arXiv subjects

Marko Lončar

Publications and source records attributed to Marko Lončar.

85 records · Page 5Linked to original sources

arXiv2016

Single-Photon Switching and Entanglement of Solid-State Qubits in an Integrated Nanophotonic System

Efficient interfaces between photons and quantum emitters form the basis for quantum networks and enable nonlinear optical devices operating at the single-photon level. We demonstrate an integrated platform for scalable quantum nanophotonics based on silicon-vacancy (SiV) color centers coupled to nanoscale diamond devices. By placing SiV centers inside diamond photonic crystal cavities, we realize a quantum-optical switch controlled by a single color center. We control the switch using SiV metastable orbital states and verify optical switching at the single-photon level by using photon correlation measurements. We use Raman transitions to realize a single-photon source with a tunable frequency and bandwidth in a diamond waveguide. Finally, we create entanglement between two SiV centers by detecting indistinguishable Raman photons emitted into a single waveguide. Entanglement is verified using a novel superradiant feature observed in photon correlation measurements, paving the way for the realization of quantum networks.

quant-ph↗

arXiv2016

Inverse design of third-order Dirac exceptional points in photonic crystals

We propose a novel inverse-design method that enables brute-force discovery of photonic crystal (PhC) structures with complex spectral degeneracies. As a proof of principle, we demonstrate PhCs exhibiting third-order Dirac points formed by the \emph{accidental} degeneracy of modes of monopolar, dipolar, and quadrupolar nature. We show that under suitable conditions, these modes can coalesce and form a third-order exceptional point (EP3), leading to diverging Petermann factors. We show that the spontaneous emission (SE) rate of emitters at such EP3s, related to the local density of states, can be enhanced by a factor of 8 in purely lossy (passive) structures, with larger enhancements $\sim \sqrt{n^3}$ possible at exceptional points of higher order $n$ or in materials with gain.

physics.optics↗

arXiv2016

Faraday cage angled-etching of nanostructures in bulk dielectrics

For many emerging optoelectronic materials, heteroepitaxial growth techniques do not offer the same high material quality afforded by bulk, single-crystal growth. However, the need for optical, electrical, or mechanical isolation at the nanoscale level often necessitates the use of a dissimilar substrate, upon which the active device layer stands. Faraday cage angled-etching (FCAE) obviates the need for these planar, thin-film technologies by enabling in-situ device release and isolation through an angled-etching process. By placing a Faraday cage around the sample during inductively-coupled plasma reactive ion etching (ICP-RIE), the etching plasma develops an equipotential at the cage surface, directing ions normal to its face. In this Article, the effects Faraday cage angle, mesh size, and sample placement have on etch angle, uniformity, and mask selectivity are investigated within a silicon etching platform. Simulation results qualitatively confirm experiments and help to clarify the physical mechanisms at work. These results will help guide FCAE process design across a wide range of material platforms.

cond-mat.mes-hall↗

arXiv2015

Dynamic Actuation of Single-Crystal Diamond Nanobeams

We show the dielectrophoretic actuation of single-crystal diamond nanomechanical devices. Gradient radio-frequency electromagnetic forces are used to achieve actuation of both cantilever and doubly clamped beam structures, with operation frequencies ranging from a few MHz to ~50MHz. Frequency tuning and parametric actuation are also studied.

cond-mat.mes-hall↗

arXiv2015

Waveguide-loaded silica fibers for coupling to high-index micro-resonators

Tapered silica fibers are often used to rapidly probe the optical properties of micro-resonators. However, their low refractive index precludes phase-matching when coupling to high-index micro-resonators, reducing efficiency. Here we demonstrate efficient optical coupling from tapered fibers to high-index micro-resonators by loading the fibers with an ancillary adiabatic waveguide-coupler fabricated via angled-etching. We demonstrate greatly enhanced coupling to a silicon multimode micro-resonator when compared to coupling via the bare fiber only. Signatures of resonator optical bistability are observed at high powers. This scheme can be applied to resonators of any size and material, increasing the functional scope of fiber coupling.

physics.optics↗

arXiv2015

Enhanced strain coupling of nitrogen vacancy spins to nanoscale diamond cantilevers

Nitrogen vacancy (NV) centers can couple to confined phonons in diamond mechanical resonators via the effect of lattice strain on their energy levels. Access to the strong spin-phonon coupling regime with this system requires resonators with nanoscale dimensions in order to overcome the weak strain response of the NV ground state spin sublevels. In this work, we study NVs in diamond cantilevers with lateral dimensions of a few hundred nm. Coupling of the NV ground state spin to the mechanical mode is detected in electron spin resonance (ESR), and its temporal dynamics are measured via spin echo. Our small mechanical mode volume leads to a 10-100X enhancement in spin-phonon coupling strength over previous NV-strain coupling demonstrations. This is an important step towards strong spin-phonon coupling, which can enable phonon-mediated quantum information processing and quantum metrology.

quant-ph↗

arXiv2014

Integrated high quality factor lithium niobate microdisk resonators

Lithium Niobate (LN) is an important nonlinear optical material. Here we demonstrate LN microdisk resonators that feature optical quality factor ~ 100,000, realized using robust and scalable fabrication techniques, that operate over a wide wavelength range spanning visible and near infrared. Using our resonators, and leveraging LN's large second order optical nonlinearity, we demonstrate on-chip second harmonic generation with a conversion efficiency of 0.109 W-1.

