Searcharxiv⌕ Search

arXiv subjects

Guilei Wang

Publications and source records attributed to Guilei Wang.

7 recordsLinked to original sources

A Unified Device-Level Physical Framework for DRAM Read Disturbance

Read disturbance in dynamic random-access memory (DRAM) depends on both local device interactions and the electrical conditions imposed by shared array circuitry. Here, we combine DIMM-level characterization results, device measurements, and TCAD simulations to interpret RowHammer, RowPress, and ColumnDisturb within a unified device-level physical framework. We relate charge evolution at the floating storage node to three key mechanisms: trap-assisted electron migration (EM), capacitive coupling (CC), and sense-amplifier-mediated disturb (SAMD). EM is local and trap-sensitive, while CC weakens with wordline separation. SAMD extends disturbance through shared column circuitry by modifying unselected-cell leakage under rail-level bitline biases, a contribution supported by the approximately ninefold higher OFF-state leakage measured relative to retention-like conditions for a high-voltage storage state. These distinct spatial ranges account for localized RowHammer and RowPress failures and remote ColumnDisturb populations with abrupt changes at subarray boundaries. We further interpret prolonged RowPress activation as a transition from an initial RowHammer-like transient to sustained leakage driven mainly by SAMD under held wordline and bitline biases. Within this device-level framework, trap effectiveness and storage-state-dependent leakage provide an interpretation of previously puzzling failure signatures, including the earlier onset of 0-to-1 RowHammer failures despite the predominance of 1-to-0 failures at high hammer counts. The same framework explains the observed RowPress and ColumnDisturb polarities and the duration-dependent reversal of neighboring- and passing-wordline effectiveness. These results provide a physical basis for developing compact DRAM reliability models across access patterns and array configurations.

cond-mat.mes-hall↗

Industrial RPCVD growth of high-purity 28Si epilayers with 29Si content below 30 ppm for high-fidelity electron spin qubits

Silicon quantum-dot spin qubits are among the most promising routes to large-scale quantum computation, but the residual 29Si nuclear spins in natural silicon impose a hyperfine dephasing limit that must be overcome by isotopic purification. Here, we report the epitaxial growth of high-purity 28Si on float-zone silicon using an industrial reduced-pressure chemical vapor deposition (RPCVD) system. Secondary-ion mass spectrometry (SIMS) confirms an 28Si isotopic purity of 99.997%, with the 29Si concentration below 30 ppm. Through a systematic vacuum annealing matrix (850-1150 C), combined with atomic force microscopy and SIMS, we investigate the defect-mediated decomposition of the native oxide and the injection of non-equilibrium vacancies. We identify a thermal-budget window below 950 C within which the thin-layer structure of 28Si remains intact. At 1.5 K, magnetotransport measurements reveal a peak Hall mobility of 12,858 cm^2 V^-1 s^-1 and a quantum scattering lifetime of 0.659 ps, corresponding to a single-particle level broadening of 499 micro-eV. A double quantum dot fabricated on this platform exhibits a T2* of 0.62 us, a Hahn-echo coherence time of 28.8 us, and single-qubit gate fidelities of up to 99.9% measured by randomized benchmarking. Our results establish industrial RPCVD as a promising route toward high-coherence, high-fidelity silicon spin qubits.

cond-mat.mes-hall↗

Dielectric Deposition Enhanced Crystallization in Atomic-Layer-Deposited Indium Oxide Transistors Achieving High Gated-Hall Mobility Exceeding 100 cm2/Vs at Room Temperature

In this work, we report high-performance atomic-layer-deposited indium oxide (In2O3) transistors with high gated-Hall mobility (μH) exceeding 100 cm2/Vs at room temperature (RT). It is found that the deposition of top hafnium oxide (HfO2) above the In2O3 channel significantly enhances its crystallization, leading to an average grain size of 97.2 nm in a 4.2-nm In2O3 channel. The ALD of In2O3 exhibits an epitaxy-like growth behavior, with its (222) planes aligning parallel to the (111) planes of both the top and bottom HfO2 dielectrics. As a result, bottom-gate In2O3 transistors with a high μH of 100.9 cm2/Vs and a decent subthreshold swing (SS) of 94 mV/dec are achieved by gated-Hall measurement at RT. Furthermore, the devices maintain excellent performance at low temperatures, achieving a μH of 162.2 cm2/Vs at 100 K. Our study reveals the critical role of dielectric deposition induced crystallization in enhancing carrier transport and offers a scalable pathway toward high-mobility devices.

