arXiv subjects

Sriram Krishnamoorthy

Publications and source records attributed to Sriram Krishnamoorthy.

86 records · Page 5Linked to original sources

arXiv2016

High Current Density 2D/3D Esaki Tunnel Diodes

The integration of two-dimensional materials such as transition metal dichalcogenides with bulk semiconductors offer interesting opportunities for 2D/3D heterojunction-based novel device structures without any constraints of lattice matching. By exploiting the favorable band alignment at the GaN/MoS2 heterojunction, an Esaki interband tunnel diode is demonstrated by transferring large area, Nb-doped, p-type MoS2 onto heavily n-doped GaN. A peak current density of 446 A/cm2 with repeatable room temperature negative differential resistance, peak to valley current ratio of 1.2, and minimal hysteresis was measured in the MoS2/GaN non-epitaxial tunnel diode. A high current density of 1 kA/cm2 was measured in the Zener mode (reverse bias) at -1 V bias. The GaN/MoS2 tunnel junction was also modeled by treating MoS2 as a bulk semiconductor, and the electrostatics at the 2D/3D interface was found to be crucial in explaining the experimentally observed device characteristics.

physics.ins-det↗

arXiv2016

Low-resistance GaN tunnel homojunctions with 150 kA/cm^2 current and repeatable negative differential resistance

We report GaN n++/p++ interband tunnel junctions with repeatable negative differential resistance and low resistance. Reverse and forward tunneling current densities were observed to increase as Si and Mg doping concentrations were increased. Hysteresis-free, bidirectional negative differential resistance was observed at room temperature from these junctions at a forward voltage of ~1.6-2 V. Thermionic PN junctions with tunnel contact to the p-layer exhibited forward current density of 150 kA/cm^2 at 7.6 V, with a low series device resistance of 1 x 10^-5 ohm.cm^2.

cond-mat.mtrl-sci↗

arXiv2015

Enhanced Light Extraction in Tunnel Junction Enabled Top Emitting UV LEDs

The efficiency of ultra violet LEDs is critically limited by the absorption losses in p-type and metal layers. In this work, surface roughening based light extraction structures are combined with tunneling-based top-contacts to realize highly efficient top-side light extraction efficiency in UV LEDs. Surface roughening of the top n-type AlGaN contact layer is demonstrated using self-assembled Ni nano-clusters as etch mask. The top surface roughened LEDs were found to enhance external quantum efficiency by over 40% for UV LEDs with a peak emission wavelength of 326 nm. The method described here can enable highly efficient UV LEDs without the need for complex manufacturing methods such as flip chip bonding.

cond-mat.mtrl-sci↗

arXiv2015

Simulation of Enhancement Mode GaN HEMTs with Threshold > 5 V using P-type Buffer

A high threshold voltage enhancement-mode GaN HEMT with p-type doped buffer is discussed and simulated. Analytical expressions are derived to explain the role of buffer capacitance in designing and enhancing threshold voltage. Simulations of the proposed device with p-type buffer show threshold voltages above 5 V, and a positive shift in threshold voltage as the oxide capacitance is reduced, thus enabling threshold voltage tunability over an unprecedented range for GaN-based HEMTs. The electric field profiles, breakdown performance, on-resistance and delay tradeoffs in the proposed pGaN back HEMT device are also discussed.

physics.ins-det↗

arXiv2015

Density-Dependent Electron Transport and Precise Modeling of GaN HEMTs

We report on the direct measurement of two-dimensional sheet charge density dependence of electron transport in AlGaN/GaN high electron mobility transistors. Pulsed IV measurements established increasing electron velocities with decreasing sheet charge densities, resulting in saturation velocity of 1.9 x 10^7 cm/s at a low sheet charge density of 7.8 x 10^11 cm-2. A new optical phonon emission-based electron velocity model for GaN is also presented. It accommodates stimulated LO phonon emission which clamps the electron velocity with strong electron-phonon interaction and long LO phonon lifetime in GaN. A comparison with the measured density-dependent saturation velocity shows that it captures the dependence rather well. Finally, the experimental result is applied in TCAD-based device simulator to predict DC and small signal characteristics of a reported GaN HEMT. Good agreement between the simulated and reported experimental results validated the measurement presented in this report and established accurate modeling of GaN HEMTs.

