arXiv subjects

Thomas Ihn

Publications and source records attributed to Thomas Ihn.

At least 145 records · Page 8Linked to original sources

arXiv2014

Characterizing wave functions in graphene nanodevices: electronic transport through ultrashort graphene constrictions on a boron nitride substrate

We present electronic transport measurements through short and narrow (30x30 nm) single layer graphene constrictions on a hexagonal boron nitride substrate. While the general observation of Coulomb-blockade is compatible with earlier work, the details are not: we show that the area on which charge is localized can be significantly larger than the area of the constriction, suggesting that the localized states responsible for Coulomb-blockade leak out into the graphene bulk. The high bulk mobility of graphene on hexagonal boron nitride, however, seems not consistent with the short bulk localization length required to see Coulomb-blockade. To explain these findings, charge must instead be primarily localized along the imperfect edges of the devices and extend along the edge outside of the constriction. In order to better understand the mechanisms, we compare the experimental findings with tight-binding simulations of such constrictions with disordered edges. Finally we discuss previous experiments in the light of these new findings.

cond-mat.mes-hall↗

arXiv2014

Evaluating charge noise acting on semiconductor quantum dots in the circuit quantum electrodynamics architecture

We evaluate the charge noise acting on a GaAs/GaAlAs based semiconductor double quantum dot dipole-coupled to the voltage oscillations of a superconducting transmission line resonator. The in-phase ($I$) and the quadrature ($Q$) components of the microwave tone transmitted through the resonator are sensitive to charging events in the surrounding environment of the double dot with an optimum sensitivity of $8.5\times10^{-5} \mbox{e}/\sqrt{\mbox{Hz}}$. A low frequency $1/f$ type noise spectrum combined with a white noise level of $6.6\times10^{-6}$ $\mbox{e}^2/\mbox{Hz}$ above $1$ Hz is extracted, consistent with previous results obtained with quantum point contact charge detectors on similar heterostructures. The slope of the $1/f$ noise allows to extract a lower bound for the double-dot charge qubit dephasing rate which we compare to the one extracted from a Jaynes-Cummings Hamiltonian approach. The two rates are found to be similar emphasizing that charge noise is the main source of dephasing in our system.

cond-mat.mes-hall↗

arXiv2014

Finite bias spectroscopy of a three-terminal graphene quantum dot in the multi-level regime

Finite bias spectroscopy measurements of a three-terminal graphene quantum dot are presented. Numerous lines of enhanced differential conductance are observed outside the Coulomb diamonds. In the single-level transport regime such lines are often associated with transport through excited states. Here the system is in the multi-level transport regime. We argue that the lines are most likely a result of strong coupling to only a few of the excited states available in the bias window. We also discuss the option that fluctuations of the density of states in the leads are fully or partly responsible for the appearance of the lines. Such a detailed analysis requires the presence of three leads to the dot.

cond-mat.mes-hall↗

arXiv2014

Increasing the ν = 5 / 2 gap energy: an analysis of MBE growth parameters

The fractional quantized Hall state (FQHS) at the filling factor ν = 5/2 is of special interest due to its possible application for quantum computing. Here we report on the optimization of growth parameters that allowed us to produce two-dimensional electron gases (2DEGs) with a 5/2 gap energy up to 135 mK. We concentrated on optimizing the MBE growth to provide high 5/2 gap energies in "as-grown" samples, without the need to enhance the 2DEGs properties by illumination or gating techniques. Our findings allow us to analyse the impact of doping in narrow quantum wells with respect to conventional DX-doping in AlxGa1-xAs. The impact of the setback distance between doping layer and 2DEG was investigated as well. Additionally, we found a considerable increase in gap energy by reducing the amount of background impurities. To this end growth techniques like temperature reductions for substrate and effusion cells and the reduction of the Al mole fraction in the 2DEG region were applied.

cond-mat.mes-hall↗

arXiv2014

Ultra-narrow ionization resonances in a quantum dot under broadband excitation

Semiconductor quantum dots driven by the broadband radiation fields of nearby quantum point contacts provide an exciting new setting for probing dynamics in driven quantum systems at the nanoscale. We report on real-time charge-sensing measurements of the dot occupation, which reveal sharp resonances in the ionization rate as a function of gate voltage and applied magnetic field. Despite the broadband nature of excitation, the resonance widths are much smaller than the scale of thermal broadening. We show that such resonant enhancement of ionization is not accounted for by conventional approaches relying on elastic scattering processes, but can be explained via a mechanism based on a bottleneck process that is relieved near excited state level crossings. The experiment thus reveals a new regime of a strongly driven quantum dynamics in few-electron systems. The theoretical results are in good agreement with observations.

cond-mat.mes-hall↗

arXiv2014

Spin-orbit splitting and effective masses in p-type GaAs two-dimensional hole gases

