SearcharxivSearch

arXiv · 2506.21375

Integrating Movable Antennas and Intelligent Reflecting Surfaces for Coverage Enhancement

Abstract

This paper investigates an intelligent reflecting surface (IRS)-aided movable antenna (MA) system, where multiple IRSs cooperate with a multi-MA base station to extend wireless coverage to multiple target areas. The objective is to maximize the worst-case signal-to-noise ratio (SNR) across all locations within these areas through joint optimization of MA positions, IRS phase shifts, and transmit beamforming. To achieve this while balancing the performance-cost trade-off, we propose three coverage-enhancement schemes: the area-adaptive MA-IRS scheme, where both MA positions and IRS phase shifts are adaptively adjusted for each target area; the area-adaptive MA-staIRS scheme, where only MA positions are adjusted, while IRS phase shifts remain unchanged after initial configuration (with staIRS denoting static IRSs); and the shared MA-staIRS scheme, where a common MA placement and static IRS configuration are applied across all areas. These schemes lead to challenging non-convex optimization problems with implicit objectives, which are difficult to solve optimally. To address these problems, we propose a general algorithmic framework that can solve each problem efficiently albeit suboptimally. Simulation results demonstrate that: 1) the proposed MA-based schemes consistently outperform their fixed-position antenna (FPA)-based counterparts under both area-adaptive and static IRS configurations, with the area-adaptive MA-IRS scheme achieving the best worst-case SNR; 2) as transmit antennas are typically far fewer than IRS elements, the area-adaptive MA-staIRS scheme may underperform the baseline FPA scheme with area-adaptive IRSs in worst-case SNR, but a modest increase in antenna number can reverse this; 3) under a fixed total cost, the optimal MA-to-IRS-element ratio for worst-case SNR maximization is empirically found to be proportional to the reciprocal of their unit cost ratio.

Explore related subjects

Keep this discovery

BibTeXRIS

Ying Gao, Qingqing Wu, Weidong Mei, Guangji Chen, Wen Chen, Ziyuan Zheng. 2025-06-26. Integrating Movable Antennas and Intelligent Reflecting Surfaces for Coverage Enhancement. https://doi.org/10.1109/twc.2025.3623474

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

Load Balancing in Multi-Shell LEO Satellite Networks with Successive Interference Cancellation

Multi-shell low Earth orbit (LEO) networks can increase service opportunities, but altitude-dependent propagation can concentrate traffic on lower shells and create strong inter-shell interference under full frequency reuse. This paper develops a mathematical framework for load balancing in multi-shell LEO satellite networks. Satellites on each shell form an independent spherical Poisson point process (SPPP), and the typical user associates with one of the per-shell serving satellites through a shell-dependent biased received-power rule, with receiver-side successive interference cancellation (SIC) under full frequency reuse. Shell-wise association probabilities, conditioned serving-distance distributions, and the rate coverage probability under shell-dependent traffic loads are derived and validated by simulation. The results show that shell-dependent biasing alleviates lower-shell traffic concentration and improves rate coverage, while receiver-side SIC mitigates the dominant lower-shell interference experienced by users associated with upper shells. Load balancing provides its largest rate-coverage gain in traffic hotspots, while SIC becomes more valuable as receive-side isolation weakens. With a fixed satellite budget, distributing satellites across multiple shells can further improve hotspot rate coverage by adding shell-wise serving opportunities.

eess.SP

Tensor Decomposition Based Mixed-Field Sensing for XL-MIMO AFDM Systems

Integrated sensing and communications enabled by extremely large-scale MIMO (XL-MIMO) and affine frequency division multiplexing (AFDM) is a highly promising paradigm for vehicular networks. However, the near-field spherical wavefront distortions induce severe non-linear parameter coupling, while the highly dynamic scattering environments exacerbate mismatch errors. To address these critical challenges, this paper proposes a novel tensor-based sensing scheme for XL-MIMO AFDM systems. First, the received signals are reformulated into a tensor, followed by an efficient decomposition approach that exploits the inherent Vandermonde structure of the factor matrices. This allows parameters to be directly estimated from the decomposed matrices, effectively avoiding inter-parameter coupling. Subsequently, a symmetric decoupling and real-domain manifold optimization algorithm is proposed for angle of arrival estimation, circumventing the high-dimensional searches typically induced by near-field effects. Furthermore, a baseband reconstruction and analytical gradient-based algorithm is developed to perform delay-Doppler estimation in the continuous parameter domain, fundamentally eradicating the grid-mismatch errors inherent in high-mobility scenarios. With these decoupled factors, the remaining unknown angle of departure can be readily extracted. Extensive simulation results demonstrate that the proposed scheme achieves orders-of-magnitude improvements in delay-Doppler accuracy and eliminates the error floors in angular estimation that severely bottleneck state-of-the-art baselines.

eess.SP

Radio Map Construction with Post-Hoc Location Calibration under Quasi-Static Positioning Errors: Joint Estimation, Performance Bounds, and GNSS-Based Evaluation

Radio maps enable environment-aware wireless and Internet-of-Things applications and can be constructed from location-tagged received signal strength (RSS) measurements collected by mobile devices. In urban environments, temporally correlated GNSS errors can shift an entire sensing trajectory, causing systematic spatial misregistration that is not mitigated by collecting more measurements. This paper presents a radio-map construction framework that uses the radio measurements themselves to calibrate erroneous location tags after data collection. The dominant positioning error is modeled as a sensor-specific quasi-static offset, which is jointly estimated with radio-propagation parameters in a Gaussian process regression (GPR) framework by exploiting complementary spatial information from distance-dependent path loss and spatially correlated shadowing. We establish lower and upper bounds on the conditional Bayes risk and show that, under a translation-invariant trajectory model, trajectory information alone cannot identify the quasi-static offset, thereby motivating the use of RSS-derived spatial information for calibration. Numerical evaluations across propagation conditions show that the proposed method reduces the mean squared error (MSE) gap from ideal GPR to approximately $3.26\mathrm{dB}^2$, compared with about $10\mathrm{dB}^2$ for position-error-agnostic and noisy-input GPR baselines. Evaluation using positioning-error models derived from smartphone GNSS measurements shows that the proposed method outperforms a KF--RTS trajectory-smoothing baseline despite unmodeled time-varying positioning errors, remaining within approximately $5\mathrm{dB}^2$ of ideal GPR at the median MSE. These results demonstrate that RSS measurements can serve not only as observations for radio-map reconstruction but also as spatial cues for post-hoc calibration of imperfectly geotagged sensing data.

eess.SP