cond-mat.mtrl-sci↗

arXiv2015

Layer-Transferred MoS2/GaN PN Diodes

Electrical and optical characterization of two-dimensional/three-dimensional (2D/3D) p-molybdenum disulfide/n-gallium nitride (p-MoS2/n-GaN) heterojunction diodes are reported. Devices were fabricated on high-quality, large-area p-MoS2 grown by chemical vapor deposition (CVD) on hexagonal sapphire substrates. The processed devices were transferred onto GaN/sapphire substrates, and the transferred films were characterized by X-ray diffraction (XRD) and atomic force microscopy (AFM). On-axis XRD spectra and surface topology obtained from AFM scans were consistent with previously grown high-quality, continuous MoS2 films. Current-voltage measurements of these diodes exhibited excellent rectification, and capacitance-voltage measurements were used to extract a conduction band offset of approximately 0.2 eV for the transferred MoS2/GaN heterojunction. This conduction band offset was confirmed by internal photoemission (IPE) measurements. The energy band lineup of the MoS2/GaN heterojunction is proposed here. This work demonstrates the potential of 2D/3D heterojunctions for novel device applications.

cond-mat.mtrl-sci↗

arXiv2015

Interband Tunneling for Hole Injection in III-Nitride Ultra-violet Emitters

Ultra-violet emitters have several applications in the areas of sensing, water purification, and data storage. While the III-Nitride semiconductor system has the band gap region necessary for ultraviolet emission, achieving efficient ultraviolet solid state emitters remains a challenge due to the low p-type conductivity and high contact resistance in wide band gap AlGaN-based ultra-violet light emitters. In this work, we show that efficient interband tunneling can be used for non-equilibrium injection of holes into ultraviolet emitters. Polarization-engineered tunnel junctions were used to enhance tunneling probability by several orders of magnitude over a PN homojunction, leading to highly efficient tunnel injection of holes to ultraviolet light emitters. This demonstration of efficient interband tunneling introduces a new paradigm for design of ultra-violet light emitting diodes and diode lasers, and enables higher efficiency and lower cost ultra-violet emitters.

cond-mat.mtrl-sci↗

arXiv2014

InGaN/GaN Tunnel Junctions For Hole Injection in GaN Light Emitting Diodes

InGaN/GaN tunnel junction contacts were grown on top of an InGaN/GaN blue (450 nm) light emitting diode wafer using plasma assisted molecular beam epitaxy. The tunnel junction contacts enable low spreading resistance n-GaN top contact layer thereby requiring less top metal contact coverage on the surface. A voltage drop of 5.3 V at 100 mA, forward resistance of 2 x 10-2 ohm cm2 and a higher light output power are measured in tunnel junction LED. A low resistance of 5 x 10-4 ohm cm2 was measured in a MBE grown tunnel junction on GaN PN junction device, indicating that the tunnel junction LED device resistance is limited by the regrowth interface and not by the intrinsic tunneling resistance.

cond-mat.mtrl-sci↗

arXiv2013

GdN Nanoisland-Based GaN Tunnel Junctions

We show that GdN nanoislands can enhance inter-band tunneling in GaN PN junctions by several orders of magnitude, enabling low optical absorption low-resistance tunnel junctions (specific resistivity 1.3 X 10-3 Ω-cm2) for various optoelectronic applications. We exploit the ability to overgrow high quality GaN over GdN nanoislands to create new nanoscale heterostructure designs that are not feasible in planar epitaxy. GdN nanoisland assisted inter-band tunneling was found to enhance tunneling in both of the polar orientations of GaN. Tunnel injection of holes was confirmed by low temperature operation of GaN p-n junction with a tunneling contact layer, showing strong electroluminescence down to 20K. The availability of tunnel junctions with negligible absorption could not only improve the efficiency of existing optoelectronic devices significantly, but also enable new electronic and optical devices based on wide band gap materials.

