arXiv subjects

M. J. Biercuk

Publications and source records attributed to M. J. Biercuk.

32 records · Page 2Linked to original sources

arXiv2013

A high-power 626 nm diode laser system for Beryllium ion trapping

We describe a high-power, frequency-tunable, external cavity diode laser (ECDL) system near 626 nm useful for laser cooling of trapped $^9$Be$^+$ ions. A commercial single-mode laser diode with rated power output of 170 mW at 635 nm is cooled to $\approx - 31$ C, and a single longitudinal mode is selected via the Littrow configuration. In our setup, involving multiple stages of thermoelectric cooling, we are able to obtain $\approx$130 mW near 626 nm, sufficient for efficient frequency doubling to the required Doppler cooling wavelengths near 313 nm in ionized Beryllium. In order to improve nonlinear frequency conversion efficiency, we achieve larger useful power via injection locking of a slave laser. In this way the entirety of the slave output power is available for frequency doubling, while analysis may be performed on the master output. We believe that this simple laser system addresses a key need in the ion trapping community and dramatically reduces the cost and complexity associated with Beryllium ion trapping experiments.

physics.optics↗

arXiv2011

Improved high-fidelity transport of trapped-ion qubits through a multi-dimensional array

We have demonstrated transport of Be+ ions through a 2D Paul-trap array that incorporates an X-junction, while maintaining the ions near the motional ground-state of the confining potential well. We expand on the first report of the experiment [1], including a detailed discussion of how the transport potentials were calculated. Two main mechanisms that caused motional excitation during transport are explained, along with the methods used to mitigate such excitation. We reduced the motional excitation below the results in Ref. [1] by a factor of approximately 50. The effect of a mu-metal shield on qubit coherence is also reported. Finally, we examined a method for exchanging energy between multiple motional modes on the few-quanta level, which could be useful for cooling motional modes without directly accessing the modes with lasers. These results establish how trapped ions can be transported in a large-scale quantum processor with high fidelity.

quant-ph↗

arXiv2011

Dynamical decoupling sequence construction as a filter-design problem

Over the past decade we have seen an explosion of demonstrations of quantum coherence in atomic, optical, and condensed matter systems. These developments have placed a new emphasis on the production of robust and optimal quantum control techniques in the presence of environmental noise. We discuss the use of dynamical decoupling as a form of open-loop quantum control capable of suppressing the effects of dephasing in quantum coherent systems. We introduce the concept of dynamical decoupling pulse-sequence construction as a filter-design problem, making connections with filter design from control theory and electrical engineering in the analysis of pulse-sequence performance for the preservation of the phase degree of freedom in a quantum superposition. A detailed mathematical description of how dephasing and the suppression of dephasing can be reduced to a linear control problem is provided, and used as motivation and context for studies of the filtration properties of various dynamical decoupling sequences. Our work then takes this practical perspective in addressing both "standard" sequences derived from nuclear magnetic resonance and novel optimized sequences developed in the context of quantum information. Additionally, we review new techniques for the numerical construction of optimized pulse sequences using the filter-design perspective. We show how the filter-design perspective permits concise comparisons of the relative capabilities of these sequences and reveals the physics underlying their functionality. The use of this new analytical framework allows us to derive new insights into the performance of these sequences and reveals important limiting issues, such as the effect of digital clocking on optimized sequence performance.

quant-ph↗

arXiv2011

Phase-coherent detection of an optical dipole force by Doppler velocimetry

We report phase-coherent Doppler detection of optical dipole forces using large ion crystals in a Penning trap. The technique is based on laser Doppler velocimetry using a cycling transition in $^{9}$Be$^{+}$ near 313 nm and the center-of-mass (COM) ion motional mode. The optical dipole force is tuned to excite the COM mode, and measurements of photon arrival times synchronized with the excitation potential show oscillations with a period commensurate with the COM motional frequency. Experimental results compare well with a quantitative model for a driven harmonic oscillator. This technique permits characterization of motional modes in ion crystals; the measurement of both frequency and phase information relative to the driving force is a key enabling capability -- comparable to lockin detection -- providing access to a parameter that is typically not available in time-averaged measurements. This additional information facilitates discrimination of nearly degenerate motional modes.

