SearcharxivSearch

arXiv · 2206.10507

SuperFGD prototype time resolution studies

Abstract

The SuperFGD will be a part of the ND280 near detector of the T2K and Hyper Kamiokande projects, that will help to reduce systematic uncertainties related with neutrino flux and cross-section modeling. The upgraded ND280 will be able to perform a full exclusive reconstruction of the final state from neutrino-nucleus interactions, including measurements of low momentum protons, pions and, for the first time, event-by event measurements of neutron kinematics. The time resolution defines the neutron energy resolution. We present the results of time resolution measurements made with the SuperFGD prototype that consists of 9216 plastic scintillator cubes (cube size is 1 cm$^3$) readout with 1728 wavelength-shifting fibers going along three orthogonal directions. We use data from the muon beam exposure at CERN. The time resolution of 0.97 ns was obtained for one readout channel after implementing the time calibration with a correction for the time-walk effect. The time resolution improves with energy deposited in a scintillator cube. Averaging two readout channels for one scintillator cube improves the time resolution to 0.68 ns which means that signals in different channels are not synchronous. Therefore the contribution from the time recording step of 2.5 ns is averaged as well. Averaging time values from N channels improves the time resolution by $\sim 1/\sqrt{N}$. Therefore a very good time resolution should be achievable for neutrons since neutron recoils hit typically several scintillator cubes and in addition produce larger amplitudes than muons. Measurements performed with a laser and a wide-bandwidth oscilloscope demonstrated that the time resolution obtained with the muon beam is not far from its expected limit. The intrinsic time resolution of one channel is 0.67 ns for signals of 56 photo-electron typical for minimum ionizing particles.

Explore related subjects

Keep this discovery

BibTeXRIS

I. Alekseev, T. Arihara, V. Baranov, L. Bartoszek, L. Bernardi, A. Blondel, A. V. Boikov, M. Buizza-Avanzini, F. Cadoux, J. Capó, J. Cayo, J. Chakrani, P. S. Chong, A. Chvirova, M. Danilov, Yu. I. Davydov, A. Dergacheva, N. Dokania, D. Douqa, O. Drapier, A. Eguchi, Y. Favre, D. Fedorova, S. Fedotov, Y. Fujii, F. Gastaldi, A. Gendotti, V. Glagolev, R. Guillaumat, K. Iwamoto, M. Jakkapu, C. Jesús-Valls, C. K. Jung, H. Kakuno, S. P. Kasetti, M. Khabibullin, A. Khotjantsev, H. Kikutani, T. Kobayashi, S. Kodama, A. Korzenev, U. Kose, Y. Kudenko, T. Kutter, D. Last, B. Li, Z. Li, L. S. Lin, S. Lin, M. Louzir, T. Lux, L. Maret, S. Martynenko, T. Matsubara, C. Mauger, C. McGrew, A. Mefodiev, O. Mineev, T. Nakadaira, K. Nakagiri, J. Nanni, L. Nicola, E. Noah, V. Paolone, S. Parsa, R. Pellegrino, M. A. Ramirez, M. Reh, C. Ricco, A. Rubbia, K. Sakashita, F. Sanchez, D. Sgalaberna, A. Shvartsman, N. Skrobova, I. A. Suslov, S. Suvorov, D. Svirida, A. Teklu, V. V. Tereshchenko, M. Tzanov, I. I. Vasilyev, K. Wood, G. Yang, N. Yershov, M. Yokoyama, Y. Yoshimoto, X. Zhao, P. Zilberman, E. D. Zimmerman. 2022-06-21. SuperFGD prototype time resolution studies. https://doi.org/10.1088/1748-0221%2F18%2F01%2Fp01012

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related papers

High-Speed Semi-FE Readout Module for ATLAS MDT at HL-LHC: Design and Production-Level Characterization

The High-Luminosity upgrade of the Large Hadron Collider (HL-LHC) introduces increased demands on the ATLAS Muon Spectrometer, particularly in terms of data throughput, timing distribution and system reliability. The Phase-II Chamber Service Module (CSM) is a key component of the upgraded Monitored Drift Tube (MDT) trigger and readout system, providing a high-speed interface between the front-end electronics and the backend systems. This paper describes the design and implementation of the Phase-II CSM, together with its validation. The results show that the CSM supports two independent optical uplinks, each operating at a line rate of 10.24 Gbps, together with clock distribution and slow control in the expected operating environment. Integration with small-diameter MDT (sMDT) chambers and tests with the prototype L0MDT trigger system are also presented. The CSM boards are now in production and will be used for installation and integration during the upcoming LHC Long Shutdown.

physics.ins-det

Spectral Discrimination of Deposited Gamma-Ray Energies in a Simulated CeBr$_3$ Scintillator

We show that wavelength measurements of individual detected optical photons may provide additional information about gamma-ray energy deposited in a CeBr$_3$ crystal when the detected-photon-count distributions overlap for nearby gamma-ray energies. Monoenergetic 662 and 629 keV gammas are used in a Geant4 simulation of a $25\times25\times20~\mathrm{mm^3}$ CeBr$_3$ crystal. Assuming a light yield of $6.0\times10^4$ photons/MeV, a wavelength-independent photon-detection efficiency of 30%, and a wavelength resolution of $\sigma_{\lambda}=40$ nm, we find that the fraction of photons reconstructed above 385 nm gives an event-level separation of $\sim$ 2 standard deviations between the 662 and 629 keV event populations selected within the same $\sim$ 1%-wide detected-photon-count interval. No timing or reconstructed interaction-position information is used. The result demonstrates, within the present simulation model, that event-dependent optical spectra can retain energy information beyond an undifferentiated photon count.

physics.ins-det

Operation of a negative ion gas time projection chamber without electronegative fill gases

The high fidelity reconstruction of particle tracks in micropatterned gaseous time projection chambers renders this technology ideal for future rare-event searches, including direction-sensitive dark matter experiments. Large drift distances are typically required for such experiments, so that the overall spatial resolution is limited by diffusion. Negative ion drift exhibits lower diffusion than electron drift and is thus an attractive option for realising a large-scale detector. The use of electronegative gases to create negative ions introduces technical challenges, most notably a reduction in gain when compared to conventional gas mixtures. In this study, we demonstrate a new method for negative ion generation via dissociative electron attachment using the conventional molecular fill gas CF$_4$. Our optical measurements of negative ion drift indicate electron attachment lengths of $<$1 mm and comparable gain to electron avalanches. The individual negative ion avalanches were also time-resolved, allowing the number of ions reaching the readout to be counted. We measure an improved energy resolution by single ion counting, relative to an integrated electron avalanche signal measured under identical gain conditions.

physics.ins-det