Radio Frequency Interference from Radio Navigation Satellite Systems: simulations and comparison to MeerKAT single-dish data

Abstract

Radio Frequency Interference (RFI) is emitted from various sources, terrestrial or orbital, and create a nuisance for ground-based 21cm experiments. In particular, single-dish 21cm intensity mapping experiments will be highly susceptible to contamination from these sources due to its wide primary beam and sensitivity. This work aims to simulate the contamination effects emitted from orbital sources in the Radio Navigational Satellite System within the 1100-1350 MHz frequency. This simulation can be split into two parts: (I) satellite positioning, emission power, and beam response on the telescope and (II) fitting of the satellite signal to data in order to improve the original model. We use previously observed single dish MeerKAT L-band data which needs to be specially calibrated to include data contaminated by satellite-based RFI. We find that due to non-linearity effects, it becomes non-trivial to fit the satellite power. However, when masking regions where this non-linearity is problematic, we can recreate the satellite contamination with high accuracy around its peak frequencies. The simulation can predict satellite movements and signal for past and future observations, which can help in RFI avoidance and testing novel cleaning methods. The predicted signal from simulations sits below the noise in the target cosmology window for the L-band (970 - 1015 MHz) making it difficult to confirm any out-of-band emission from satellites. However, a power spectrum analysis shows that such signal can still contaminate the 21cm power spectrum at these frequencies. In our simulations, this contamination overwhelms the auto-power spectrum but still allows for a clean detection of the signal in cross-correlations with mild foreground cleaning. Whether such contamination does exist one will require further characterization of the satellite signals far away from their peak frequencies.