavy-ion experiments at the CERN SPS began in the mid-1980s to study nuclear matter at extreme temperatures and densities. The program started with light ions, such as oxygen and sulphur, at energies of 60A GeV and 200A GeV, later advancing to lead ions at 158A GeV. A series of experiments, employing novel detector technologies, explored various signatures of quark-gluon plasma (QGP) formation. In February 2000, these results led CERN to announce evidence for the QGP formation. Subsequently, an energy scan was conducted with lead ions from 20A GeV to 158A GeV, to locate the threshold of QGP creation.

nucl-ex↗

arXiv2026

Influence of Radiation and AC Coupling on Time Performance of Analog Pixels Test Structures in 65 nm CMOS technology

Monolithic Active Pixel Sensors (MAPS) in advanced CMOS imaging technologies are key to next-generation tracking systems for high-energy physics, where radiation hardness and precise vertex reconstruction are essential. As part of the ALICE ITS3 R&D program in synergy with the CERN R&D, we evaluated the performance of the Analog Pixel Test Structures (APTS) fabricated in the TPSCo 65 nm CMOS imaging process. The prototypes employ 10 um pitch pixels with a fast operational amplifier-based buffering stage at the output, enabling direct characterization of intrinsic sensor response. Beam tests with minimum ionizing particles assessed the timing and charge collection of DC- and AC-coupled designs, including devices exposed to 10^14 NIEL and 10^15 NIEL non ioninsing energy loss. DC-coupled sensors demonstrated stable performance, maintaining time resolution lower than 70 ps and >99% detection efficiency up to 10^15 NIEL. AC-coupled sensors demonstrated a wide operational margin, with efficiencies above 99% for clusterization thresholds below 150 electrons. Even though the AC coupling allows higher reverse bias than DC-coupled sensors, the reduced signal amplitude lowers the signal-to-noise ratio, increasing the jitter contribution. At high reverse bias, the AC-coupled sensors achieve time resolutions comparable to the DC-coupled version, demonstrating the viability of both approaches. These results also suggest that combining the low capacitance of DC-coupled designs with the high-bias capability of AC coupling could further enhance time resolution. These results confirm the suitability of 65 nm MAPS for future collider detectors requiring high radiation tolerance, efficiency, and timing precision.

physics.ins-det↗

arXiv2025

Further Characterisation of Digital Pixel Test Structures Implemented in a 65 nm CMOS Process

The next generation of MAPS for future tracking detectors will have to meet stringent requirements placed on them. One such detector is the ALICE ITS3 that aims to be very light at 0.07% X/X$_{0}$ per layer and have a low power consumption in the active area of 40 mW/cm$^{2}$ by implementing wafer-scale MAPS bent into cylindrical half layers. To address these challenging requirements, the ALICE ITS3 project, in conjunction with the CERN EP R&D on monolithic pixel sensors, proposed the Tower Partners Semiconductor Co. 65 nm CMOS process as the starting point for the sensor. After the initial results confirmed the detection efficiency and radiation hardness, the choice of the technology was solidified by demonstrating the feasibility of operating MAPS in low-power consumption regimes, < 50 mW/cm$^{2}$, while maintaining high-quality performance. This was shown through a detailed characterisation of the Digital Pixel Test Structure (DPTS) prototype exposed to X-rays and ionising beams, and the results are presented in this article. Additionally, the sensor was further investigated through studies of the fake-hit rate, the linearity of the front-end in the range 1.7-28 keV, the performance after ionising irradiation, and the detection efficiency of inclined tracks in the range 0-45$^\circ$.

physics.ins-det↗

arXiv2025

Detection efficiency and spatial resolution of Monolithic Active Pixel Sensors bent to different radii

Bent monolithic active pixel sensors are the basis for the planned fully cylindrical ultra low material budget tracking detector ITS3 of the ALICE experiment. This paper presents results from testbeam campaigns using high-energy particles to verify the performance of 50 um thick bent ALPIDE chips in terms of efficiency and spatial resolution. The sensors were bent to radii of 18, 24 and 30 mm, slightly smaller than the foreseen bending radii of the future ALICE ITS3 layers. An efficiency larger than $99.9\%$ and a spatial resolution of approximately 5 um, in line with the nominal operation of flat ALPIDE sensors, is obtained at nominal operating conditions. These values are found to be independent of the bending radius and thus constitute an additional milestone in the demonstration of the feasibility of the planned ITS3 detector. In addition, a special geometry in which the beam particles graze the chip and traverse it laterally over distances of up to 3 mm is investigated.