cond-mat.mtrl-sci↗

arXiv2013

Large Area Single Crystal (0001) Oriented MoS2 Thin Films

Layered metal dichalcogenide materials are a family of semiconductors with a wide range of energy band gaps and properties, and potential to open up new areas of physics and technology applications. However, obtaining high crystal quality thin films over a large area remains a challenge. Here we show that chemical vapor deposition (CVD) can be used to achieve large area electronic grade single crystal Molybdenum Disulfide (MoS2) thin films with the highest mobility reported in CVD grown films so far. Growth temperature and choice of substrate were found to critically impact the quality of film grown, and high temperature growth on (0001) orientated sapphire yielded highly oriented single crystal MoS2 films for the first time. Films grown under optimal conditions were found to be of high structural quality from high-resolution X-ray diffraction, transmission electron microscopy, and Raman measurements, approaching the quality of reference geological MoS2. Photoluminescence and electrical measurements confirmed the growth of optically active MoS2 with a low background carrier concentration, and high mobility. The CVD method reported here for the growth of high quality MoS2 thin films paves the way towards growth of a variety of layered 2D chalcogenide semiconductors and their heterostructures.

cond-mat.mtrl-sci↗

arXiv2013

Low Resistance GaN/InGaN/GaN Tunnel Junctions

Enhanced interband tunnel injection of holes into a PN junction is demonstrated using P-GaN/InGaN/N-GaN tunnel junctions with a specific resistivity of 1.2 X 10-4 Ω cm2. The design methodology and low-temperature characteristic of these tunnel junctions is discussed, and insertion into a PN junction device is described. Applications of tunnel junctions in III-nitride optoelectronics devices are explained using energy band diagrams. The lower band gap and polarization fields reduce tunneling barrier, eliminating the need for ohmic contacts to p-type GaN. This demonstration of efficient tunnel injection of carriers in III-Nitrides can lead to a replacement of existing resistive p-type contact material in light emitters with tunneling contact layers, requiring very little metal footprint on the surface, resulting in enhanced light extraction from top emitting emitters.

cond-mat.mtrl-sci↗

arXiv2011

Electrical Properties of Atomic Layer Deposited Aluminum Oxide on Gallium Nitride

We report on our investigation of the electrical properties of metal/Al2O3/GaN metal-insulator-semiconductor (MIS) capacitors. We determined the conduction band offset and interface charge density of the alumina/GaN interface by analyzing capacitance-voltage characteristics of atomic layer deposited Al2O3 films on GaN substrates. The conduction band offset at the Al2O3/GaN interface was calculated to be 2.13 eV, in agreement with theoretical predications. A non-zero field of 0.93 MV/cm in the oxide under flat-band conditions in the GaN was inferred, which we attribute to a fixed net positive charge density of magnitude 4.60x1012 cm-2 at the Al2O3/GaN interface. We provide hypotheses to explain the origin of this charge by analyzing the energy band line-up.

cond-mat.mes-hall↗

arXiv2011

Demonstration of Forward Inter-band Tunneling in GaN by Polarization Engineering

We report on the design, fabrication, and characterization of GaN interband tunnel junction showing forward tunneling characteristics. We have achieved very high forward tunneling currents (153 mA/cm2 at 10 mV, and 17.7 A/cm2 peak current) in polarization-engineered GaN/InGaN/GaN heterojunction diodes grown by plasma assisted molecular beam epitaxy. We also report the observation of repeatable negative differential resistance in interband III-Nitride tunnel junctions, with peak-valley current ratio (PVCR) of 4 at room temperature. The forward current density achieved in this work meets the typical current drive requirements of a multi-junction solar cell.

cond-mat.mtrl-sci↗

arXiv2010

Polarization-engineered GaN/InGaN/GaN tunnel diodes

We report on the design and demonstration of polarization-engineered GaN/InGaN/GaN tunnel junction diodes with high current density and low tunneling turn-on voltage. Wentzel-Kramers-Brillouin (WKB) calculations were used to model and design tunnel junctions with narrow bandgap InGaN-based barrier layers. N-polar p-GaN/In0.33Ga0.67N/n-GaN heterostructure tunnel diodes were grown using molecular beam epitaxy. Efficient zero bias tunneling turn-on with a high current density of 118 A/cm2 at a reverse bias of 1V, reaching a maximum current density up to 9.2 kA/cm2 were obtained. These results represent the highest current density reported in III-nitride tunnel junctions, and demonstrate the potential of III-nitride tunnel devices for a broad range of optoelectronic and electronic applications.

cond-mat.mtrl-sci↗