Searcharxiv⌕ Search

arXiv subjects

K. S. Novoselov

Publications and source records attributed to K. S. Novoselov.

At least 145 records · Page 8Linked to original sources

Gap opening in the zeroth Landau level of graphene

We have measured a strong increase of the low-temperature resistivity $ρ_{xx}$ and a zero-value plateau in the Hall conductivity $σ_{xy}$ at the charge neutrality point in graphene subjected to high magnetic fields up to 30 T. We explain our results by a simple model involving a field dependent splitting of the lowest Landau level of the order of a few Kelvin, as extracted from activated transport measurements. The model reproduces both the increase in $ρ_{xx}$ and the anomalous $ν=0$ plateau in $σ_{xy}$ in terms of coexisting electrons and holes in the same spin-split zero-energy Landau level.

cond-mat.mes-hall↗

Uniaxial Strain in Graphene by Raman Spectroscopy: G peak splitting, Gruneisen Parameters and Sample Orientation

Graphene is the two-dimensional building block for carbon allotropes of every other dimensionality. Since its experimental discovery, graphene continues to attract enormous interest, in particular as a new kind of matter, in which electron transport is governed by a Dirac-like wave equation, and as a model system for studying electronic and phonon properties of other, more complex, graphitic materials[1-4]. Here, we uncover the constitutive relation of graphene and probe new physics of its optical phonons, by studying its Raman spectrum as a function of uniaxial strain. We find that the doubly degenerate E2g optical mode splits in two components, one polarized along the strain and the other perpendicular to it. This leads to the splitting of the G peak into two bands, which we call G+ and G-, by analogy with the effect of curvature on the nanotube G peak[5-7]. Both peaks red shift with increasing strain, and their splitting increases, in excellent agreement with first-principles calculations. Their relative intensities are found to depend on light polarization, which provides a useful tool to probe the graphene crystallographic orientation with respect to the strain. The singly degenerate 2D and 2D' bands also red shift, but do not split for small strains. We study the Gruneisen parameters for the phonons responsible for the G, D and D' peaks. These can be used to measure the amount of uniaxial or biaxial strain, providing a fundamental tool for nanoelectronics, where strain monitoring is of paramount importance[8, 9]

cond-mat.mtrl-sci↗

Infrared spectroscopy of electronic bands in bilayer graphene

We present infrared spectra (0.1-1 eV) of electrostatically gated bilayer graphene as a function of doping and compare it with tight binding calculations. All major spectral features corresponding to the expected interband transitions are identified in the spectra: a strong peak due to transitions between parallel split-off bands and two onset-like features due to transitions between valence and conduction bands. A strong gate voltage dependence of these structures and a significant electron-hole asymmetry is observed that we use to extract several band parameters. Surprisingly, the structures related to the gate-induced bandgap are much less pronounced in the experiment than predicted by the tight binding model.

cond-mat.str-el↗

Raman Spectroscopy of Graphene Edges

Graphene edges are of particular interest, since their chirality determines the electronic properties. Here we present a detailed Raman investigation of graphene flakes with well defined edges oriented at different crystallographic directions. The position, width and intensity of G and D peaks at the edges are studied as a function of the incident light polarization. The D-band is strongest for light polarized parallel to the edge and minimum for perpendicular orientation. Raman mapping shows that the D peak is localized in proximity of the edge. The D to G ratio does not always show a significant dependence on edge orientation. Thus, even though edges can appear macroscopically smooth and oriented at well defined angles, they are not necessarily microscopically ordered.

cond-mat.mtrl-sci↗

Control of graphene's properties by reversible hydrogenation

Graphene - a monolayer of carbon atoms densely packed into a hexagonal lattice - has one of the strongest possible atomic bonds and can be viewed as a robust atomic-scale scaffold, to which other chemical species can be attached without destroying it. This notion of graphene as a giant flat molecule that can be altered chemically is supported by the observation of so-called graphene oxide, that is graphene densely covered with hydroxyl and other groups. Unfortunately, graphene oxide is strongly disordered, poorly conductive and difficult to reduce to the original state. Nevertheless, one can imagine atoms or molecules being attached to the atomic scaffold in a strictly periodic manner, which should result in a different electronic structure and, essentially, a different crystalline material. A hypothetical example for this is graphane, a wide-gap semiconductor, in which hydrogen is bonded to each carbon site of graphene. Here we show that by exposing graphene to atomic hydrogen, it is possible to transform this highly-conductive semimetal into an insulator. Transmission electron microscopy reveals that the material retains the hexagonal lattice but its period becomes markedly shorter than that of graphene, providing direct evidence for a new graphene-based derivative. The reaction with hydrogen is found to be reversible so that the original metallic state and lattice spacing are restored by annealing and even the quantum Hall effect recovers. Our work proves the concept of chemical modification of graphene, which promises a whole range of new two-dimensional crystals with designed electronic and other properties.

