arXiv subjects

A. S. Dzurak

Publications and source records attributed to A. S. Dzurak.

At least 73 records · Page 4Linked to original sources

arXiv2009

Electrostically defined few-electron double quantum dot in silicon

A few-electron double quantum dot was fabricated using metal-oxide-semiconductor(MOS)-compatible technology and low-temperature transport measurements were performed to study the energy spectrum of the device. The double dot structure is electrically tunable, enabling the inter-dot coupling to be adjusted over a wide range, as observed in the charge stability diagram. Resonant single-electron tunneling through ground and excited states of the double dot was clearly observed in bias spectroscopy measurements.

cond-mat.mes-hall↗

arXiv2008

Gate-controlled charge transfer in Si:P double quantum dots

We present low temperature charge sensing measurements of nanoscale phosphorus-implanted double-dots in silicon. The implanted phosphorus forms two 50 nm diameter islands with source and drain leads, which are separated from each other by undoped silicon tunnel barriers. Occupancy of the dots is controlled by surface gates and monitored using an aluminium single electron transistor which is capacitively coupled to the dots. We observe a charge stability diagram consistent with the designed many-electron double-dot system and this agrees well with capacitance modelling of the structure. We discuss the significance of these results to the realisation of smaller devices which may be used as charge or spin qubits.

cond-mat.mes-hall↗

arXiv2008

Bias spectroscopy and simultaneous SET charge state detection of Si:P double dots

We report a detailed study of low-temperature (mK) transport properties of a silicon double-dot system fabricated by phosphorous ion implantation. The device under study consists of two phosphorous nanoscale islands doped to above the metal-insulator transition, separated from each other and the source and drain reservoirs by nominally undoped (intrinsic) silicon tunnel barriers. Metallic control gates, together with an Al-AlOx single-electron transistor, were positioned on the substrate surface, capacitively coupled to the buried dots. The individual double-dot charge states were probed using source-drain bias spectroscopy combined with non-invasive SET charge sensing. The system was measured in linear (VSD = 0) and non-linear (VSD <> 0) regimes allowing calculations of the relevant capacitances. Simultaneous detection using both SET sensing and source-drain current measurements was demonstrated, providing a valuable combination for the analysis of the system. Evolution of the triple points with applied bias was observed using both charge and current sensing. Coulomb diamonds, showing the interplay between the Coulomb charging effects of the two dots, were measured using simultaneous detection and compared with numerical simulations.

cond-mat.mes-hall↗

arXiv2006

Ion implanted Si:P double-dot with gate tuneable interdot coupling

We report on millikelvin charge sensing measurements of a silicon double-dot system fabricated by phosphorus ion implantation. An aluminum single-electron transistor (SET) is capacitively coupled to each of the implanted dots enabling the charging behavior of the double-dot system to be studied independently of current transport. Using an electrostatic gate, the interdot coupling can be tuned from weak to strong coupling. In the weak interdot coupling regime, the system exhibits well-defined double-dot charging behavior. By contrast, in the strong interdot coupling regime, the system behaves as a single-dot.

cond-mat.mes-hall↗

arXiv2006

Coulomb blockade in a nanoscale phosphorus-in-silicon island

We study the low temperature electrical transport behaviour of a silicon single electron transistor. The island and leads are defined by patterned phosphorus doped regions achieved by ion implantation through a polymer resist mask. In the device a 50 nm diameter island, containing ~600 donors and having a metallic density of states, is separated from source and drain leads by undoped silicon tunnel barriers. The central island and tunnel barriers are covered by a surface gate in a field effect transistor geometry allowing the coupling between the leads and island to be controlled. Coulomb blockade due to charging of the doped island is measured, the oscillation period is observed to be constant while the charging energy is dependent on the surface gate voltage. We discuss the possibilities of approaching the few electron regime in these structures, with the aim of observing and manipulating discrete quantum mechanical states.

cond-mat.mes-hall↗

arXiv2006

Controlled single electron transfer between Si:P dots

We demonstrate electrical control of Si:P double dots in which the potential is defined by nanoscale phosphorus doped regions. Each dot contains approximately 600 phosphorus atoms and has a diameter close to 30 nm. On application of a differential bias across the dots, electron transfer is observed, using single electron transistors in both dc- and rf-mode as charge detectors. With the possibility to scale the dots down to few and even single atoms these results open the way to a new class of precision-doped quantum dots in silicon.