quant-ph↗

arXiv2011

Phenomenological Study of Decoherence in Solid-State Spin Qubits due to Nuclear Spin Diffusion

We present a study of the prospects for coherence preservation in solid-state spin qubits using dynamical decoupling protocols. Recent experiments have provided the first demonstrations of multipulse dynamical decoupling sequences in this qubit system, but quantitative analyses of potential coherence improvements have been hampered by a lack of concrete knowledge of the relevant noise processes. We present simulations of qubit coherence under the application of arbitrary dynamical decoupling pulse sequences based on an experimentally validated semiclassical model. This phenomenological approach bundles the details of underlying noise processes into a single experimentally relevant noise power spectral density. Our results show that the dominant features of experimental measurements in a two-electron singlet-triplet spin qubit can be replicated using a $1/ω^{2}$ noise power spectrum associated with nuclear-spin-flips in the host material. Beginning with this validation we address the effects of nuclear programming, high-frequency nuclear-spin dynamics, and other high-frequency classical noise sources, with conjectures supported by physical arguments and microscopic calculations where relevant. Our results provide expected performance bounds and identify diagnostic metrics that can be measured experimentally in order to better elucidate the underlying nuclear spin dynamics.

cond-mat.mes-hall↗

arXiv2010

Ultrasensitive force and displacement detection using trapped ions

The ability to detect extremely small forces is vital for a variety of disciplines including precision spin-resonance imaging, microscopy, and tests of fundamental physical phenomena. Current force-detection sensitivity limits have surpassed 1 $aN/\sqrt{Hz}$ (atto $=10^{-18}$) through coupling of micro or nanofabricated mechanical resonators to a variety of physical systems including single-electron transistors, superconducting microwave cavities, and individual spins. These experiments have allowed for probing studies of a variety of phenomena, but sensitivity requirements are ever-increasing as new regimes of physical interactions are considered. Here we show that trapped atomic ions are exquisitely sensitive force detectors, with a measured sensitivity more than three orders of magnitude better than existing reports. We demonstrate detection of forces as small as 174 $yN$ (yocto $=10^{-24}$), with a sensitivity 390$\pm150$ $yN/\sqrt{Hz}$ using crystals of $n=60$ $^{9}$Be$^{+}$ ions in a Penning trap. Our technique is based on the excitation of normal motional modes in an ion trap by externally applied electric fields, detection via and phase-coherent Doppler velocimetry, which allows for the discrimination of ion motion with amplitudes on the scale of nanometers. These experimental results and extracted force-detection sensitivities in the single-ion limit validate proposals suggesting that trapped atomic ions are capable of detecting of forces with sensitivity approaching 1 $yN/\sqrt{Hz}$. We anticipate that this demonstration will be strongly motivational for the development of a new class of deployable trapped-ion-based sensors, and will permit scientists to access new regimes in materials science.

quant-ph↗

arXiv2010

Decoherence due to elastic Rayleigh scattering

We present theoretical and experimental studies of the decoherence of hyperfine ground-state superpositions due to elastic Rayleigh scattering of light off-resonant with higher lying excited states. We demonstrate that under appropriate conditions, elastic Rayleigh scattering can be the dominant source of decoherence, contrary to previous discussions in the literature. We show that the elastic-scattering decoherence rate of a two-level system is given by the square of the difference between the elastic-scattering \textit{amplitudes} for the two levels, and that for certain detunings of the light, the amplitudes can interfere constructively even when the elastic scattering \textit{rates} from the two levels are equal. We confirm this prediction through calculations and measurements of the total decoherence rate for a superposition of the valence electron spin levels in the ground state of $^9$Be$^+$ in a 4.5 T magnetic field.

quant-ph↗

arXiv2005

Charge sensing in carbon nanotube quantum dots on microsecond timescales

We report fast, simultaneous charge sensing and transport measurements of gate-defined carbon nanotube quantum dots. Aluminum radio frequency single electron transistors (rf-SETs) capacitively coupled to the nanotube dot provide single-electron charge sensing on microsecond timescales. Simultaneously, rf reflectometry allows fast measurement of transport through the nanotube dot. Charge stability diagrams for the nanotube dot in the Coulomb blockade regime show extended Coulomb diamonds into the high-bias regime, as well as even-odd filling effects, revealed in charge sensing data.