cond-mat.mes-hall↗

Quantum resistance metrology in graphene

We have performed a metrological characterization of the quantum Hall resistance in a 1 $μ$m wide graphene Hall-bar. The longitudinal resistivity in the center of the $ν=\pm 2$ quantum Hall plateaus vanishes within the measurement noise of 20 m$Ω$ upto 2 $μ$A. Our results show that the quantization of these plateaus is within the experimental uncertainty (15 ppm for 1.5$ μ$A current) equal to that in conventional semiconductors. The principal limitation of the present experiments are the relatively high contact resistances in the quantum Hall regime, leading to a significantly increased noise across the voltage contacts and a heating of the sample when a high current is applied.

cond-mat.mes-hall↗

Macroscopic graphene membranes and their extraordinary stiffness

The properties of suspended graphene are currently attracting enormous interest, but the small size of available samples and the difficulties in making them severely restrict the number of experimental techniques that can be used to study the optical, mechanical, electronic, thermal and other characteristics of this one-atom-thick material. Here we describe a new and highly-reliable approach for making graphene membranes of a macroscopic size (currently up to 100 microns in diameter) and their characterization by transmission electron microscopy. In particular, we have found that long graphene beams supported by one side only do not scroll or fold, in striking contrast to the current perception of graphene as a supple thin fabric, but demonstrate sufficient stiffness to support extremely large loads, millions of times exceeding their own weight, in agreement with the presented theory. Our work opens many avenues for studying suspended graphene and using it in various micromechanical systems and electron microscopy.

cond-mat.mes-hall↗

Nanolithography and manipulation of graphene using an atomic force microscope

We use an atomic force microscope (AFM) to manipulate graphene films on a nanoscopic length scale. By means of local anodic oxidation with an AFM we are able to structure isolating trenches into single-layer and few-layer graphene flakes, opening the possibility of tabletop graphene based device fabrication. Trench sizes of less than 30 nm in width are attainable with this technique. Besides oxidation we also show the influence of mechanical peeling and scratching with an AFM of few layer graphene sheets placed on different substrates.

cond-mat.mes-hall↗

Universal Dynamic Conductivity and Quantized Visible Opacity of Suspended Graphene

We show that the optical transparency of suspended graphene is defined by the fine structure constant, alpha, the parameter that describes coupling between light and relativistic electrons and is traditionally associated with quantum electrodynamics rather than condensed matter physics. Despite being only one atom thick, graphene is found to absorb a significant (pi times alpha=2.3%) fraction of incident white light, which is a consequence of graphene's unique electronic structure. This value translates into universal dynamic conductivity G =e^2/4h_bar within a few percent accuracy.

cond-mat.mes-hall↗

Graphene-Based Liquid Crystal Device

Graphene is only one atom thick, optically transparent, chemically inert and an excellent conductor. These properties seem to make this material an excellent candidate for applications in various photonic devices that require conducting but transparent thin films. In this letter we demonstrate liquid crystal devices with electrodes made of graphene which show excellent performance with a high contrast ratio. We also discuss the advantages of graphene compared to conventionally-used metal oxides in terms of low resistivity, high transparency and chemical stability.

cond-mat.mes-hall↗

The electronic properties of graphene

This article reviews the basic theoretical aspects of graphene, a one atom thick allotrope of carbon, with unusual two-dimensional Dirac-like electronic excitations. The Dirac electrons can be controlled by application of external electric and magnetic fields, or by altering sample geometry and/or topology. We show that the Dirac electrons behave in unusual ways in tunneling, confinement, and integer quantum Hall effect. We discuss the electronic properties of graphene stacks and show that they vary with stacking order and number of layers. Edge (surface) states in graphene are strongly dependent on the edge termination (zigzag or armchair) and affect the physical properties of nanoribbons. We also discuss how different types of disorder modify the Dirac equation leading to unusual spectroscopic and transport properties. The effects of electron-electron and electron-phonon interactions in single layer and multilayer graphene are also presented.