We present magnetotransport measurements performed on two-dimensional hole gases embedded in carbon doped p-type GaAs/AlGaAs heterostructures grown on [001] oriented substrates. A pronounced beating pattern in the Shubnikov-de Haas oscillations proves the presence of strong spin-orbit interaction in the device under study. We estimate the effective masses of spin-orbit split subbands by measuring the temperature dependence of the Shubnikov-de Haas oscillations at different hole densities. While the lighter heavy-hole effective mass is not energy dependent, the heavier heavy-hole effective mass has a prominent energy dependence, indicating a strong spin-orbit induced non parabolicity of the valence band. The measured effective masses show qualitative agreement with self-consistent numerical calculations.

cond-mat.mes-hall↗

arXiv2013

Insulating state and giant non-local response in an InAs/GaSb quantum well in the quantum Hall regime

We present transport measurements performed in InAs/GaSb double quantum wells. At the electron-hole crossover tuned by a gate voltage, a strong increase in the longitudinal resistivity is observed with increasing perpendicular magnetic field. Concomitantly with a local resistance exceeding the resistance quantum by an order of magnitude, we find a pronounced non-local resistance signal of almost similar magnitude. The co-existence of these two effects is reconciled in a model of counter-propagating and dissipative quantum Hall edge channels providing backscattering, shorted by a residual bulk conductivity.

cond-mat.mes-hall↗

arXiv2013

Imaging the Conductance of Integer and Fractional Quantum Hall Edge States

We measure the conductance of a quantum point contact (QPC) while the biased tip of a scanning probe microscope induces a depleted region in the electron gas underneath. At finite magnetic field we find plateaus in the real-space maps of the conductance as a function of tip position at integer (ν=1,2,3,4,6,8) and fractional (ν=1/3,2/3,5/3,4/5) values of transmission. They resemble theoretically predicted compressible and incompressible stripes of quantum Hall edge states. The scanning tip allows us to shift the constriction limiting the conductance in real space over distances of many microns. The resulting stripes of integer and fractional filling factors are rugged on the micron scale, i.e. on a scale much smaller than the zero-field elastic mean free path of the electrons. Our experiments demonstrate that microscopic inhomogeneities are relevant even in high-quality samples and lead to locally strongly fluctuating widths of incompressible regions even down to their complete suppression for certain tip positions. The macroscopic quantization of the Hall resistance measured experimentally in a non-local contact configuration survives in the presence of these inhomogeneities, and the relevant local energy scale for the ν=2 state turns out to be independent of tip position.

cond-mat.mes-hall↗

arXiv2013

Suppression of bulk conductivity in InAs/GaSb broken gap composite quantum wells

The two-dimensional topological insulator state in InAs/GaSb quantum wells manifests itself by topologically protected helical edge channel transport relying on an insulating bulk. This work investigates a way of suppressing bulk conductivity by using gallium source materials of different degrees of impurity concentrations. While highest-purity gallium is accompanied by clear conduction through the sample bulk, intentional impurity incorporation lead to a bulk resistance over 1 MΩ. This resistance was found to be independent of applied magnetic fields. Ultra high electron mobilities for GaAs/AlGaAs structures fabricated in a molecular beam epitaxy system used for the growth of Sb-based samples are reported.

cond-mat.mes-hall↗

arXiv2013

Cyclic Depopulation of Edge States in a large Quantum Dot

We investigate magneto-transport through a 1.6 μm wide quantum dot (QD) with adjacent charge detector, for different integer filling factors in the QD and constrictions. When this system is operated as a Fabry-Pérot interferometer, transport is governed by a Coulomb blockade mechanism. In the tunneling regime, we can directly measure the charge stability diagram of two capacitively and tunnel coupled Landau levels. This situation has been investigated in direct transport, as well as in single electron counting. The edge states within the dot are non-cyclically depopulated, which can be explained by a simple capacitive model and allows to draw conclusions about the edge state geometry within the quantum dot.

cond-mat.mes-hall↗

arXiv2013

Aharonov-Bohm rings with strong spin-orbit interaction: the role of sample-specific properties

We present low-temperature transport experiments on Aharonov-Bohm (AB) rings fabricated from two-dimensional hole gases in p-type GaAs/AlGaAs heterostructures. Highly visible h/e (up to 15%) and h/2e oscillations, present for different gate voltages, prove the high quality of the fabricated devices. Like in previous work, a clear beating pattern of the h/e and h/2e oscillations is present in the magnetoresistance, producing split peaks in the Fourier spectrum. The magnetoresistance evolution is presented and discussed as a function of temperature and gate voltage. It is found that sample specific properties have a pronounced influence on the observed behavior. For example, the interference of different transverse modes or the interplay between h/e oscillations and conductance fluctuations can produce the features mentioned above. In previous work they have occasionally been interpreted as signatures of spin-orbit interaction (SOI)-induced effects. In the light of these results, the unambiguous identification of SOI-induced phase effects in AB rings remains still an open and challenging experimental task.