cond-mat.mes-hall↗

arXiv2005

Gate-Defined Quantum Dots on Carbon Nanotubes

We report the realization of nanotube-based quantum dot structures that use local electrostatic gating to produce individually controllable dots in series along a nanotube. Electrostatic top-gates produce depletion regions in the underlying tube; a pair of such depletion regions defines a quantum dot. Transparencies of tunnel barriers as well as the electrostatic energies, within single and multiple dots, can be tuned by gate voltages. The approach allows accurate control over multiple devices on a single tube, and serves as a design paradigm for nanotube-based electronics and quantum systems.

cond-mat.mes-hall↗

arXiv2004

Anomalous Conductance Quantization in Carbon Nanotubes

Conductance measurements of carbon nanotubes containing gated local depletion regions exhibit plateaus as a function of gate voltage, spaced by approximately e2/h, the quantum of conductance for a single (non-degenerate) mode. Plateau structure is investigated as a function of bias voltage, temperature, and magnetic field. We speculate on the origin of this surprising quantization, which appears to lack band and spin degeneracy.

cond-mat.mes-hall↗

arXiv2003

Locally addressable tunnel barriers within a carbon nanotube

We report the realization and characterization of independently controllable tunnel barriers within a carbon nanotube. The nanotubes are mechanically bent or kinked using an atomic force microscope, and top gates are subsequently placed near each kink. Transport measurements indicate that the kinks form gate-controlled tunnel barriers, and that gates placed away from the kinks have little or no effect on conductance. The overall conductance of the nanotube can be controlled by tuning the transmissions of either the kinks or the metal-nanotube contacts.

cond-mat.mes-hall↗

arXiv2003

Local gating of carbon nanotubes

Local effects of multiple electrostatic gates placed beneath carbon nanotubes grown by chemical vapor deposition (CVD) are reported. Single-walled carbon nanotubes were grown by CVD from Fe catalyst islands across thin Mo "finger gates" (150 x 10nm). Prior to tube growth, several finger gates were patterned lithogrpahically and subsequently coated with a patterned high-k dielectric using low-temperature atomic layer deposition. Transport measurements demonstrate that local finger gates have a distinct effect from a global backgate.

cond-mat.mes-hall↗

arXiv2003

A Low-Temperature Atomic Layer Deposition Liftoff Method for Microelectronic and Nanoelectronic Applications

We report a novel method for depositing patterned dielectric layers with sub-micron features using atomic layer deposition (ALD). The patterned films are superior to sputtered or evaporated films in continuity, smoothness, conformality, and minimum feature size. Films were deposited at 100-150C using several different precursors and patterned using either PMMA or photoresist. The low deposition temperature permits uniform film growth without significant outgassing or hardbaking of resist layers. A liftoff technique presented here gives sharp step edges with edge roughness as low as ~10 nm. We also measure dielectric constants (k) and breakdown fields for the high-k materials aluminum oxide (k ~ 8-9), hafnium oxide (k ~ 16-19) and zirconium oxide (k ~ 20-29), grown under similar low temperature conditions.

cond-mat.mes-hall↗

arXiv2002

Carbon nanotube composites for thermal management

Single-wall carbon nanotubes (SWNTs) were used to augment the thermal transport properties of industrial epoxy. Samples loaded with 1 wt% unpurified SWNT material show a 70% increase in thermal conductivity at 40K, rising to 125% at room temperature; the enhancement due to 1 wt% loading of vapor grown carbon fibers is three times smaller. Electrical conductivity data show a percolation threshold between 0.1 and 0.2 wt% SWNT loading. The Vickers hardness rises monotonically with SWNT loading up to a factor of 3.5 at 2 wt%. These results suggest that the thermal and mechanical properties of SWNT-epoxy composites are improved, without the need to chemically functionalize the nanotubes.

cond-mat.mtrl-sci↗