arXiv subjects
Publications and source records attributed to M. R. Gokhale.
We report polarization-sensitive solar-blind metal-semiconductor-metal UV photodetectors based on (11-20) a-plane AlGaN. The epilayer shows anisotropic optical properties confirmed by polarization-resolved transmission and photocurrent measurements, in good agreement with band structure calculations.
We report epitaxial growth of a-plane (11-20) AlInN layers nearly-lattice-matched to GaN. Unlike for c-plane oriented epilayers, a-plane Al_{1-x}In_{x}N cannot be simultaneously lattice-matched to GaN in both in-plane directions. We study the influence of temperature on indium incorporation and obtain nearly-lattice-matched Al_{0.81}In_{0.19}N at a growth temperature of 760^{o}C. We outline a procedure to check in-plane lattice mismatch using high resolution x-ray diffraction, and evaluate the strain and critical thickness. Polarization-resolved optical transmission measurements of the Al_{0.81}In_{0.19}N epilayer reveal a difference in bandgap of ~140 meV between (electric field) E_parallel_c [0001]-axis and E_perpendicular_c conditions with room-temperature photoluminescence peaked at 3.38 eV strongly polarized with E_parallel_c, in good agreement with strain-dependent band-structure calculations.
We present a simple fabrication technique for lateral nanowire wrap-gate devices with high capacitive coupling and field-effect mobility. Our process uses e-beam lithography with a single resist-spinning step, and does not require chemical etching. We measure, in the temperature range 1.5-250 K, a subthreshold slope of 5-54 mV/decade and mobility of 2800-2500 $cm^2/Vs$ -- significantly larger than previously reported lateral wrap-gate devices. At depletion, the barrier height due to the gated region is proportional to applied wrap-gate voltage.
Unlike c-plane nitrides, ``non-polar" nitrides grown in e.g. the a-plane or m-plane orientation encounter anisotropic in-plane strain due to the anisotropy in the lattice and thermal mismatch with the substrate or buffer layer. Such anisotropic strain results in a distortion of the wurtzite unit cell and creates difficulty in accurate determination of lattice parameters and solid phase group-III content (x_solid) in ternary alloys. In this paper we show that the lattice distortion is orthorhombic, and outline a relatively simple procedure for measurement of lattice parameters of non-polar group III-nitrides epilayers from high resolution x-ray diffraction measurements. We derive an approximate expression for x_solid taking into account the anisotropic strain. We illustrate this using data for a-plane AlGaN, where we measure the lattice parameters and estimate the solid phase Al content, and also show that this method is applicable for m-plane structures as well.
In recent years there have been reports of anomalous electrical resistivity and the presence of superconductivity in semiconducting InN layers. By a careful correlation of the temperature dependence of resistivity and magnetic susceptibility with structural information from highresolution x-ray diffraction measurements we show that superconductivity is not intrinsic to InN and is seen only in samples that show traces of oxygen impurity. We hence believe that InN is not intrinsically a superconducting semiconductor.
Band discontinuities at the InN-GaN heterointerface are experimentally determined from internal photoemission spectroscopy measurements on n+ InN on GaN epilayers. The photocurrent shows two threshold energies, one at 1.624 eV and the other at 2.527 eV. From these we obtain the valence band offset 0.85 eV and the conduction band offset 1.82 eV.
We establish a correlation between the internal stress in InN epilayers and their optical properties such as the measured absorption band edge and photoluminescence emission wavelength. By a careful evaluation of the lattice constants of InN epilayers grown on c-plane sapphire substrates under various conditions by metalorganic vapor phase epitaxy we find that the films are under primarily hydrostatic stress. This results in a shift in the band edge to higher energy. The effect is significant, and may be responsible for some of the variations in InN bandgap reported in the literature.
From a detailed analysis of InN epilayers deposited in a close-coupled showerhead metalorganic vapour phase epitaxy (MOVPE) system under various conditions we investigate the effect of growth parameters on the lattice constants of the InN layer. The layers are under significant internal hydrostatic stress which influences the optical properties. Samples typically fall into two broad categories of stress, with resultant luminescence emission around 0.8eV and 1.1eV. We can correlate the internal stress in the layer and the value of the optical absorption edge, and the PL emission wavelength.
A systematic manipulation of the morphology and the optical emission properties of MOVPE grown ensembles of InAs/InP quantum dots is demonstrated by changing the growth kinetics parameters. Under non-equilibrium conditions of a comparatively higher growth rate and low growth temperature, the quantum dot density, their average size and hence the peak emission wavelength can be tuned by changing efficiency of the surface diffusion (determined by the growth temperature) relative to the growth flux. We further observe that the distribution of quantum dot heights, for samples grown under varying conditions, if normalized to the mean height, can be nearly collapsed onto a single Gaussian curve.
The evolution of InAs quantum dots grown on InP substrates by metal-organic vapour phase epitaxy is studied as a function of InAs coverage. Under specific growth conditions, the onset of the two- to three-dimensional transition is seen to proceed via two distinct pathways: through (i) an abrupt appearance of quantum dots as expected in the usual Stranski-Krastanov growth picture and (ii) a continuous evolution of small surface features into well developed quantum dots. The average size of the features in both these families increases with coverage, leading to a bimodal distribution in dot sizes at an intermediate stage of growth evolution that eventually becomes a unimodal distribution as more material is deposited. Complementary information obtained from independent measurements of photoluminescence spectra and surface morphology is correlated and is found to be consistent with the picture of growth proposed.
In experiments on electron transport the macroscopic inhomogeneities in the sample play a fundamental role. In this paper and a subsequent one we introduce and develop a general formalism that captures the principal features of sample inhomogeneities (density gradients, contact misalignments) in the magneto resistance data taken from low mobility heterostructures. We present detailed assessments and experimental investigations of the different regimes of physical interest, notably the regime of semiclassical transport at weak magnetic fields, the plateau-plateau transitions as well as the plateau-insulator transition that generally occurs at much stronger values of the external field only. It is shown that the semiclassical regime at weak fields plays an integral role in the general understanding of the experiments on the quantum Hall regime. The results of this paper clearly indicate that the plateau-plateau transitions, unlike the the plateau-insulator transition, are fundamentally affected by the presence of sample inhomogeneities. We propose a universal scaling result for the magneto resistance parameters. This result facilitates, amongst many other things, a detailed understanding of the difficulties associated with the experimental methodology of H.P. Wei et.al in extracting the quantum critical behavior of the electron gas from the transport measurements conducted on the plateau-plateau transitions.