cond-mat.mtrl-sci↗

High Mobility SiGe/Ge 2DHG Heterostructure Quantum Wells for Semiconductor Hole Spin Qubits

Strong spin-orbit coupling and relatively weak hyperfine interactions make germanium hole spin qubits a promising candidate for semiconductor quantum processors. The two-dimensional hole gas structure of strained Ge quantum wells serves as the primary material platform for spin hole qubits.A low disorder material environment is essential for this process. In this work, we fabricated a Ge/SiGe heterojunction with a 60 nm buried quantum well layer on a Si substrate using reduced pressure chemical vapor deposition technology. At a temperature of 16 mK, when the carrier density is 1.87*10^11/cm2, we obtained a mobility as high as 308.64*10^4cm2/Vs. Concurrently, double quantum dot and planar germanium coupling with microwave cavities were also successfully achieved.This fully demonstrates that this structure can be used for the preparation of higher-performance hole spin qubits.

cond-mat.mes-hall↗

Effective electrical manipulation of topological antiferromagnet by orbital Hall effect

Electrical control of the non-trivial topology in Weyl antiferromagnet is of great interests to develop next-generation spintronic devices. Recent works suggest that spin Hall effect can switch the topological antiferromagnetic order. However, the switching efficiency remains relatively low. Here, we demonstrate effective manipulation of antiferromagnetic order in Weyl semimetal Mn3Sn by orbital Hall effect originated from metal Mn or oxide CuOx. While Mn3Sn is proven to be able to convert orbit current to spin current by itself, we find that inserting a heavy metal layer like Pt with proper thickness can effectively reduce the critical switching current density by one order of magnitude. In addition, we show that the memristor-like switching behavior of Mn3Sn can mimic the potentiation and depression processes of a synapse with high linearity, which is beneficial for constructing artificial neural network with high accuracy. Our work paves an alternative way to manipulate topological antiferromagnetic order and may inspire more high-performance antiferromagnetic functional devices.

cond-mat.mtrl-sci↗

Undoped Strained Ge Quantum Well with Ultrahigh Mobility Grown by Reduce Pressure Chemical Vapor Deposition

We fabricate an undoped Ge quantum well under 30 nm Ge0.8Si0.2 shallow barrier with reverse grading technology. The under barrier is deposited by Ge0.8Si0.2 followed by Ge0.9Si0.1 so that the variation of Ge content forms a sharp interface which can suppress the threading dislocation density penetrating into undoped Ge quantum well. And the Ge0.8Si0.2 barrier introduces enough in-plane parallel strain -0.41% in the Ge quantum well. The heterostructure field-effect transistors with a shallow buried channel get a high two-dimensional hole gas (2DHG) mobility over 2E6 cm2/Vs at a low percolation density of 2.51 E-11 cm2. We also discover a tunable fractional quantum Hall effect at high densities and high magnetic fields. This approach defines strained germanium as providing the material basis for tuning the spin-orbit coupling strength for fast and coherent quantum computation.

cond-mat.mes-hall↗

A Study of Selectively Digital Etching Silicon-Germanium with Nitric and Hydrofluoric Acids

A digital etching method was proposed to achieve excellent control of etching depth. The digital etching characteristics of p+ Si and Si0.7Ge0.3 using the combinations of HNO3 oxidation and BOE oxide removal processes were studied. Experiments showed that oxidation saturates with time due to low activation energy. A physical model was presented to describe the wet oxidation process with nitric acid. The model was calibrated with experimental data and the oxidation saturation time, final oxide thickness, and selectivity between Si0.7Ge0.3 and p+ Si were obtained. The digital etch of laminated Si0.7Ge0.3/p+ Si was also investigated. The depth of the tunnels formed by etching SiGe layers between two Si layers was found in proportion to digital etching cycles. And oxidation would also saturate and the saturated relative etched amount per cycle (REPC) was 0.5 nm (4 monolayers). A corrected selectivity calculation formula was presented. The oxidation model was also calibrated with Si0.7Ge0.3/p+ Si stacks, and selectivity from model was the same with the corrected formula. The model can also be used to analyze process variations and repeatability. And it could act as a guidance for experiment design. Selectivity and repeatability should make a trade-off.

physics.app-ph↗