cond-mat.other↗

Giant Intrinsic Carrier Mobilities in Graphene and Its Bilayer

We have studied temperature dependences of electron transport in graphene and its bilayer and found extremely low electron-phonon scattering rates that set the fundamental limit on possible charge carrier mobilities at room temperature. Our measurements have shown that mobilities significantly higher than 200,000 cm2/Vs are achievable, if extrinsic disorder is eliminated. A sharp (threshold-like) increase in resistivity observed above approximately 200K is unexpected but can qualitatively be understood within a model of a rippled graphene sheet in which scattering occurs on intra-ripple flexural phonons.

cond-mat.mes-hall↗

Chaotic Dirac billiard in graphene quantum dots

We report on transport characteristics of quantum dot devices etched entirely in graphene. At large sizes, they behave as conventional single-electron transistors, exhibiting periodic Coulomb blockade peaks. For quantum dots smaller than 100 nm, the peaks become strongly non-periodic indicating a major contribution of quantum confinement. Random peak spacing and its statistics are well described by the theory of chaotic neutrino (Dirac) billiards. Short constrictions of only a few nm in width remain conductive and reveal a confinement gap of up to 0.5eV, which demonstrates the in-principle possibility of molecular-scale electronics based on graphene.

cond-mat.mes-hall↗

Biased bilayer graphene: semiconductor with a gap tunable by electric field effect

We demonstrate that the electronic gap of a graphene bilayer can be controlled externally by applying a gate bias. From the magneto-transport data (Shubnikov-de Haas measurements of the cyclotron mass), and using a tight binding model, we extract the value of the gap as a function of the electronic density. We show that the gap can be changed from zero to mid-infrared energies to a value as large as 0.3 eV by using fields of < 1 V/nm, below the electric breakdown of SiO2. The opening of a gap is clearly seen in the quantum Hall regime.

cond-mat.mtrl-sci↗

Making graphene visible

Microfabrication of graphene devices used in many experimental studies currently relies on the fact that graphene crystallites can be visualized using optical microscopy if prepared on top of silicon wafers with a certain thickness of silicon dioxide. We study graphene's visibility and show that it depends strongly on both thickness of silicon dioxide and light wavelength. We have found that by using monochromatic illumination, graphene can be isolated for any silicon dioxide thickness, albeit 300 nm (the current standard) and, especially, approx. 100 nm are most suitable for its visual detection. By using a Fresnel-law-based model, we quantitatively describe the experimental data without any fitting parameters.

cond-mat.mes-hall↗

Raman Fingerprint of Charged Impurities in Graphene

We report strong variations in the Raman spectra for different single-layer graphene samples obtained by micromechanical cleavage, which reveals the presence of excess charges, even in the absence of intentional doping. Doping concentrations up to ~10^13 cm-2 are estimated from the G peak shift and width, and the variation of both position and relative intensity of the second order 2D peak. Asymmetric G peaks indicate charge inhomogeneity on the scale of less than 1 micron.

cond-mat.mtrl-sci↗

Detection of Individual Gas Molecules Absorbed on Graphene

The ultimate aspiration of any detection method is to achieve such a level of sensitivity that individual quanta of a measured value can be resolved. In the case of chemical sensors, the quantum is one atom or molecule. Such resolution has so far been beyond the reach of any detection technique, including solid-state gas sensors hailed for their exceptional sensitivity. The fundamental reason limiting the resolution of such sensors is fluctuations due to thermal motion of charges and defects which lead to intrinsic noise exceeding the sought-after signal from individual molecules, usually by many orders of magnitude. Here we show that micrometre-size sensors made from graphene are capable of detecting individual events when a gas molecule attaches to or detaches from graphenes surface. The adsorbed molecules change the local carrier concentration in graphene one by one electron, which leads to step-like changes in resistance. The achieved sensitivity is due to the fact that graphene is an exceptionally low-noise material electronically, which makes it a promising candidate not only for chemical detectors but also for other applications where local probes sensitive to external charge, magnetic field or mechanical strain are required.

cond-mat.mtrl-sci↗

Cyclotron Resonance study of the electron and hole velocity in graphene monolayers

We report studies of cyclotron resonance in monolayer graphene. Cyclotron resonance is detected using the photoconductive response of the sample for several different Landau level occupancies. The experiments measure an electron velocity at the K- (Dirac) point of $c_{K}^{*}$ = 1.093 x 10$^{6}$ ms$^{-1}$ and in addition detect a significant asymmetry between the electron and hole bands, leading to a difference in the electron and hole velocities of 5% by energies of 125 meV away from the Dirac point.

cond-mat.mes-hall↗