cond-mat.mes-hall↗

arXiv2005

An ion-implanted silicon single-electron transistor

We report on the fabrication and electrical characterization at millikelvin temperatures of a novel silicon single-electron transistor (Si-SET). The island and source-drain leads of the Si-SET are formed by the implantation of phosphorus ions to a density above the metal-insulator-transition, with the tunnel junctions created by undoped regions. Surface gates above each of the tunnel junctions independently control the tunnel coupling between the Si-SET island and leads. The device shows periodic Coulomb blockade with a charging energy e$^2$/2C$_Σ$ $\sim$ 250 $μ$eV, and demonstrates a reproducible and controllable pathway to a silicon-based SET using CMOS processing techniques.

cond-mat.mes-hall↗

arXiv2004

Single-Shot Readout with the Radio Frequency Single Electron Transistor in the Presence of Charge Noise

The radio frequency single electron transistor (rf-SET) possesses key requirements necessary for reading out a solid state quantum computer. This work explores the use of the rf-SET as a single-shot readout device in the presence of 1/f and telegraph charge noise. For a typical spectrum of 1/f noise we find that high fidelity, single-shot measurements are possible for signals q > 0.01e. For the case of telegraph noise, we present a cross-correlation measurement technique that uses two rf-SETs to suppress the effect of random switching events on readout. We demonstrate this technique by monitoring the charge state of a metal double dot system on microsecond time-scales. Such a scheme will be advantageous in achieving high readout fidelity in a solid state quantum computer.

cond-mat.mes-hall↗

arXiv2004

Observing sub-microsecond telegraph noise with the radio frequency single electron transistor

Telegraph noise, which originates from the switching of charge between meta-stable trapping sites, becomes increasingly important as device sizes approach the nano-scale. For charge-based quantum computing, this noise may lead to decoherence and loss of read out fidelity. Here we use a radio frequency single electron transistor (rf-SET) to probe the telegraph noise present in a typical semiconductor-based quantum computer architecture. We frequently observe micro-second telegraph noise, which is a strong function of the local electrostatic potential defined by surface gate biases. We present a method for studying telegraph noise using the rf-SET and show results for a charge trap in which the capture and emission of a single electron is controlled by the bias applied to a surface gate.

cond-mat.mes-hall↗

arXiv2004

Modeling Single Electron Transfer in Si:P Double Quantum Dots

Solid-state systems such as P donors in Si have considerable potential for realization of scalable quantum computation. Recent experimental work in this area has focused on implanted Si:P double quantum dots (DQDs) that represent a preliminary step towards the realization of single donor charge-based qubits. This paper focuses on the techniques involved in analyzing the charge transfer within such DQD devices and understanding the impact of fabrication parameters on this process. We show that misalignment between the buried dots and surface gates affects the charge transfer behavior and identify some of the challenges posed by reducing the size of the metallic dot to the few donor regime.

quant-ph↗

arXiv2004

Development and operation of the twin radio frequency single electron transistor for solid state qubit readout

Ultra-sensitive detectors and readout devices based on the radio frequency single electron transistor (rf-SET) combine near quantum-limited sensitivity with fast operation. Here we describe a twin rf-SET detector that uses two superconducting rf-SETs to perform fast, real-time cross-correlated measurements in order to distinguish sub-electron signals from charge noise on microsecond time-scales. The twin rf-SET makes use of two tuned resonance circuits to simultaneously and independently address both rf-SETs using wavelength division multiplexing (WDM) and a single cryogenic amplifier. We focus on the operation of the twin rf-SET as a charge detector and evaluate the cross-talk between the two resonance circuits. Real time suppression of charge noise is demonstrated by cross correlating the signals from the two rf-SETs. For the case of simultaneous operation, the rf-SETs had charge sensitivities of $δq_{SET1} = 7.5 μe/\sqrt{Hz}$ and $δq_{SET2} = 4.4 μe/\sqrt{Hz}$.

cond-mat.mes-hall↗

arXiv2003

Charge-based quantum computing using single donors in semiconductors

Solid-state quantum computer architectures with qubits encoded using single atoms are now feasible given recent advances in atomic doping of semiconductors. Here we present a charge qubit consisting of two dopant atoms in a semiconductor crystal, one of which is singly ionised. Surface electrodes control the qubit and a radio-frequency single electron transistor provides fast readout. The calculated single gate times, of order 50ps or less, are much shorter than the expected decoherence time. We propose universal one- and two-qubit gate operations for this system and discuss prospects for fabrication and scale up.