cond-mat.mes-hall↗

arXiv2013

A circuit analysis of an in situ tunable radio-frequency quantum point contact

A detailed analysis of the tunability of a radio-frequency quantum point contact setup using a C-LCR circuit is presented. We calculate how the series capacitance influences resonance frequency and charge-detector resistance for which matching is achieved as well as the voltage and power delivered to the load. Furthermore, we compute the noise contributions in the system and compare our findings with measurements taken with an etched quantum point contact. While our considerations mostly focus on our specific choice of matching circuit, the discussion of the influence of source-to-load power transfer on the signal-to-noise ratio is valid generally.

cond-mat.mes-hall↗

arXiv2013

Tunable Charge Detectors for Semiconductor Quantum Circuits

Nanostructures defined in high-mobility two-dimensional electron systems offer a unique way of controlling the microscopic details of the investigated device. Quantum point contacts play a key role in these investigations, since they are not only a research topic themselves, but turn out to serve as convenient and powerful detectors for their electrostatic environment. We investigate how the sensitivity of charge detectors can be further improved by reducing screening, increasing the capacitive coupling between charge and detector and by tuning the quantum point contacts' confinement potential into the shape of a localized state. We demonstrate the benefits of utilizing a localized state by performing fast and well-resolved charge detection of a large quantum dot in the quantum Hall regime.

cond-mat.mes-hall↗

arXiv2013

Reactive-Ion-Etched Graphene Nanoribbons on a Hexagonal Boron Nitride Substrate

We report on the fabrication and electrical characterization of both single layer graphene micron-sized devices and nanoribbons on a hexagonal boron nitride substrate. We show that the micron-sized devices have significantly higher mobility and lower disorder density compared to devices fabricated on silicon dioxide substrate in agreement with previous findings. The transport characteristics of the reactive-ion-etched graphene nanoribbons on hexagonal boron nitride, however, appear to be very similar to those of ribbons on a silicon dioxide substrate. We perform a detailed study in order to highlight both similarities as well as differences. Our findings suggest that the edges have an important influence on transport in reactive ion-etched graphene nanodevices.

cond-mat.mes-hall↗

arXiv2012

Counting statistics in an InAs nanowire quantum dot with a vertically coupled charge detector

A gate-defined quantum dot in an InAs nanowire is fabricated on top of a quantum point contact realized in a two-dimensional electron gas. The strong coupling between these two quantum devices is used to perform time-averaged as well as time-resolved charge detection experiments for electron flow through the quantum dot. We demonstrate that the Fano factor describing shot noise or time-correlations in single-electron transport depends in the theoretically expected way on the asymmetry of the tunneling barriers even in a regime where the thermal energy $k_\mathrm{B}T$ is comparable to the single-particle level spacing in the dot.

cond-mat.mes-hall↗

arXiv2011

Spatial mapping and manipulation of two tunnel-coupled quantum dots

The metallic tip of a scanning force microscope operated at 300 mK is used to locally induce a potential in a fully controllable double quantum dot defined via local anodic oxidation in a GaAs/AlGaAs heterostructure. Using scanning gate techniques we record spatial images of the current through the sample for different numbers of electrons on the quantum dots (i.e., for different quantum states). Owing to the spatial resolution of current maps, we are able to determine the spatial position of the individual quantum dots, and investigate their apparent relative shifts due to the voltage applied to a single gate.

cond-mat.mes-hall↗

arXiv2011

Raman spectroscopy on etched graphene nanoribbons

We investigate etched single-layer graphene nanoribbons with different widths ranging from 30 to 130 nm by confocal Raman spectroscopy. We show that the D-line intensity only depends on the edge-region of the nanoribbon and that consequently the fabrication process does not introduce bulk defects. In contrast, the G- and the 2D-lines scale linearly with the irradiated area and therefore with the width of the ribbons. We further give indications that the D- to G-line ratio can be used to gain information about the crystallographic orientation of the underlying graphene. Finally, we perform polarization angle dependent measurements to analyze the nanoribbon edge-regions.

cond-mat.mes-hall↗

arXiv2010

An in-situ tunable radio-frequency quantum point contact

Incorporating a variable capacitance diode into a radio-frequency matching circuit allows us to in-situ tune the resonance frequency of an RF quantum point contact, increasing the versatility of the latter as a fast charge sensor of a proximal quantum circuit. The performance of this method is compared in detail to conventional low-frequency charge detection. The approach is also applicable to other RF-detection schemes, such as RF-SET circuits.

cond-mat.mes-hall↗