physics.optics↗

arXiv2014

High-Q optical nanocavities in bulk single-crystal diamond

Single-crystal diamond, with its unique optical, mechanical and thermal properties, has emerged as a promising material with applications in classical and quantum optics. However, the lack of heteroepitaxial growth and scalable fabrication techniques remain major limiting factors preventing more wide-spread development and application of diamond photonics. In this work, we overcome this difficulty by adapting angled-etching techniques, previously developed for realization of diamond nanomechanical resonators, to fabricate racetrack resonators and photonic crystal cavities in bulk single-crystal diamond. Our devices feature large optical quality factors, in excess of 10^5, and operate over a wide wavelength range, spanning visible and telecom. These newly developed high-Q diamond optical nanocavities open the door for a wealth of applications, ranging from nonlinear optics and chemical sensing, to quantum information processing and cavity optomechanics.

cond-mat.mes-hall↗

arXiv2013

Nanomechanical resonant structures in single-crystal diamond

With its host of outstanding material properties, single-crystal diamond is an attractive material for nanomechanical systems. Here, the mechanical resonance characteristics of freestanding, single-crystal diamond nanobeams fabricated by an angled-etching methodology are reported. Resonance frequencies displayed evidence of significant compressive stress in doubly clamped diamond nanobeams, while cantilever resonance modes followed the expected inverse-length-squared trend. Q-factors on the order of 104 were recorded in high vacuum. Results presented here represent initial groundwork for future diamond-based nanomechanical systems which may be applied in both classical and quantum applications.

cond-mat.mes-hall↗

arXiv2013

Spontaneous emission and collection efficiency enhancement of single emitters in diamond via plasmonic cavities and gratings

We demonstrate an approach, based on plasmonic apertures and gratings, to enhance the radiative decay rate of single NV centers in diamond, while simultaneously improving their collection efficiency. Our structures are based on metallic resonators formed by surrounding sub-wavelength diamond nanoposts with a silver film, which can enhance the spontaneous emission rate of an embedded NV center. However, the collection efficiency of emitted photons remains low due to losses to surface plasmons and reflections at the diamond-air interface. In this work, we mitigate photon losses into these channels by incorporating grating structures into the plasmonic cavity system.

physics.optics↗

arXiv2011

Enhanced Single Photon Emission from a Diamond-Silver Aperture

We have developed a scalable method for coupling single color centers in diamond to plasmonic resonators and demonstrated Purcell enhancement of the single photon emission rate of nitrogen-vacancy (NV) centers. Our structures consist of single nitrogen-vacancy (NV) center-containing diamond nanoposts embedded in a thin silver film. We have utilized the strong plasmon resonances in the diamond-silver apertures to enhance the spontaneous emission of the enclosed dipole. The devices were realized by a combination of ion implantation and top-down nanofabrication techniques, which have enabled deterministic coupling between single NV centers and the plasmonic modes for multiple devices in parallel. The plasmon-enhanced NV centers exhibited over six-fold improvements in spontaneous emission rate in comparison to bare nanoposts and up to a factor of 3.6 in radiative lifetime reduction over bulk samples, with comparable increases in photon counts. The hybrid diamond-plasmon system presented here could provide a stable platform for the implementation of diamond-based quantum information processing and magnetometry schemes.

quant-ph↗

arXiv2010

Fabrication and characterization of high quality factor silicon nitride nanobeam cavities

Si3N4 is an excellent material for applications of nanophotonics at visible wavelengths due to its wide bandgap and moderately large refractive index (n $\approx$ 2.0). We present the fabrication and characterization of Si3N4 photonic crystal nanobeam cavities for coupling to diamond nanocrystals and Nitrogen-Vacancy centers in a cavity QED system. Confocal micro-photoluminescence analysis of the nanobeam cavities demonstrates quality factors up to Q ~ 55,000, which is limited by the resolution of our spectrometer. We also demonstrate coarse tuning of cavity resonances across the 600-700nm range by lithographically scaling the size of fabricated devices. This is an order of magnitude improvement over previous SiNx cavities at this important wavelength range.

quant-ph↗

arXiv2010

Single Color Centers Implanted in Diamond Nanostructures

The development of materials processing techniques for optical diamond nanostructures containing a single color center is an important problem in quantum science and technology. In this work, we present the combination of ion implantation and top-down diamond nanofabrication in two scenarios: diamond nanopillars and diamond nanowires. The first device consists of a 'shallow' implant (~20nm) to generate Nitrogen-vacancy (NV) color centers near the top surface of the diamond crystal. Individual NV centers are then isolated mechanically by dry etching a regular array of nanopillars in the diamond surface. Photon anti-bunching measurements indicate that a high yield (>10%) of the devices contain a single NV center. The second device demonstrates 'deep' (~1μm) implantation of individual NV centers into pre-fabricated diamond nanowire. The high single photon flux of the nanowire geometry, combined with the low background fluorescence of the ultrapure diamond, allows us to sustain strong photon anti-bunching even at high pump powers.

cond-mat.mtrl-sci↗