physics.ins-det↗

arXiv2024

Characterisation of analogue Monolithic Active Pixel Sensor test structures implemented in a 65 nm CMOS imaging process

Analogue test structures were fabricated using the Tower Partners Semiconductor Co. CMOS 65 nm ISC process. The purpose was to characterise and qualify this process and to optimise the sensor for the next generation of Monolithic Active Pixels Sensors for high-energy physics. The technology was explored in several variants which differed by: doping levels, pixel geometries and pixel pitches (10-25 $μ$m). These variants have been tested following exposure to varying levels of irradiation up to 3 MGy and $10^{16}$ 1 MeV n$_\text{eq}$ cm$^{-2}$. Here the results from prototypes that feature direct analogue output of a 4$\times$4 pixel matrix are reported, allowing the systematic and detailed study of charge collection properties. Measurements were taken both using $^{55}$Fe X-ray sources and in beam tests using minimum ionizing particles. The results not only demonstrate the feasibility of using this technology for particle detection but also serve as a reference for future applications and optimisations.

physics.ins-det↗

arXiv2023

Digital Pixel Test Structures implemented in a 65 nm CMOS process

The ALICE ITS3 (Inner Tracking System 3) upgrade project and the CERN EP R&D on monolithic pixel sensors are investigating the feasibility of the Tower Partners Semiconductor Co. 65 nm process for use in the next generation of vertex detectors. The ITS3 aims to employ wafer-scale Monolithic Active Pixel Sensors thinned down to 20 to 40 um and bent to form truly cylindrical half barrels. Among the first critical steps towards the realisation of this detector is to validate the sensor technology through extensive characterisation both in the laboratory and with in-beam measurements. The Digital Pixel Test Structure (DPTS) is one of the prototypes produced in the first sensor submission in this technology and has undergone a systematic measurement campaign whose details are presented in this article. The results confirm the goals of detection efficiency and non-ionising and ionising radiation hardness up to the expected levels for ALICE ITS3 and also demonstrate operation at +20 C and a detection efficiency of 99% for a DPTS irradiated with a dose of $10^{15}$ 1 MeV n$_{\mathrm{eq}}/$cm$^2$. Furthermore, spatial, timing and energy resolutions were measured at various settings and irradiation levels.

physics.ins-det↗

arXiv2020

Cooperative Problem Solving: an experience of high-school teaching updating

We present the results of an experience of teaching updating dispensed to Italian high-school physics teachers to promote the application of the Cooperative Problem Solving method as an useful strategy to improve physics learning at high-school level and to foster the development of problem solving skills. Beside analysing the method and discussing the ways to propose and apply it in a high-school context, the teachers experienced the method acting both as learners and as tutors of student group learners. Students and teachers evaluated as positive the experience, mainly focusing on cooperation within the group by information exchange and the application of a solution scheme. The ex-post analysis of the students' performance in applying the method to solve some rich context text showed the need of improving critical sense with respect to achieved results to fully exploit the strategy and develop their problem solving skills. Finally, an analysis on gender differences and scholar distribution of students is presented.

physics.ed-ph↗

arXiv2009

Results on angular distributions of thermal dileptons in nuclear collisions

The NA60 experiment at the CERN SPS has studied dimuon production in 158 AGeV In-In collisions. The strong pair excess above the known sources found in the mass region $0.2<M<2.5$ GeV has been previously interpreted as thermal radiation. In this paper results on the associated angular distributions for $M<1$ GeV, as measured in the Collins-Soper reference frame, are presented. The structure function parameters $λ$, $μ$, $ν$ are consistent with zero and the projected polar and azimuth angle distributions are uniform. The absence of any polarization is consistent with the interpretation of the excess dimuons as thermal radiation from a randomized system.

nucl-ex↗

arXiv2003

First results from the NA60 experiment at CERN

Since 1986, several heavy ion experiments have studied some signatures of the formation of the quark-gluon plasma and a few exciting results have been found. However, some important questions are still unanswered and require new measurements. The NA60 experiment, with a new detector concept that vastly improves dimuon detection in proton-nucleus and heavy-ion collisions, studies several of those open questions, including the production of open charm. This paper presents the experiment and some first results from data collected in 2002.

hep-ex↗