cond-mat↗

arXiv2003

Charge-based silicon quantum computer architectures using controlled single-ion implantation

We report a nanofabrication, control and measurement scheme for charge-based silicon quantum computing which utilises a new technique of controlled single ion implantation. Each qubit consists of two phosphorus dopant atoms ~50 nm apart, one of which is singly ionized. The lowest two energy states of the remaining electron form the logical states. Surface electrodes control the qubit using voltage pulses and dual single electron transistors operating near the quantum limit provide fast readout with spurious signal rejection. A low energy (keV) ion beam is used to implant the phosphorus atoms in high-purity Si. Single atom control during the implantation is achieved by monitoring on-chip detector electrodes, integrated within the device structure, while positional accuracy is provided by a nanomachined resist mask. We describe a construction process for implanted single atom and atom cluster devices with all components registered to better than 20 nm, together with electrical characterisation of the readout circuitry. We also discuss universal one- and two-qubit gate operations for this architecture, providing a possible path towards quantum computing in silicon.

cond-mat↗

arXiv2002

Self-aligned fabrication process for silicon quantum computer devices

We describe a fabrication process for devices with few quantum bits (qubits), which are suitable for proof-of-principle demonstrations of silicon-based quantum computation. The devices follow the Kane proposal to use the nuclear spins of 31P donors in 28Si as qubits, controlled by metal surface gates and measured using single electron transistors (SETs). The accurate registration of 31P donors to control gates and read-out SETs is achieved through the use of a self-aligned process which incorporates electron beam patterning, ion implantation and triple-angle shadow-mask metal evaporation.

cond-mat↗

arXiv2002

Correlated charge detection for read-out of a solid state quantum computer

The single electron transistor (SET) is a prime candidate for reading out the final state of a qubit in a solid state quantum computer. Such a measurement requires the detection of sub-electron charge motion in the presence of random charging events. We present a detection scheme where the signals from two SETs are cross-correlated to suppress unwanted artifacts due to charge noise. This technique is demonstrated by using the two SETs to detect the charge state of two tunnel junction - coupled metal dots, thereby simulating charge transfer and readout in a two qubit system. These measurements indicate that for comparable buried dopant semiconductor architectures the minimum measurement time required to distinguish between the two charge states is of the order of 10 ns.

cond-mat.mes-hall↗

arXiv2002

Density dependent spin polarisation in ultra low-disorder quantum wires

There is controversy as to whether a one-dimensional (1D) electron gas can spin polarise in the absence of a magnetic field. Together with a simple model, we present conductance measurements on ultra low-disorder quantum wires supportive of a spin polarisation at B=0. A spin energy gap is indicated by the presence of a feature in the range 0.5 - 0.7 X 2e^2/h in conductance data. Importantly, it appears that the spin gap is not static but a function of the electron density. Data obtained using a bias spectroscopy technique are consistent with the spin gap widening further as the Fermi-level is increased.

cond-mat.str-el↗

arXiv2001

Towards the fabrication of phosphorus qubits for a silicon quantum computer

The quest to build a quantum computer has been inspired by the recognition of the formidable computational power such a device could offer. In particular silicon-based proposals, using the nuclear or electron spin of dopants as qubits, are attractive due to the long spin relaxation times involved, their scalability, and the ease of integration with existing silicon technology. Fabrication of such devices however requires atomic scale manipulation - an immense technological challenge. We demonstrate that it is possible to fabricate an atomically-precise linear array of single phosphorus bearing molecules on a silicon surface with the required dimensions for the fabrication of a silicon-based quantum computer. We also discuss strategies for the encapsulation of these phosphorus atoms by subsequent silicon crystal growth.

cond-mat↗

arXiv2000

Many-body spin related phenomena in ultra-low-disorder quantum wires

Zero length quantum wires (or point contacts) exhibit unexplained conductance structure close to 0.7 X 2e^2/h in the absence of an applied magnetic field. We have studied the density- and temperature-dependent conductance of ultra-low-disorder GaAs/AlGaAs quantum wires with nominal lengths l=0 and 2 mu m, fabricated from structures free of the disorder associated with modulation doping. In a direct comparison we observe structure near 0.7 X 2e^2/h for l=0 whereas the l=2 mu m wires show structure evolving with increasing electron density to 0.5 X 2e^2/h in zero magnetic field, the value expected for an ideal spin-split sub-band. Our results suggest the dominant mechanism through which electrons interact can be strongly affected by the length of the 1D region.

cond-mat.str-el↗